参数资料
型号: PT6101N
厂商: TEXAS INSTRUMENTS INC
元件分类: 稳压器
英文描述: 1 A SWITCHING REGULATOR, 600 kHz SWITCHING FREQ-MAX, SMA12
封装: ROHS COMPLIANT, VERTICAL MOUNT PACKAGE-12
文件页数: 3/8页
文件大小: 586K
代理商: PT6101N
Application Notes
For technical support and more information, see inside back cover or visit www.ti.com/powertrends
PT6100/6210/6300 Series
Adjusting the Output Voltage of Power Trends’
Wide Input Range Bus ISRs
The output voltage of the Power Trends’ Wide Input
Range Series ISRs may be adjusted higher or lower than the
factory trimmed pre-set voltage with the addition of a single
external resistor. Table 1 accordingly gives the allowable
adjustment range for each model for either series as V
a (min)
and V
a (max).
Adjust Up:
An increase in the output voltage is obtained by
adding a resistor R2, between pin 12 (Vo adjust) and pins 5-8
(GND).
Adjust Down:
Add a resistor (R1), between pin 12 (Vo adjust)
and pins 9-11(Vout).
Refer to Figure 1 and Table 2 for both the placement and value
of the required resistor; either (R1) or R2 as appropriate.
Notes:
1. Use only a single 1% resistor in either the (R1) or R2
location. Place the resistor as close to the ISR as possible.
2. Never connect capacitors from V
o adjust to either GND or
V
out. Any capacitance added to the Vo adjust pin will affect
the stability of the ISR.
3. Adjustments to the output voltage may place additional
limits on the maximum and minimum input voltage for the
part. The revised maximum and minimum input voltage
limits must comply with the following requirements. Note
that the minimum input voltage limits are also model
dependant.
V
in (max)
= (8 x V
a)V or
*30/38V,
whichever is less.
*Limit is 30V when inhibit function is active.
PT6x0x/PT6x1x series:
V
in (min)
= (V
a + 4)V or 9V,
whichever is greater.
PT6x2x series:
V
o <10V;
V
in (min)
= (V
a + 2.0)V or 7.0V,
whichever is greater.
V
o
≥10V;
V
in (min)
= (V
a + 2.5)V
Figure 1
The values of (R1) [adjust down], and R2 [adjust up], can
also be calculated using the following formulae.
Ro (Va – 1.25)
(R1)
=
Vo – Va
k
1.25 Ro
k
R2
=
Va – Vo
Where: V
o
= Original output voltage
V
a
= Adjusted output voltage
R
o
= The resistance value fromTable 1
Table 1
ISR ADJUSTMENT RANGE AND FORMULA PARAMETERS
1Adc Rated
PT6102
PT6101
PT6103
2Adc Rated
PT6213
PT6212
PT6214
3Adc Rated
PT6303
PT6302
PT6304
Vo (nom)
3.3
5.0
12.0
Va (min)
1.89
1.88
2.18
2.43
Va (max)
6.07
11.25
8.5
22.12
Ro (k
)
66.5
150.0
90.9
243.0
R2
Adjust
Up
C1
1
F Ceramic
(Optional)
C2
100
F
(Req’d)
Vo
COM
Vin
+
(R1)
Adj Down
PT6100/6200/6300
9,10,11
12
5,6,7,8
2,3,4
Vin
Vo
G N D
Vo(adj)
相关PDF资料
PDF描述
PT6102N 1 A SWITCHING REGULATOR, 600 kHz SWITCHING FREQ-MAX, SMA12
PT6103A 1 A SWITCHING REGULATOR, 600 kHz SWITCHING FREQ-MAX, SMA12
PT6101G 1 A SWITCHING REGULATOR, 600 kHz SWITCHING FREQ-MAX, SMA12
PT6103R 1 A SWITCHING REGULATOR, 600 kHz SWITCHING FREQ-MAX, SMA12
PT6103S 1 A SWITCHING REGULATOR, 600 kHz SWITCHING FREQ-MAX, SMA12
相关代理商/技术参数
参数描述
PT6101R 功能描述:开关变换器、稳压器与控制器 5Vout 1A Wide Input Adj Step-Down ISR RoHS:否 制造商:Texas Instruments 输出电压:1.2 V to 10 V 输出电流:300 mA 输出功率: 输入电压:3 V to 17 V 开关频率:1 MHz 工作温度范围: 安装风格:SMD/SMT 封装 / 箱体:WSON-8 封装:Reel
PT6101S 制造商:TI 制造商全称:Texas Instruments 功能描述:1 Amp Adjustable Positive Step-down Integrated Switching Regulator
PT6102 制造商:TI 制造商全称:Texas Instruments 功能描述:1 AMP ADJUSTABLE POSITIVE STEP-DOWN INTEGRATED SWITCHING REGULATOR
PT61020EL 功能描述:固定电感器 350uHmin. .50uHmax. OP -40C to +85C RoHS:否 制造商:AVX 电感:10 uH 容差:20 % 最大直流电流:1 A 最大直流电阻:0.075 Ohms 工作温度范围:- 40 C to + 85 C 自谐振频率:38 MHz Q 最小值:40 尺寸:4.45 mm W x 6.6 mm L x 2.92 mm H 屏蔽:Shielded 端接类型:SMD/SMT 封装 / 箱体:6.6 mm x 4.45 mm
PT61020L 功能描述:固定电感器 BASE T TRANS RoHS:否 制造商:AVX 电感:10 uH 容差:20 % 最大直流电流:1 A 最大直流电阻:0.075 Ohms 工作温度范围:- 40 C to + 85 C 自谐振频率:38 MHz Q 最小值:40 尺寸:4.45 mm W x 6.6 mm L x 2.92 mm H 屏蔽:Shielded 端接类型:SMD/SMT 封装 / 箱体:6.6 mm x 4.45 mm