- 您现在的位置：买卖IC网 > Datasheet目录698 > PP016 (Teledyne LeCroy)PASS PROBE 10:1 300MHZ-WAVEACE Datasheet资料下载
参数资料
| 型号： | PP016 |
| 厂商： | Teledyne LeCroy |
| 文件页数： | 3/6页 |
| 文件大小： | 0K |
| 描述： | PASS PROBE 10:1 300MHZ-WAVEACE |
| 产品培训模块： | Fundamentals of Probing Overview |
| 视频文件： | LeCroy WaveAce Using Basic Math LeCroy WaveAce Using the FFT LeCroy WaveAce Using Push Button Knobs LeCroy WaveAce Using the Sequence Recorder LeCroy WaveAce Measure with Cursors LeCroy WaveAce Saving Waveforms and Setups LeCroy WaveAce Quickly Display a Waveform LeCroy WaveAce Pass Fail Mask Testing LeCroy WaveAce Using the Help Function LeCroy WaveAce Setting Probe Attenuation LeCroy WaveAce Selecting an Acquisition Mode LeCroy WaveAce Measure with Parameters LeCroy WaveAce Closer Look at Waveforms |
| 标准包装： | 1 |
| 系列： | WaveAce™ |
| 类型： | 无源 |
| 衰减值： | 1:1，10:1 |
| 带宽： | 10MHz，300MHz |
| 电阻 - 输入： | 1M，10M |
| 电压 - 最大： | 600V（DC + AC 峰值） |
| 电容 - 输入： | 46pF，12pF |
| 线缆长度： | 47.244"（1200.00mm） |
| 颜色： | 黑 |
| 包括： | 调节工具，BNC 适配器，编码环，接地连接和引线，IC 测试触头，替代触头，弹簧钩 |
| 配用： | WAVEACE 2034-ND - DGTL O-SCOPE 300MHZ 4CH 1GS/S WAVEACE 2032-ND - DGTL O-SCOPE 300MHZ 2CH 1GS/S WAVEACE 2024-ND - DGTL O-SCOPE 200MHZ 4CH 1GS/S WAVEACE 2022-ND - DGTL O-SCOPE 200MHZ 2CH 1GS/S WAVEACE 2014-ND - DGTL O-SCOPE 100MHZ 4CH 1GS/S WAVEACE 2012-ND - DGTL O-SCOPE 100MHZ 2CH 1GS/S WAVEACE 2004-ND - DGTL O-SCOPE 70MHZ 4CH 1GS/S WAVEACE 2002-ND - DGTL O-SCOPE 70MHZ 2CH 1GS/S WAVEACE 1012-ND - DGTL O-SCOPE 100MHZ 2CH 500MS/S WAVEACE 1002-ND - DGTL O-SCOPE 60MHZ 2CH 500MS/S 更多... |
| 相关产品： | PKIT3-5MM-101-ND - WAVEACE PROBE ACCES |
Introduction
The probe PP016 described in this manual is passive probes to be used with LeCroy
WaveAce oscilloscopes
Safety Information
This symbol appears on the product:
It refers you to additional information contained in this manual. The corresponding
information in the manual is similarly denoted.
To avoid personal injury and to prevent fire or damage to the probe or any products
connected to it, review and comply with the following safety precautions.
WARNING -- ELECTRIC SHOCK HAZARD
Do not remove the probe case. Removal of the probe case may expose you to
electric shock.
Do not disassemble the probe. Disassembling the probe may expose you to
electric shock.
Do not disconnect the probe from the scope during measurement.
Disconnecting the probe during measurement may expose you to electric.
Connect the probes grounding terminal to the ground potential of the device under
test. Failure to connect to ground potential may expose you to electric shock.
Connect to properly grounded instruments . This probe is to be used only with test
instruments having input connectors with the BNC shield (ring) connected to earth
ground.
Connect the probe properly: Connect the probe to the measurement instrument
before connecting the probe to test circuit. Do not disconnect the probe from the test
instrument while the input is connected to the test circuit.
Do not connect the probe ground terminal to any point in the test circuit that is at a
potential other than earth ground.
Do not apply to the input any potential that exceeds the maximum ratings of
the probe. Refer to specifications.
Do not use in wet or explosive atmospheres.
For indoor use only. This probe is intended for indoor use and should be operated in
a clean, dry environment.
Do not use the probe if any part is damaged. All maintenance should be referred to
qualified service personnel.
Avoid physical injury. The probe tip is extremely sharp. Use care when handling
to prevent injury, including accidental skin puncture.
Use of the probe and/or the test instrument it is connected to in a manner not specified
by the manufacturer may impair the protection mechanisms.
PP016-OM-E Rev A
3
相关PDF资料 |
PDF描述 |
|---|---|
| PPE1.2KV | PROBE HV 10:1/100:1 200/300MHZ |
| PPE2KV | PROBE HV 100:1 400MHZ 50M OHMS |
| PPE4KV | PROBE HV 100:1 400MHZ 50M OHMS |
| PPE5KV | PROBE HV 100:1 400MHZ 50M OHMS |
| PPE6KV | PROBE HV 1000:1 400MHZ 5/50MOHMS |
相关代理商/技术参数 |
参数描述 |
|---|---|
| PP-016 | 功能描述:CONN DC POWER PLUG 1.4X4.3X6.5MM RoHS:是 类别:连接器，互连式 >> 桶型 - 电源 系列:- 标准包装:800 系列:- 连接器类型:插孔 类型:公头 插头/配接插头直径:2.5mm 内径，5.5mm 外径 位置/触点数:3 导线，3 触点 内部开关:单开关，常闭 安装类型:表面贴装，直角 端子:焊接 屏蔽:无屏蔽 特点:- 颜色:黑 触点材料:铜合金 触点材料 - 镀层:镍 体座颜色:黑 体座材料:热塑塑胶 工作温度:- 电压 - 额定:- 额定电流:3A |
| PP017 | 制造商:TELEDYNE 制造商全称:TELEDYNE 功能描述:High Definition Oscilloscopes |
| PP-017 | 功能描述:CONN DC PWR PLUG 0.9X3.2X9.0MM RoHS:是 类别:连接器，互连式 >> 桶型 - 电源 系列:- 标准包装:800 系列:- 连接器类型:插孔 类型:公头 插头/配接插头直径:2.5mm 内径，5.5mm 外径 位置/触点数:3 导线，3 触点 内部开关:单开关，常闭 安装类型:表面贴装，直角 端子:焊接 屏蔽:无屏蔽 特点:- 颜色:黑 触点材料:铜合金 触点材料 - 镀层:镍 体座颜色:黑 体座材料:热塑塑胶 工作温度:- 电压 - 额定:- 额定电流:3A |
| PP017-1 | 功能描述:测试探头 PASSIVE PROBE FOR HDO 4000 RoHS:否 制造商:Teledyne LeCroy 设备类型:Passive Probes 带宽:500 MHz 尖端类型: 长度:1.3 mm 颜色:Black 电压额定值: 电流额定值: |
| PP017-2 | 功能描述:测试探头 PASSIVE PROBE FOR HDO 4000 RoHS:否 制造商:Teledyne LeCroy 设备类型:Passive Probes 带宽:500 MHz 尖端类型: 长度:1.3 mm 颜色:Black 电压额定值: 电流额定值: |
发布紧急采购，3分钟左右您将得到回复。