- 您现在的位置：买卖IC网 > PDF目录224796 > PS2801-1-V-F4 (California Eastern Laboratories) Power Resistor; Series:MK; Resistance:1Mohm; Resistance Tolerance:+/- 1 %; Power Rating:0.75W; Voltage Rating:400V; Temperature Coefficient:+/-50 ppm; Mounting Type:Through Hole; Operating Temp. Min:0 C; Terminal Type:Radial Leaded PDF资料下载
参数资料
| 型号： | PS2801-1-V-F4 |
| 厂商： | California Eastern Laboratories |
| 英文描述： | Power Resistor; Series:MK; Resistance:1Mohm; Resistance Tolerance:+/- 1 %; Power Rating:0.75W; Voltage Rating:400V; Temperature Coefficient:+/-50 ppm; Mounting Type:Through Hole; Operating Temp. Min:0 C; Terminal Type:Radial Leaded |
| 中文描述： | 高隔离电压SSOP封装光耦合器 |
| 文件页数： | 2/12页 |
| 文件大小： | 357K |
| 代理商： | PS2801-1-V-F4 |
NOTES ON HANDLING
1. Recommended soldering conditions
(1) Infrared reflow soldering
Peak reflow temperature
260
°C or below (package surface temperature)
Time of peak reflow temperature
10 seconds or less
Time of temperature higher than 220
°C
60 seconds or less
Time to preheat temperature from 120 to 180
°C
120
±30 s
Number of reflows
Three
Flux
Rosin flux containing small amount of chlorine (The flux with a
maximum chlorine content of 0.2 Wt% is recommended.)
120±30 s
(preheating)
220C
180C
Package
Surface
Temperature
T
(C)
Time (s)
Recommended Temperature Profile of Infrared Reflow
(heating)
to 10 s
to 60 s
260C MAX.
120C
(2) Wave soldering
Temperature
260
°C or below (molten solder temperature)
Time
10 seconds or less
Preheating conditions
120
°C or below (package surface temperature)
Number of times
One (Allowed to be dipped in solder including plastic mold portion.)
Flux
Rosin flux containing small amount of chlorine (The flux with a maximum chlorine
content of 0.2 Wt% is recommended.)
(3) Soldering by Soldering Iron
Peak Temperature (lead part temperature)
350
°C or below
Time (each pins)
3 seconds or less
Flux
Rosin flux containing small amount of chlorine (The flux with a
maximum chlorine content of 0.2 Wt% is recommended.)
(a) Soldering of leads should be made at the point 1.5 to 2.0 mm from the root of the lead
(b) Please be sure that the temperature of the package would not be heated over 100
°C
Data Sheet PN10398EJ02V0DS
10
PS2801A-1,PS2801A-4
相关PDF资料 |
PDF描述 |
|---|---|
| PS2801A-4-V-F4 | HIGH ISOLATION VOLTAGE SSOP PHOTOCOUPLER |
| PS2811-1-M | 1 CHANNEL TRANSISTOR OUTPUT OPTOCOUPLER |
| PS2861-1-L | 1 CHANNEL TRANSISTOR OUTPUT OPTOCOUPLER |
| PS2861H-1 | CONNECTOR ACCESSORY |
| PS710EL-1A-E4 | 6-PIN DIP, 0.08 ohm LOW ON-STATE RESISTANCE 2.0 A CONTINUOUS LOAD CURRENT 1-ch Optical Coupled MOS FET |
相关代理商/技术参数 |
参数描述 |
|---|---|
| PS2801-1-Y-A | 功能描述:晶体管输出光电耦合器 SNGL Tr DC Couplr RoHS:否 制造商:Vishay Semiconductors 输入类型:DC 最大集电极/发射极电压:70 V 最大集电极/发射极饱和电压:0.4 V 绝缘电压:5300 Vrms 电流传递比:100 % to 200 % 最大正向二极管电压:1.65 V 最大输入二极管电流:60 mA 最大集电极电流:100 mA 最大功率耗散:100 mW 最大工作温度:+ 110 C 最小工作温度:- 55 C 封装 / 箱体:DIP-4 封装:Bulk |
| PS28014 | 制造商:NEC Electronics Corporation 功能描述: 制造商: 功能描述: 制造商:undefined 功能描述: |
| PS2801-4 | 功能描述:晶体管输出光电耦合器 Hi-Iso Photo 4-Ch RoHS:否 制造商:Vishay Semiconductors 输入类型:DC 最大集电极/发射极电压:70 V 最大集电极/发射极饱和电压:0.4 V 绝缘电压:5300 Vrms 电流传递比:100 % to 200 % 最大正向二极管电压:1.65 V 最大输入二极管电流:60 mA 最大集电极电流:100 mA 最大功率耗散:100 mW 最大工作温度:+ 110 C 最小工作温度:- 55 C 封装 / 箱体:DIP-4 封装:Bulk |
| PS2801-4-A | 功能描述:晶体管输出光电耦合器 Hi-Iso Photo 4-Ch RoHS:否 制造商:Vishay Semiconductors 输入类型:DC 最大集电极/发射极电压:70 V 最大集电极/发射极饱和电压:0.4 V 绝缘电压:5300 Vrms 电流传递比:100 % to 200 % 最大正向二极管电压:1.65 V 最大输入二极管电流:60 mA 最大集电极电流:100 mA 最大功率耗散:100 mW 最大工作温度:+ 110 C 最小工作温度:- 55 C 封装 / 箱体:DIP-4 封装:Bulk |
| PS2801-4-F3 | 功能描述:晶体管输出光电耦合器 Hi-Iso Photo 4-Ch RoHS:否 制造商:Vishay Semiconductors 输入类型:DC 最大集电极/发射极电压:70 V 最大集电极/发射极饱和电压:0.4 V 绝缘电压:5300 Vrms 电流传递比:100 % to 200 % 最大正向二极管电压:1.65 V 最大输入二极管电流:60 mA 最大集电极电流:100 mA 最大功率耗散:100 mW 最大工作温度:+ 110 C 最小工作温度:- 55 C 封装 / 箱体:DIP-4 封装:Bulk |
发布紧急采购，3分钟左右您将得到回复。