- 您现在的位置：买卖IC网 > Datasheet目录500 > PT334-6C (Everlight Electronics Co Ltd)PHOTOTRANSISTOR 5MM CLEAR RAD Datasheet资料下载
参数资料
| 型号： | PT334-6C |
| 厂商： | Everlight Electronics Co Ltd |
| 文件页数： | 9/9页 |
| 文件大小： | 0K |
| 描述： | PHOTOTRANSISTOR 5MM CLEAR RAD |
| 标准包装： | 500 |
| 电压 - 集电极发射极击穿（最大）： | 30V |
| 电流 - 集电极 (Ic)（最大）： | 20mA |
| 电流 - 暗 (Id)（最大）： | 100nA |
| 波长： | 940nm |
| 安装类型： | 通孔 |
| 方向： | 顶视图 |
| 封装/外壳： | 径向，5mm 直径（T 1 3/4） |
| 其它名称： | 1080-1159 |
DATASHEET
5mm Phototransistor T-1 3/4
PT334-6C
Although the recommended soldering conditions are specified in the above table, dip or hand soldering at the lowest
possible temperature is desirable for the LEDs.
?
Wave soldering parameter must be set and maintain according to recommended temperature and dwell time in the solder
wave.
4.
Cleaning
?
?
When necessary, cleaning should occur only with isopropyl alcohol at room temperature for a duration of no more than
one minute. Dry at room temperature before use.
Do not clean the LEDs by the ultrasonic. When it is absolutely necessary, the influence of ultrasonic cleaning on the LEDs
depends on factors such as ultrasonic power and the assembled condition. Ultrasonic cleaning shall be pre-qualified to
ensure this will not cause damage to the LED
5.
Heat Management
?
?
Heat management of LEDs must be taken into consideration during the design stage of LED application. The current
should be de-rated appropriately by referring to the de-rating curve found in each product specification.
The temperature surrounding the LED in the application should be controlled. Please refer to the data sheet de-rating
curve.
6.
ESD (Electrostatic Discharge)
?
?
?
?
Electrostatic discharge (ESD) or surge current (EOS) can damage LEDs.
An ESD wrist strap, ESD shoe strap or antistatic gloves must be worn whenever handling LEDs.
All devices, equipment and machinery must be properly grounded.
Use ion blower to neutralize the static charge which might have built up on surface of the LEDs plastic lens as a result of
friction between LEDs during storage and handing.
7.
Other
?
?
?
Above specification may be changed without notice. EVERLIGHT will reserve authority on material change for above
specification.
When using this product, please observe the absolute maximum ratings and the instructions for using outlined in these
specification sheets. EVERLIGHT assumes no responsibility for any damage resulting from use of the product which does
not comply
with the absolute maximum ratings and the instructions included in these specification sheets.
These specification sheets include materials protected under copyright of EVERLIGHT corporation. Please don’t
reproduce or cause anyone to reproduce them without EVERLIGHT’s consent.
9
www.everlight.com
:2
Revision Copyright ?
LifecyclePhase:
Release
2010, Everlight All Rights Reserved. Release Date : MAY.28.2013. Issue No:DPT-0000185 Date:2013-06-04 09:42:55.0
Expired Period: Forever
相关PDF资料 |
PDF描述 |
|---|---|
| PT42-21B/TR8 | PHOTOTRANSISTOR 1.8MM RND BK SMD |
| PT4800E0000F | PHOTO TRANS CLEAR LEN 800NM SIDE |
| PT4800FE000F | PHOTO TRANS BLACK LEN 860NM SIDE |
| PT480E00000F | PHOTO TRANS CLEAR LEN 800NM SIDE |
| PT480FE0000F | PHOTO TRANS BLACK LEN 860NM SIDE |
相关代理商/技术参数 |
参数描述 |
|---|---|
| PT334-6C_05 | 制造商:EVERLIGHT 制造商全称:Everlight Electronics Co., Ltd 功能描述:5mm Phototransistor T-1 3/4 |
| PT334-6C_09 | 制造商:EVERLIGHT 制造商全称:Everlight Electronics Co., Ltd 功能描述:5mm Phototransistor T-1 3/4 |
| PT33A0803ST69 | 制造商:ITT Interconnect Solutions 功能描述:CONN RCPT 3POS WALL MNT SKT |
| PT33A08-03ST69 | 制造商:ITT Interconnect Solutions 功能描述:Conn MIL-C-26482 Circular SKT 3 POS Solder ST Wall Mount 3 Terminal 1 Port |
| PT33A0804P | 制造商:ITT Interconnect Solutions 功能描述:CONN RCPT 4POS WALL MNT PIN |
发布紧急采购，3分钟左右您将得到回复。