- 您现在的位置：买卖IC网 > PDF目录378053 > PM49FL004T-33JC (PMC-Sierra, Inc.) 2 Mbit / 4 Mbit 3.3 Volt-only Firmware Hub/LPC Flash Memory PDF资料下载
参数资料
| 型号： | PM49FL004T-33JC |
| 厂商： | PMC-Sierra, Inc. |
| 英文描述： | 2 Mbit / 4 Mbit 3.3 Volt-only Firmware Hub/LPC Flash Memory |
| 中文描述： | 2兆位/ 4兆位3.3伏，只固件集线器/ LPC快闪记忆体 |
| 文件页数： | 8/46页 |
| 文件大小： | 208K |
| 代理商： | PM49FL004T-33JC |
第1页第2页第3页第4页第5页第6页第7页当前第8页第9页第10页第11页第12页第13页第14页第15页第16页第17页第18页第19页第20页第21页第22页第23页第24页第25页第26页第27页第28页第29页第30页第31页第32页第33页第34页第35页第36页第37页第38页第39页第40页第41页第42页第43页第44页第45页第46页
Programmable Microelectronics Corp.
Issue Date: December, 2003 Rev: 1.4
8
PMC
Pm49FL002 / 004
SECTOR AND BLOCK ERASE
The Pm49FL002 contains sixty-four uniform 4 Kbyte sec-
tors, or sixteen uniform 16 Kbyte blocks (sector group -
consists of four adjecent sectors). The Pm49FL004 con-
tains one hundred and twenty-eight uniform 4 Kbyte sec-
tors, or eight uniform 64 Kbyte blocks (sector group -
consists of sixteen adjecent sectors). A sector erase
command is used to erase an individual sector. A block
erase command is used to erase an individual block.
See Table 12 - 13 for Sector/Block Address Tables.
In FWH/LPC mode, an erase operation is activated by
writing the six-byte command sequence through six con-
secutive write memory cycles. In A/A Mux mode, an
erase operation is activated by writing the six-byte com-
mand in six consecutive bus cycles. Pre-programs the
sector or block is not required prior to an erase opera-
tion.
I/O7 DATA# POLLING
The devices provide a Data# Polling feature to indicate
the progress or the completion of a program or erase
operation in all modes. During a program operation, an
attempt to read the device will result in the complement
of the last loaded data on I/O7. Once the program cycle
is complete, the true data of the last loaded data is valid
on all outputs. During an erase operation, an attempt to
read the device will result a
“
0
”
on I/O7. After the erase
cycle is complete, an attempt to read the device will
result a
“
1
”
on I/O7.
DEVICE OPERATION (CONTINUED)
I/O6 TOGGLE BIT
The Pm49FL002/004 also provide a Toggle Bit feature to
detect the progress or the completion of a program or
erase operation. During a program or erase operation,
an attempt to read data from the devices will result in I/
O6 toggling between
“
1
”
and
“
0
”
. When the program or
erase operation is complete, I/O6 will stop toggling and
valid data will be read. Toggle bit may be accessed at
any time during a program or erase operation.
RESET
Any read, program, or erase operation to the devices
can be reset by the INIT# or RST# pins. INIT# and RST#
pins are internally hard-wired and have same function to
the devices. The INIT# pin is only available in FWH and
LPC modes. The RST# pin is available in all modes. It
is required to drive INIT# or RST# pins low during sys-
tem reset to ensure proper initialization.
During a memory read operation, pulls low the INIT# or
RST# pin will reset the devices back to standby mode
and then the FWH[3:0] of FWH interface or the LAD[3:0]
of LPC interface will go to high impedance state. During
a program or erase operation, pulls low the INIT# or RST#
pin will abort the program or erase operation and reset
the devices back to standby mode. A reset latency will
occur before the devices resume to standby mode when
such reset is performed. When a program or erase op-
eration is reset before the completion of such opera-
tion, the memory contents of devices may become
invalid due to an incomplete program or erase opera-
tion.
相关PDF资料 |
PDF描述 |
|---|---|
| PM49FL004T-33JCE | 2 Mbit / 4 Mbit 3.3 Volt-only Firmware Hub/LPC Flash Memory |
| PM49FL004T-33VC | 2 Mbit / 4 Mbit 3.3 Volt-only Firmware Hub/LPC Flash Memory |
| PM49FL002T-33JCE | 2 Mbit / 4 Mbit 3.3 Volt-only Firmware Hub/LPC Flash Memory |
| PM49FL002T-33VCE | 2 Mbit / 4 Mbit 3.3 Volt-only Firmware Hub/LPC Flash Memory |
| PM49FL004T-33VCE | 2 Mbit / 4 Mbit 3.3 Volt-only Firmware Hub/LPC Flash Memory |
相关代理商/技术参数 |
参数描述 |
|---|---|
| PM49FL004T-33JCE | 制造商:PMC 制造商全称:PMC 功能描述:2 Mbit / 4 Mbit 3.3 Volt-only Firmware Hub/LPC Flash Memory |
| PM49FL004T-33VC | 制造商:PMC 制造商全称:PMC 功能描述:2 Mbit / 4 Mbit 3.3 Volt-only Firmware Hub/LPC Flash Memory |
| PM49FL004T-33VCE | 制造商:PMC 制造商全称:PMC 功能描述:2 Mbit / 4 Mbit 3.3 Volt-only Firmware Hub/LPC Flash Memory |
| PM4A472J | 制造商:ELPAC CAPACITORS 功能描述:FILM CAPACITOR |
| PM4B105K | 制造商:ELPAC CAPACITORS 功能描述:FILM |
发布紧急采购，3分钟左右您将得到回复。