Ericsson Internal
PROD. SPECIFICATION MECHANICAL
3 (5)
Prepared (also subject responsible if other)
No.
MICKAOV
5/1301-BMR 6401 Uen
Approved
Checked
Date
Rev
Reference
SEC/D (Julia You)
See §1
2007-10-08
D
Delivery Package Information
The surface mount version of the product is delivered in
antistatic injection molded trays (Jedec design guide 4.10D
standard) or in antistatic carrier tape (EIA 481 standard)
The hole mount version is delivered in antistatic tubes.
Carrier Tape Specifications
Material
Polystyrene (PS), antistatic
Surface resistivity
< 107 Ohm/square
Bakability
The tape is not bakable
Tape width
72 mm [2.835 inch]
Pocket pitch
36 mm [1.417 inch]
Pocket depth
9.2 mm [0.362 inch]
Reel diameter
330 mm [13 inch]
Reel capacity
150 products / reel
Reel weight
Approximately 2.5 kg / full reel
Tape feed direction
Round holes
Elongated holes
Pin 1
Tube Specifications
Material
PVC, transparent with antistatic coating
Surface resistance
< 1011 Ohm/square
Bakability
The tubes are not bakable
Tube capacity
10 products / tube
Box capacity
100 products (10 full tubes / box)
Tube weight
Typical 160 g full tube
Tray Specifications
Material
PPE, antistatic
Surface resistance
105 < Ohm/square < 1012
Bakability
The trays can be baked at maximum
125 °C for maximum 48 hours
Tray capacity
15 products / tray
Box capacity
150 products (10 full trays / box)
Tray weight
140 g empty, 320 g full tray maximum
JEDEC standard tray
Note: all tray dimensions refer to pocket center. Exact position
of pickup point depends on the position of the pickup surface
(top of main transformer) of the individual product variant
E
PKR 4000 series
DC/DC converters, Input 36-75 V, Output up to 1.5 A/7 W
EN/LZT 146 302 R6E September 2007
Ericsson Power Modules AB
Technical Specication
E
PKR 4000 series
DC/DC converters, Input 36-75 V, Output up to 1.5 A/7 W
EN/LZT 146 302 R6F November 2007
Ericsson Power Modules AB
Technical Specication
E
PKR 4000 series
DC/DC converters, Input 36-75 V, Output up to 1.5 A/7 W
EN/LZT 146 302 R6G November 2008
Ericsson Power Modules AB
Technical Specication
35