- 您现在的位置：买卖IC网 > PDF目录98053 > PKJ4316IP (ERICSSON POWER MODULES AB) 1-OUTPUT 310.2 W DC-DC REG PWR SUPPLY MODULE PDF资料下载
参数资料
| 型号： | PKJ4316IP |
| 厂商： | ERICSSON POWER MODULES AB |
| 元件分类： | 电源模块 |
| 英文描述： | 1-OUTPUT 310.2 W DC-DC REG PWR SUPPLY MODULE |
| 封装： | ROHS COMPLIANT, PACKAGE-9 |
| 文件页数： | 8/20页 |
| 文件大小： | 596K |
| 代理商： | PKJ4316IP |
Ericsson Internal
PRODUCT SPECIFICATION
3 (5)
Prepared (also subject responsible if other)
No.
EQUENXU
3/1301-BMR 630 03/7 Uen
Approved
Checked
Date
Rev
Reference
SEC/D (Julia You)
EZYPING
2006-12-19
B
Operating information continued
Parallel Operation
Two converters may be paralleled for redundancy if the total
power is equal or less than PO max. It is not recommended to
parallel the converters without using external current sharing
circuits.
See Design Note 006 for detailed information.
Remote Sense
The DC/DC converters have remote sense that can be used
to compensate for voltage drops between the output and the
point of load. The sense traces should be located close to the
PCB ground layer to reduce noise susceptibility. The remote
sense circuitry will compensate for up to 10% voltage drop
between output pins and the point of load.
If the remote sense is not needed +Sense should be
connected to +Out and -Sense should be connected to -Out.
Over Temperature Protection (OTP)
The DC/DC converter are protected from thermal overload by
an internal over temperature shutdown circuit.
When the baseplate temperature (center of baseplate)
exceeds 140 C the converter will shut down (latching). The
converter can be restarted by cycling the input voltage or
using the remote control function.
Over Voltage Protection (OVP)
The DC/DC converters have latching output
overvoltage protection. In the event of an overvoltage
condition,the converter will shut down immediately. The
converter can be restarted by cycling the input voltage or
using the remote control function.
Over Current Protection (OCP)
The converters include current limiting circuitry for protection
at continuous overload.
The output voltage will decrease towards zero for output
currents in excess of max output current (max IO). The
converter will resume normal operation after removal of the
overload. The load distribution should be designed for the
maximum output short circuit current specified.
Thermal Consideration
General
The converters are designed to operate in different thermal
environments and sufficient cooling must be provided to
ensure reliable operation.
Cooling is achieved mainly by conduction, from the pins to
the host board, and convection, which is dependant on the
airflow across the converter. Increased airflow enhances the
cooling of the converter.
The Output Current Derating graph found in the Output
section for each model provides the available output current
vs. ambient air temperature and air velocity at Vin = 53 V.
The DC/DC converter is tested on a 254 x 254 mm,
35 μm (1 oz), 16-layer test board mounted vertically in a wind
tunnel with a cross-section of 305 x 305 mm.
Proper cooling of the DC/DC converter can be verified by
measuring the temperature at positions P1 and P2. The
temperature at these positions should not exceed the max
values provided in the table below.
Note that the max value is the absolute maximum rating
(non destruction) and that the electrical Output data is
guaranteed up to Tref +90°C.
See Design Note 019 for further information.
Position
Device
Designation
max value
P1
PCB
110 C
P2
Baseplate
Tref
120 C
E
PKJ 4000 series RFPA products
DC/DC converters, Input 35-75 V, Output 12.4 A/350 W
EN/LZT 146 367 R1A Febuary 2007
Ericsson Power Modules AB
Technical Specication
16
相关PDF资料 |
PDF描述 |
|---|---|
| PKJ4216NIP | 1-OUTPUT 250.66 W DC-DC REG PWR SUPPLY MODULE |
| PKJ4711EPIP | 1-OUTPUT 100 W DC-DC REG PWR SUPPLY MODULE |
| PKJ4711EPILA | 1-OUTPUT 100 W DC-DC REG PWR SUPPLY MODULE |
| PKJ4810EIP | 1-OUTPUT 82.5 W DC-DC REG PWR SUPPLY MODULE |
| PKJ4111EIP | 1-OUTPUT 100 W DC-DC REG PWR SUPPLY MODULE |
相关代理商/技术参数 |
参数描述 |
|---|---|
| PKJ4316PI | 功能描述:DC/DC转换器 28 Vdc 11A Iso Input 36-75V 310W RoHS:否 制造商:Murata 产品: 输出功率: 输入电压范围:3.6 V to 5.5 V 输入电压（标称）: 输出端数量:1 输出电压（通道 1）:3.3 V 输出电流（通道 1）:600 mA 输出电压（通道 2）: 输出电流（通道 2）: 安装风格:SMD/SMT 封装 / 箱体尺寸: |
| PKJ4316PILA | 制造商:Ericsson 功能描述:DC - DC CONVERTER |
| PKJ4316PIM | 制造商:Ericsson 功能描述:28V, 11A / 310W - Bulk |
| PKJ4318PIT | 制造商:Ericsson 功能描述:DC/DC POWER MODULE |
| PKJ4418LEPI | 制造商:Ericsson 功能描述:DC/DC PS SGL-OUT 1.2V 40A 48W - Bulk |
发布紧急采购，3分钟左右您将得到回复。