- 您现在的位置：买卖IC网 > PDF目录96681 > PKF4610API (ERICSSON POWER MODULES AB) 1-OUTPUT 6.6 W DC-DC REG PWR SUPPLY MODULE PDF资料下载
参数资料
| 型号： | PKF4610API |
| 厂商： | ERICSSON POWER MODULES AB |
| 元件分类： | 电源模块 |
| 英文描述： | 1-OUTPUT 6.6 W DC-DC REG PWR SUPPLY MODULE |
| 封装： | 8 MM HEIGHT, POWER, MODULE-18 |
| 文件页数： | 7/8页 |
| 文件大小： | 466K |
| 代理商： | PKF4610API |
7
EN/LZT 146 85 R1A Ericsson Microelectronics AB, December 2001
Output Voltage Adjust (Vadj)
Output voltage, VO, can be adjusted by using an external resistor or
other external circuitry. If other circuitry is used, the slew rate has
to be limited to maximum 5 V/ms. If pins 8 and 9 are not connect-
ed together the output will decrease to a low value. To increase VO a
resistor should be connected between pin 8/9 and 17, and to de-
crease VO a resistor should be connected between pin 8 and 9
Typical required resistor value to increase VO is given by:
Radj =4.20 × (4.13 – VO)/(VO – VOi) k
W
where VO is the desired output voltage,
VOi is the typical output voltage initial setting
Typical required resistor value to decrease VO is given by:
Radj = 17.20 × (VOi – VO)/(VO – 1.73 ) k
W
The following typical resistor values can be used to adjust the
output voltage to 1.8 V or 2.5 V. For more information on
temperature dependence see fig. 4.
Current Limiting Protection (Ilim)
The output power is limited at loads above the output current
limiting threshold (Ilim), specified as a minimum value.
Input and Output Impedance
Both the source impedance of the power feeding and the load im-
pedance will interact with the impedance of the DC/DC power
module.
It is most important to have the ratio between L and C as low as
possible, i.e. a low characteristic impedance, both at the input and
output, as the power modules have a low energy storage capability.
Use an electrolytic capacitor across the input if the source
inductance is higher than 10
mH. Their equivalent series resistance
together with the capacitance acts as a lossless damping filter.
Suitable capacitor values are in the range 10–100
mF.
Capacitive Load
The PKF series has no maximum limit for capacitive load on the
output. The power module may operate in current limiting mode
during start-up, affecting the ramp-up and the start-up time. For
optimum start performance we recommend maximum 100
mF/A of
IO. Connect capacitors at the point of load for best performance.
Synchronization (Sync)
It is possible to synchronize the switching frequency to an external
symmetrical clock signal. The input can be driven by an TTL-
compatible output and referenced to the input pin 17.
Figure 2
Characteristics
min
typ
max
unit
High level
2.2
6.5
V
Threshold level*)
1.2
1.7
2.2
V
Low level
0
0.4
V
Sink current
1.5
mA
Sync. frequency
520
688
kHz
*)
Rise time <10ns
Parallel Operation
Paralleling of several converters is easily accomplished by direct
connection of the output voltage terminal pins. The load regulation
characteristic is specifically designed for optimum paralleling per-
formance. Load sharing between converters will be within ±10%.
It is recommended not to exceed PO = n × 0.9 × POmax, where POmax
is the maximum converter output power and n the number of
paralleled converters, to prevent overloading any of the converters
and thereby decreasing the reliability performance.
Information given in this data sheet is believed to be accurate and reliable.
No responsibility is assumed for the consequences of its use nor for any infringement
of patents or other rights of third parties which may result from its use.
No license is granted by implication or otherwise under any patent or patent rights of
Ericsson Microelectronics. These products are sold only according to
Ericsson Microelectronics’ general conditions of sale, unless otherwise confirmed in
writing. Specifications subject to change without notice.
Output voltage
tolerance band
Rodnom (
W)
Standard values E24 (
W)
2.5 V ± 4%
17.8 k
20 k//160 k 1% 200 ppm
1.8 V ± 4%
360 k
1% 200 ppm
Information Ordering
Surface mount
PKF 4610A SI
Through hole
PKF 4610A PI *
Version
Part No.
* Optional PINS version without synchronization input.
Figure 3
相关PDF资料 |
PDF描述 |
|---|---|
| PKF4910APINS | 1-OUTPUT 9.9 W DC-DC REG PWR SUPPLY MODULE |
| PKF4910API | 1-OUTPUT 9.9 W DC-DC REG PWR SUPPLY MODULE |
| PKF4918BI | 1-OUTPUT 9 W DC-DC REG PWR SUPPLY MODULE |
| PKF5113SI | 1-OUTPUT 11 W DC-DC REG PWR SUPPLY MODULE |
| PKF5713API | 1-OUTPUT 7.8 W DC-DC REG PWR SUPPLY MODULE |
相关代理商/技术参数 |
参数描述 |
|---|---|
| PKF4611 | 制造商:ERICSSON 制造商全称:Ericsson 功能描述:3?7 W DC/DC Power Modules 48 V Input Series |
| PKF4611PI | 制造商:ERICSSON 功能描述: 制造商:Ericsson 功能描述:1-OUTPUT 6 W DC-DC REG PWR SUPPLY MODULE |
| PKF4611SI | 制造商:ERICSSON 功能描述:CONVERTER 制造商:Ericsson 功能描述:1-OUTPUT 6 W DC-DC REG PWR SUPPLY MODULE |
| PKF4621 | 制造商:ERICSSON 制造商全称:Ericsson 功能描述:3?7 W DC/DC Power Modules 48 V Input Series |
| PKF4621PI | 制造商:ERICSSON 制造商全称:Ericsson 功能描述:3?7 W DC/DC Power Modules 48 V Input Series |
发布紧急采购，3分钟左右您将得到回复。