参数资料
型号: PR32MA11NTZF
厂商: Sharp Microelectronics
文件页数: 8/14页
文件大小: 0K
描述: RELAY SSR 240V 150MA 6-DIP
产品目录绘图: PR22MA11N, PR32MA11N
标准包装: 50
系列: PR32MA
电路: SPST-NO(1 Form A)
输出类型: AC
负载电流: 150mA
输入电压: 1.2VDC
电压 - 负载: 0 ~ 240 V
安装类型: 通孔
端接类型: PC 引脚
封装/外壳: 6-DIP(0.300",7.62mm),5 引线
供应商设备封装: 6-DIP
包装: 管件
继电器类型: 继电器
产品目录页面: 2634 (CN2011-ZH PDF)
其它名称: 425-2604-5
PR32MA11NTZF-ND
PR22MA11NTZ Series
PR32MA11NTZ Series
■ Design Considerations
● Recommended Operating Conditions
Parameter
Symbol
Conditions
MIN.
MAX.
Unit
Input
Input signal current at ON state
Input signal current at OFF state
I F (ON)
I F (OFF)
?
?
20
0
25
0.1
mA
mA
Load supply voltage
PR22MA11NTZ
PR32MA11NTZ
V OUT (rms)
?
?
120
240
V
Output
Load supply current
I OUT (rms)
Locate snubber circuit between output terminals
(Cs = 0.01 μ F, Rs = 100 ? )
?
I T (rms) × 80%( ? )
mA
Frequency
Operating temperature
f
T opr
?
?
50
? 20
60
70
Hz
?C
( ? ) See Fig.2 about derating curve (I T (rms) vs. ambient temperature).
● Design guide
In order for the SSR to turn off, the triggering current (I F ) must be 0.1mA or less.
In phase control applications or where the SSR is being by a pulse signal, please ensure that the pulse width
is a minimum of 1ms.
When the input current (I F ) is below 0.1mA, the output Triac will be in the open circuit mode. However, if the
voltage across the Triac, V D , increases faster than rated dV/dt, the Triac may turn on. To avoid this situation,
please incorporate a snubber circuit. Due to the many different types of load that can be driven, we can
merely recommend some circuit values to start with : Cs = 0.01 μ F and Rs = 100 ? . The operation of the SSR
and snubber circuit should be tested and if unintentional switching occurs, please adjust the snubber circuit
component values accordingly.
When making the transition from On to Off state, a snubber circuit should be used ensure that sudden drops
in current are not accompanied by large instantaneous changes in voltage across the Triac.
This fast change in voltage is brought about by the phase difference between current and voltage.
Primarily, this is experienced in driving loads which are inductive such as motors and solenods.
Following the procedure outlined above should provide sufficient results.
Any snubber or Varistor used for the above mentioned scenarios should be located as close to the main
output triac as possible.
All pins shall be used by soldering on the board. (Socket and others shall not be used.)
● Degradation
In general, the emission of the IRED used in SSR will degrade over time.
In the case where long term operation and / or constant extreme temperature fluctuations will be applied to
the devices, please allow for a worst case scenario of 50% degradation over 5years.
Therefore in order to maintain proper operation, a design implementing these SSRs should provide at least
twice the minimum required triggering current from initial operation.
Sheet No.: D4-A00201EN
8
相关PDF资料
PDF描述
PR33MF11NSZF RELAY SSR 240VAC .3A 8-DIP
PR33MF51NSZF RELAY SSR TRIAC OUT 300MA 8-DIP
PR36MF11NSZF RELAY SSR 240VAC .6A TRIAC 8-DIP
PR36MF22NSZ RELAY SSR 240VAC .6A ZC 8-DIP
PR39MF11NSZF RELAY SSR 240VAC .9A TRIAC 8-DIP
相关代理商/技术参数
参数描述
PR32MA11NXPF 制造商:Sharp Microelectronics Corporation 功能描述:
PR32MA11YXPF 制造商:SHARP 功能描述:RELAY SOLID STATE 制造商:Sharp Microelectronics Corporation 功能描述:RELAY, SOLID STATE 制造商:Sharp Microelectronics Corporation 功能描述:SSR Triac Non-Zero 0.15A 600V DIP6 SMT
PR33-2-TO8 功能描述:光电二极管 UV/Blue enhanced 5.5x6.1mm Area RoHS:否 制造商:Vishay Semiconductors 产品:Photodiodes 反向电压:10 V 最大暗电流:30 nA 峰值波长:565 nm 上升时间:3.1 us 下降时间:3 us 半强度角度:50 deg 封装 / 箱体:TO-5
PR3365S 制造商:Stanley Electric Co 功能描述:LED Uni-Color Red 700nm 2-Pin T-1 Bulk 制造商:Stanley Electric 功能描述:LED Uni-Color Red 700nm 2-Pin T-1 Bulk 制造商:Stanley Electric 功能描述:LED 3mm Red 630nm 98deg unique wide beam
PR33-6-TO8 功能描述:光电二极管 Low Dark Current 5.5 X 6.1mm Area RoHS:否 制造商:Vishay Semiconductors 产品:Photodiodes 反向电压:10 V 最大暗电流:30 nA 峰值波长:565 nm 上升时间:3.1 us 下降时间:3 us 半强度角度:50 deg 封装 / 箱体:TO-5