- 您现在的位置：买卖IC网 > PDF目录65956 > PLY10AN1430R5R2M (MURATA MANUFACTURING CO LTD) 300 V, SINGLE PHASE EMI FILTER PDF资料下载
参数资料
| 型号： | PLY10AN1430R5R2M |
| 厂商： | MURATA MANUFACTURING CO LTD |
| 元件分类： | 电源滤波器 |
| 英文描述： | 300 V, SINGLE PHASE EMI FILTER |
| 文件页数： | 3/3页 |
| 文件大小： | 70K |
| 代理商： | PLY10AN1430R5R2M |
Continued from the preceding page.
http://www.murata.com/
Data Sheet
! Note:
1. This datasheet is downloaded from the website of Murata Manufacturing co., ltd. Therefore, it’s specifications are subject to change or our
products in it may be discontinued without advance notice. Please check with our sales representatives or product engineers before ordering.
2. This datasheet has only typical specifications because there is no space for detailed specifications. Therefore, please approve our product
specifications or transact the approval sheet for product specifications before ordering.
3
o This data sheet is applied for AC Line Filters Hybrid Choke Coils used for General Electronics equipment for your design.
2007.7.4
Noise Suppression Products/EMI Suppression Filters > AC Line Filters > Hybrid Choke Coils
Part Number
Common Mode Inductance (min.)
Normal Mode Inductance (min.)
Rated Current
Rated Voltage
PLY10AN4420R8D2p
4.4mH
320
H
0.8A
300Vac
PLY10AN8720R7D2p
8.7mH
500
H
0.7A
300Vac
PLY10AN9720R6D2p
9.7mH
670
H
0.6A
300Vac
PLY10AN1130R5D2p
11.0mH
840
H
0.5A
300Vac
Common Mode Inductor
Differential Mode Inductor
(1)
(2)
(3)
(4)
No polarity.
Operating Temperature Range (Ambient Temperature Range + Winding Temperature Rise): -25
°C to 120°C
Winding Temperature Rise (at Rated Current) (max.): 60K
1. Rated Current
Operating current should not exceed the rated
value. Even if operating current is under the
rated value, adequate ventilation is required to
avoid excessive heat generated within the product
(choke coil) and from surrounding heat sources.
If exceeding these conditions, excessive heat may
cause fumes or permanent damage to the product.
Please ensure that product (choke coil) is
evaluated and confirmed against the specification
when it is mounted in your final assembled product.
-> Winding temperature should be less than
120 degree C.
*As for FKOB series winding temperature should be
less than 95 degree C.
Maximum allowable temperature at the surface of
coil (ambient temperature + winding temperature
rise) is in accordance with each safety standard
applicable to final assembled product.
When the temperature at winding exceeds maximum
allowable temperature of safety standard, the
rated current should be derated.
2. Inrush Current
Inrush current should not exceed 10 times rated
current within 1/4 cycle of 50/60Hz commercial
power line. Inrush current should be limited to a
minimum of 10 seconds after last inrush.
If these conditions are exceeded, excessive heat may
cause fumes or permanent damage to the component,
or at worst cause ignition.
I !Caution (Rating)
Magnetic Flux Leakage
Choke coils generate small amounts of magnetic flux
leakage that may adversely affect equipment operation
according to component arrangement.
Testing should be completed on final assembly to
ensure equipment performance is not affected.
I Notice (Soldering and Mounting)
Coil Humming Noise
Magnetic flux generated between coil and core or
between the choke coil windings creates repulsive
power between the coil windings. This repulsive
power causes the coil winding to vibrate and create
a humming noise. The amount of hum produced by the
coil is proportionate to the amount of harmonic
distortion generated by the operating current. This
does not influence the electrical performance of
the coils, but it should be considered and tested
in actual circuit application.
I Notice (Other)
I Equivalent Circuit
I Packaging
Code
Packaging
Minimum Quantity
M
Magazine
1800
B
Box
1200
相关PDF资料 |
PDF描述 |
|---|---|
| PLY10AN1521R6R2M | 300 V, SINGLE PHASE EMI FILTER |
| PLY10AN2121R4R2M | 300 V, SINGLE PHASE EMI FILTER |
| PLY10AN2321R2D2M | 300 V, SINGLE PHASE EMI FILTER |
| PLY10AN2821R2R2M | 300 V, SINGLE PHASE EMI FILTER |
| PLY10AN3521R0D2M | 300 V, SINGLE PHASE EMI FILTER |
相关代理商/技术参数 |
参数描述 |
|---|---|
| PLY10AN1430R5R3B | 功能描述:共模滤波器/扼流器 14.0mH/1000uH 0.5A AC Line Filter RoHS:否 制造商:TDK 电感: 阻抗:35 Ohms 容差: 最大直流电流:0.1 A 最大直流电阻:1.5 Ohms 自谐振频率: Q 最小值: 工作温度范围:- 25 C to + 85 C 端接类型:SMD/SMT 封装 / 箱体:0302 (0806 metric) 系列:TCE |
| PLY10AN1521R6R2B | 功能描述:共模滤波器/扼流器 1.5mH/110uH 1.6A AC Line Filter RoHS:否 制造商:TDK 电感: 阻抗:35 Ohms 容差: 最大直流电流:0.1 A 最大直流电阻:1.5 Ohms 自谐振频率: Q 最小值: 工作温度范围:- 25 C to + 85 C 端接类型:SMD/SMT 封装 / 箱体:0302 (0806 metric) 系列:TCE |
| PLY10AN1521R6R3B | 功能描述:共模滤波器/扼流器 1.5mH/110uH 1.6A AC Line Filter RoHS:否 制造商:TDK 电感: 阻抗:35 Ohms 容差: 最大直流电流:0.1 A 最大直流电阻:1.5 Ohms 自谐振频率: Q 最小值: 工作温度范围:- 25 C to + 85 C 端接类型:SMD/SMT 封装 / 箱体:0302 (0806 metric) 系列:TCE |
| PLY10AN1522R0A2B | 制造商:MURATA 制造商全称:Murata Manufacturing Co., Ltd. 功能描述:EMI Suppression Filters for AC Power Lines |
| PLY10AN1522R0A2M | 制造商:MURATA 制造商全称:Murata Manufacturing Co., Ltd. 功能描述:EMI Suppression Filters for AC Power Lines |
发布紧急采购，3分钟左右您将得到回复。