- 您现在的位置：买卖IC网 > Datasheet目录1001 > PR33MF51NSZF (Sharp Microelectronics)RELAY SSR TRIAC OUT 300MA 8-DIP Datasheet资料下载
参数资料
| 型号： | PR33MF51NSZF |
| 厂商： | Sharp Microelectronics |
| 文件页数： | 8/14页 |
| 文件大小： | 0K |
| 描述： | RELAY SSR TRIAC OUT 300MA 8-DIP |
| 产品目录绘图： | PRxxMF Series Circuit |
| 标准包装： | 500 |
| 系列： | PR33MF |
| 电路： | SPST-NO（1 Form A） |
| 输出类型： | AC |
| 负载电流： | 300mA |
| 输入电压： | 1.2VDC |
| 电压 - 负载： | 0 ~ 240 V |
| 安装类型： | 通孔 |
| 端接类型： | PC 引脚 |
| 封装/外壳： | 8-DIP（0.300"，7.62mm），7 引线 |
| 供应商设备封装： | 8-DIP |
| 包装： | 管件 |
| 继电器类型： | 继电器 |
| 产品目录页面： | 2634 (CN2011-ZH PDF) |
| 其它名称： | 425-2647-5 |
PR33MF51NSZF Series
■ Design Considerations
● Recommended Operating Conditions
Parameter
Symbol
Condition
MIN.
MAX.
Unit
Input
Input signal current at ON state
Input signal current at OFF state
I F (ON)
I F (OFF)
?
?
20
0
25
0.1
mA
mA
Load supply voltage
Output Load supply current
Frequency
Operating temperature
V OUT (rms)
I OUT (rms)
f
T opr
?
Locate snubber circuit between output terminals
(Cs = 0.022 μ F, Rs = 47 Ω )
?
?
?
?
50
? 20
240
I T (rms)×
80%(*)
60
80
V
A
Hz
? C
(*) See Fig.2 about derating curve (I T (rms) vs. ambient temperature).
● Degradation
In order for the SSR to turn off, the triggering current (I F ) must be 0.1mA or less
In phase control applications or where the SSR is being by a pulse signal, please ensure that the pulse width
is a minimum of 1ms.
When the input current (I F ) is below 0.1mA, the output Triac will be in the open circuit mode. However, if the
voltage across the Triac, V D , increases faster than rated dV/dt, the Triac may turn on. To avoid this situa-
tion, please incorporate a snubber circuit. Due to the many different types of load that can be driven, we can
merely recommend some circuit values to start with : Cs = 0.022 μ F and Rs = 47 Ω . The operation of the SSR
and snubber circuit should be tested and if unintentional switching occurs, please adjust the snubber circuit
component values accordingly
When making the transition from On to Off state, a snubber circuit should be used ensure that sudden drops
in current are not accompanied by large instantaneous changes in voltage across the Triac.
This fast change in voltage is brought about by the phase difference between current and voltage.
Primarily, this is experienced in driving loads which are inductive such as motors and solenods.
Following the procedure outlined above should provide suf ? cient results.
Any snubber or Varistor used for the above mentioned scenarios should be located as close to the main out-
put triac as possible.
All pins shall be used by soldering on the board. (Socket and others shall not be used.)
● Degradation
In general, the emission of the IRED used in SSR will degrade over time.
In the case where long term operation and / or constant extreme temperature ? uctuations will be applied to
the devices, please allow for a worst case scenario of 50% degradation over 5years.
Therefore in order to maintain proper operation, a design implementing these SSRs should provide at least
twice the minimum required triggering current from initial operation.
Sheet No.: D4-A03901EN
8
相关PDF资料 |
PDF描述 |
|---|---|
| PR36MF11NSZF | RELAY SSR 240VAC .6A TRIAC 8-DIP |
| PR36MF22NSZ | RELAY SSR 240VAC .6A ZC 8-DIP |
| PR39MF11NSZF | RELAY SSR 240VAC .9A TRIAC 8-DIP |
| PR39MF51NSZF | RELAY SSR 240V 0.9A 8-DIP |
| PR3BMF51NSKF | RELAY SSR 10MA 240V 1.2A 8-DIP |
相关代理商/技术参数 |
参数描述 |
|---|---|
| PR33MF51YIPF | 制造商:SHARP 制造商全称:Sharp Electrionic Components 功能描述:Non-Zero Cross type DIP 8pin Triac output SSR |
| PR33MF51YPLF | 制造商:Sharp Microelectronics Corporation 功能描述:PR33MF51YPLF - Tape and Reel 制造商:Sharp Microelectronics Corporation 功能描述:RELAY SSR 240V 制造商:Sharp Microelectronics Corporation 功能描述:Solid State Relay 8 Pin 600 Volt |
| PR33MF51YSZF | 制造商:SHARP 制造商全称:Sharp Electrionic Components 功能描述:Non-Zero Cross type DIP 8pin Triac output SSR |
| PR-33-REFLECTOR | 制造商:TE Connectivity 功能描述:9-1197714-8 |
| PR3400-25MQ160C | 制造商:未知厂家 制造商全称:未知厂家 功能描述:32-Bit Microprocessor |
发布紧急采购，3分钟左右您将得到回复。