- 您现在的位置：买卖IC网 > Datasheet目录352 > POE33U-1AT (PHIHONG USA)ADAPTER POE INJECTOR 33.6W 56V Datasheet资料下载
参数资料
| 型号： | POE33U-1AT |
| 厂商： | PHIHONG USA |
| 文件页数： | 5/5页 |
| 文件大小： | 0K |
| 描述： | ADAPTER POE INJECTOR 33.6W 56V |
| 标准包装： | 1 |
| 类型： | 单端口，Midspan 电源供应器 |
| 电源（瓦） - 每个端口： | 33.6W |
| 端口数： | 1 |
| 输入电压： | 90 ~ 264VAC |
| 输出电压： | 56VDC |
| 电流 - 输出： | 600mA |
| 安装类型： | 支架安装 |
| 尺寸/尺寸： | 9.93" L x 6.93" W x 3.07" H（252.1mm x 176.0mm x 78.0mm） |
| 输入连接器： | 端接块 |
| 效率： | 70% |
| 工作温度： | -40°C ~ 60°C |
| 其它名称： | 993-1145 |
Installation Instructions
1) The unit is packaged fully closed with the
mounting bracket pre-installed; remove from
packaging and loosen the four captive screws
located at the top of the midspan so that the lid
can be lifted easily.
2) Using a Philips screwdriver, remove the four
WWW.PHIHONG.COM
5) Thread outdoor rated waterproof AC cable
(must comply with all local, national and
country electrical codes) from source through
piping/gland to the terminal block. The AC
cable will need to be a minimum of 14AWG
and terminated with M3.5 spade lugs. Pair and
secure ground, line, and neutral to the
appropriate positions on the three pin terminal
block and reattach the protective covering.
Note: if using the cable gland PGLAND750, the
outer seal nut needs to be fully tightened to
close rubber seal to protect against ingress of
water.
screws holding the protective covering for the
PC Board, and the two screws for the protective
covering over the AC terminal block.
6) Using waterproof outdoor rated Cat5e Ethernet
cable, thread through cable glands or conduit
piping to the appropriate RJ45 connector and
3) Connect cable glands (PGLAND750) or ? NPT
ensure each portal is properly sealed.
conduit piping to the face of the midspan.
Ensure that connectors are fully installed to
guarantee waterproof operation.
7) Reattach the protective covering over the PC
board and terminal blocks and re-close the lid.
Ensure that the four captive screws are fully
4) To better enable waterproof operation it is
recommended that installers use Teflon tape to
cover threads before installation. Users may
also wish to use silicon sealant to further protect
from ingress of liquid.
tightened before operation can commence.
相关PDF资料 |
PDF描述 |
|---|---|
| POE36D-1AT | ADAPTER POE INJECTOR 33.6W 56V |
| POE36U-1AT | ADAPTER POE INJECTOR 33.6W 56V |
| POE370U-480-24-N | POWER SUPPLY 24PORT GIGABIT |
| POE45-120 | ADAPTER POE SPLITTER 45W 12V |
| POE480U-8UP | POWER SUPPLY 8PORT 480W |
相关代理商/技术参数 |
参数描述 |
|---|---|
| POE33U-1AT-R | 功能描述:以太网供电 - PoE 33W 56V 0.59V IEEE802.3af Gigabit RoHS:否 制造商:Phihong 输入电压（标称）:90 VAC to 264 VAC 输出端数量:1 输出功率额定值:15.4 W 输出电压:48 V 输出电流:0.35 A 随附/必需的交流插头:Required |
| POE33U-560DO | 功能描述:以太网供电 - PoE RoHS:否 制造商:Phihong 输入电压（标称）:90 VAC to 264 VAC 输出端数量:1 输出功率额定值:15.4 W 输出电压:48 V 输出电流:0.35 A 随附/必需的交流插头:Required |
| POE33U-560DO-R | 功能描述:以太网供电 - PoE 16.8W 56Vdc 300mA Dual Port PassivePOE RoHS:否 制造商:Phihong 输入电压（标称）:90 VAC to 264 VAC 输出端数量:1 输出功率额定值:15.4 W 输出电压:48 V 输出电流:0.35 A 随附/必需的交流插头:Required |
| POE-35088T | 制造商:Unicom 功能描述:8 PORT 10/100 POE SWITCH 2*1000T/SFP GBIC AC |
| POE36D-1AT | 功能描述:ADAPTER POE INJECTOR 33.6W 56V RoHS:是 类别:电源 - 外部/内部（非板载） >> 以太网供电 (PoE) 系列:POE36x 标准包装:1 系列:PSA16U 类型:单端口，Midspan 电源供应器 电源（瓦） - 每个端口:15.4W 端口数:1 输入电压:100 ~ 240 VAC 输出电压:48VDC 电流 - 输出:350mA 安装类型:台式 尺寸/尺寸:5.98" L x 2.56" W x 1.42" H（152.0mm x 65.0mm x 36.0mm） 输入连接器:IEC320-C14 效率:65% 工作温度:0°C ~ 40°C 特点:电源线单独销售 相关产品:817-1654-ND - LOCKING LINE CORD 3 COND UK 2M817-1655-ND - LOCKING LINE CORD 3 COND EU 2M817-1656-ND - LOCKING LINE CORD 3 COND US 6'817-1657-ND - LOCKING LINE CORD 3 COND US 6'993-1040-ND - LINE CORD 3 COND UK993-1039-ND - LINE CORD 3 COND US993-1038-ND - LINE CORD 3 COND EU 其它名称:PSA16U-480-R |
发布紧急采购，3分钟左右您将得到回复。