- 您现在的位置：买卖IC网 > PDF目录69064 > PMH4518TS (ERICSSON POWER MODULES AB) 1-OUTPUT 55 W DC-DC REG PWR SUPPLY MODULE PDF资料下载
参数资料
| 型号： | PMH4518TS |
| 厂商： | ERICSSON POWER MODULES AB |
| 元件分类： | 电源模块 |
| 英文描述： | 1-OUTPUT 55 W DC-DC REG PWR SUPPLY MODULE |
| 封装： | ROHS COMPLIANT, PACKAGE-10 |
| 文件页数： | 15/29页 |
| 文件大小： | 677K |
| 代理商： | PMH4518TS |
第1页第2页第3页第4页第5页第6页第7页第8页第9页第10页第11页第12页第13页第14页当前第15页第16页第17页第18页第19页第20页第21页第22页第23页第24页第25页第26页第27页第28页第29页
Ericsson Internal
PRODUCT SPEC.
3 (5)
Prepared (also subject responsible if other)
No.
SEC/D KEVIN YAN
3/1301-BMR 645 4 Uen
Approved
Checked
Date
Rev
Reference
SEC/D Wei Zhang A
2006-2-8
A
will resume normal operation after removal of the overload.
The load distribution should be designed for the maximum
output short circuit current specified. The current limit
operation is a “hick up” mode current limit.
Soft-start Power Up
From the moment a valid input voltage is applied, the soft-
start control introduces a short time-delay (typically 5-10 ms)
before allowing the output voltage to rise.
The initial rise in input current when the input voltage first
starts to rise is the charge current drawn by the input
capacitors. Power-up is complete within 15 ms.
Auto-Track Function
Auto-Track was designed to simplify the amount of circuitry
required to make the output vltage from each module power
up and power down in sequence. The sequencing of two or
more supply voltages during power up is a common
requirement for complex mixed-signal applications, that use
dual-voltage VLSI ICs such as DSPs, micro-processors and
ASICs.
Margin Up/Down controls
These controls allow the input voltage to be momentarily
adjusted, either up or down, by a nominal 5 %. This provides
a convenient method for dynamically testing the operation of
the load circuit over its supply margin or range. It can also be
used to verify the function of supply voltage supervisors.
Pre-Bias Startup Capability
This often occurs in complex digital systems when current
from another power source is backfed through a dual-supply
logic component, such as FPGA or ASIC.
The PMH(3.3/5.0V Vin) incorporate synchronous rectifiers, but
will not sink current during startup, or whenever the Inhibit pin
is held low. However, to ensure satisfactory operation of this
function, certain conditions must be maintained.
Thermal Consideration
General
The regulators are designed to operate in different thermal
environments and sufficient cooling must be provided to
ensure reliable operation.
Cooling is achieved mainly by conduction, from the pins to
the host board, and convection, which is dependant on the
airflow across the regulator. Increased airflow enhances the
cooling of the regulator.
The Output Current Derating graph found in the Output
section for each model provides the available output current
vs. ambient air temperature and air velocity at Vin = 3.3 V.
The DC/DC regulator is tested on a 254 x 254 mm,
35 m (1 oz), 8-layer test board mounted vertically in a wind
tunnel with a cross-section of 305 x 305 mm.
Proper cooling of the DC/DC regulator can be verified by
measuring the temperature at positions P1, P2 and P3. The
temperature at these positions should not exceed the max
values provided in the table below.
Note that the max value is the absolute maximum rating
(non destruction) and that the electrical Output data is
guaranteed up to Tref +85°C.
See Design Note 019 for further information.
Position
Device
Designation
max value
P1
Pcb
125 C
P2
Mosfet
Tref
135 C
P3
Inductor
130 C
E
PMH 4000 series
POL regulator, Input 2.95-3.65 V, Output 22 A/55 W
EN/LZT 146 322 R1B February 2006
Ericsson Power Modules AB
Technical Specication
E
PMH 4000 series
POL regulator, Input 2.95-3.65 V, Output 22 A/55 W
EN/LZT 146 322 R1B April 2006
Ericsson Power Modules AB
Technical Specication
22
相关PDF资料 |
PDF描述 |
|---|---|
| PMH4518TP | 1-OUTPUT 55 W DC-DC REG PWR SUPPLY MODULE |
| PMH8318TS | 1-OUTPUT 32.4 W DC-DC REG PWR SUPPLY MODULE |
| PMH8318TSR | 1-OUTPUT 32.4 W DC-DC REG PWR SUPPLY MODULE |
| PMH8318TP | 1-OUTPUT 32.4 W DC-DC REG PWR SUPPLY MODULE |
| PMH8918LSR | 1-OUTPUT 90 W DC-DC REG PWR SUPPLY MODULE |
相关代理商/技术参数 |
参数描述 |
|---|---|
| PMH4518TSR | 功能描述:DC/DC转换器 0.8-2.5V 22A Non-Iso Input 3.3V 55W RoHS:否 制造商:Murata 产品: 输出功率: 输入电压范围:3.6 V to 5.5 V 输入电压（标称）: 输出端数量:1 输出电压（通道 1）:3.3 V 输出电流（通道 1）:600 mA 输出电压（通道 2）: 输出电流（通道 2）: 安装风格:SMD/SMT 封装 / 箱体尺寸: |
| PMH5718TP | 功能描述:DC/DC转换器 0.8-3.6V 22A Non-Iso Input 5V 79.2W RoHS:否 制造商:Murata 产品: 输出功率: 输入电压范围:3.6 V to 5.5 V 输入电压（标称）: 输出端数量:1 输出电压（通道 1）:3.3 V 输出电流（通道 1）:600 mA 输出电压（通道 2）: 输出电流（通道 2）: 安装风格:SMD/SMT 封装 / 箱体尺寸: |
| PMH5718TS | 功能描述:DC/DC转换器 .8-3.6 Vdc 22A Iso Input 5V 79.2W RoHS:否 制造商:Murata 产品: 输出功率: 输入电压范围:3.6 V to 5.5 V 输入电压（标称）: 输出端数量:1 输出电压（通道 1）:3.3 V 输出电流（通道 1）:600 mA 输出电压（通道 2）: 输出电流（通道 2）: 安装风格:SMD/SMT 封装 / 箱体尺寸: |
| PMH5718TSR | 功能描述:DC/DC转换器 0.8-3.6V 22A Non-Iso Input 5V 79.2W RoHS:否 制造商:Murata 产品: 输出功率: 输入电压范围:3.6 V to 5.5 V 输入电压（标称）: 输出端数量:1 输出电压（通道 1）:3.3 V 输出电流（通道 1）:600 mA 输出电压（通道 2）: 输出电流（通道 2）: 安装风格:SMD/SMT 封装 / 箱体尺寸: |
| PMH61X308 | 制造商:Perlos 功能描述: |
发布紧急采购，3分钟左右您将得到回复。