- 您现在的位置：买卖IC网 > PDF目录7444 > PR36MF11NSZ (Sharp Microelectronics)RELAY SSR 240VAC .6A TRIAC 8-DIP PDF资料下载
参数资料
| 型号： | PR36MF11NSZ |
| 厂商： | Sharp Microelectronics |
| 文件页数： | 9/15页 |
| 文件大小： | 0K |
| 描述： | RELAY SSR 240VAC .6A TRIAC 8-DIP |
| 标准包装： | 50 |
| 系列： | PR36MF |
| 电路： | SPST-NO（1 Form A） |
| 输出类型： | AC |
| 负载电流： | 600mA |
| 输入电压： | 1.2VDC |
| 电压 - 负载： | 0 ~ 240 V |
| 安装类型： | 通孔 |
| 端接类型： | PC 引脚 |
| 封装/外壳： | 8-DIP（0.300"，7.62mm），7 引线 |
| 供应商设备封装： | 8-DIP |
| 包装： | 管件 |
| 继电器类型： | 继电器 |
| 其它名称： | 425-1196-5 |
PR26MF1xNSZ Series
PR36MF1xNSZ Series
■ Design Considerations
● Recommended Operating Conditions
Parameter
Symbol
Conditions
MIN.
MAX.
Unit
Input
Input signal current
at ON state
Rank 1
Rank 2
I F (ON)
?
20
10
25
15
mA
Input signal current at OFF state
I F (OFF)
?
0
0.1
mA
Load supply voltage
PR26MF1xNSZ
PR36MF1xNSZ
V OUT (rms)
?
?
120
240
V
Output
Load supply current
I OUT (rms)
Locate snubber circuit between output terminals
(Cs = 0.022 μ F, Rs = 47 ? )
?
I T (rms) × 80%( ? )
mA
Frequency
Operating temperature
f
T opr
?
?
50
? 20
60
80
Hz
?C
( ? ) See Fig.2 about derating curve (I T (rms) vs. ambient temperature).
● Design guide
In order for the SSR to turn off, the triggering current (I F ) must be 0.1mA or less.
In phase control applications or where the SSR is being by a pulse signal, please ensure that the pulse width
is a minimum of 1ms.
When the input current (I F ) is below 0.1mA, the output Triac will be in the open circuit mode. However, if the
voltage across the Triac, V D , increases faster than rated dV/dt, the Triac may turn on. To avoid this situation,
please incorporate a snubber circuit. Due to the many different types of load that can be driven, we can
merely recommend some circuit values to start with : Cs = 0.022 μ F and Rs = 47 ? . The operation of the SSR
and snubber circuit should be tested and if unintentional switching occurs, please adjust the snubber circuit
component values accordingly.
When making the transition from On to Off state, a snubber circuit should be used ensure that sudden drops
in current are not accompanied by large instantaneous changes in voltage across the Triac.
This fast change in voltage is brought about by the phase difference between current and voltage.
Primarily, this is experienced in driving loads which are inductive such as motors and solenods.
Following the procedure outlined above should provide sufficient results.
Any snubber or Varistor used for the above mentioned scenarios should be located as close to the main
output triac as possible.
All pins shall be used by soldering on the board. (Socket and others shall not be used.)
● Degradation
In general, the emission of the IRED used in SSR will degrade over time.
In the case where long term operation and / or constant extreme temperature fluctuations will be applied to
the devices, please allow for a worst case scenario of 50% degradation over 5years.
Therefore in order to maintain proper operation, a design implementing these SSRs should provide at least
twice the minimum required triggering current from initial operation.
Sheet No.: D4-A00401EN
9
相关PDF资料 |
PDF描述 |
|---|---|
| 2-1546561-0 | BARRIER STRIP 4CIRC VERT .438" |
| 1301470129 | COVER PLATE L7-20P W/MALE RCPT |
| 1546842-5 | CONN BARRIER BLOCK 5CIRC 9.53MM |
| 9-1546119-8 | CONN BARRIER BLOCK 7CIRC 8.26MM |
| 3M 1267 0.75"SQ-250 | ALUM FOIL TAPE 3/4" SQ 250/PACK |
相关代理商/技术参数 |
参数描述 |
|---|---|
| PR36MF11NSZF | 功能描述:固态继电器-PCB安装 8-DIP NON-ZC 10mA RoHS:否 制造商:Omron Electronics 控制电压范围: 负载电压额定值:40 V 负载电流额定值:120 mA 触点形式:1 Form A (SPST-NO) 输出设备:MOSFET 封装 / 箱体:USOP-4 安装风格:SMD/SMT |
| PR36MF11YSZF | 功能描述:固态继电器-PCB安装 8-DIP NON-ZC 10mA RoHS:否 制造商:Omron Electronics 控制电压范围: 负载电压额定值:40 V 负载电流额定值:120 mA 触点形式:1 Form A (SPST-NO) 输出设备:MOSFET 封装 / 箱体:USOP-4 安装风格:SMD/SMT |
| PR36MF12NSZ | 功能描述:RELAY SSR 240VAC .6A TRIAC 8-DIP RoHS:否 类别:继电器 >> 固态 系列:PR36MF 其它有关文件:AQx REACH Cert of Compliance 特色产品:AQY Series Relays 标准包装:1 系列:PhotoMOS™ AQY 电路:SPST-NO（1 Form A） 输出类型:AC，DC（RF） 导通状态电阻:1.25 欧姆 负载电流:250mA 输入电压:1.3VDC 电压 - 负载:0 ~ 40 V 安装类型:表面贴装 端接类型:SMD（SMT）接片 封装/外壳:4-SMD（0.175"，4.45mm） 供应商设备封装:4-SSOP 包装:Digi-Reel® 继电器类型:继电器 其它名称:255-2683-6 |
| PR36MF12NSZF | 功能描述:固态继电器-PCB安装 8-DIP NON-ZC 10mA RoHS:否 制造商:Omron Electronics 控制电压范围: 负载电压额定值:40 V 负载电流额定值:120 mA 触点形式:1 Form A (SPST-NO) 输出设备:MOSFET 封装 / 箱体:USOP-4 安装风格:SMD/SMT |
| PR36MF12YSZF | 功能描述:固态继电器-PCB安装 8-DIP NON-ZC 10mA RoHS:否 制造商:Omron Electronics 控制电压范围: 负载电压额定值:40 V 负载电流额定值:120 mA 触点形式:1 Form A (SPST-NO) 输出设备:MOSFET 封装 / 箱体:USOP-4 安装风格:SMD/SMT |
发布紧急采购，3分钟左右您将得到回复。