- 您现在的位置：买卖IC网 > PDF目录66046 > PT6302CT (TEXAS INSTRUMENTS INC) 3 A SWITCHING REGULATOR, 600 kHz SWITCHING FREQ-MAX, SMA12 PDF资料下载
参数资料
| 型号： | PT6302CT |
| 厂商： | TEXAS INSTRUMENTS INC |
| 元件分类： | 稳压器 |
| 英文描述： | 3 A SWITCHING REGULATOR, 600 kHz SWITCHING FREQ-MAX, SMA12 |
| 封装： | ROHS COMPLIANT, HORIZONTAL SURFACE MOUNT PACKAGE-12 |
| 文件页数： | 5/8页 |
| 文件大小： | 190K |
| 代理商： | PT6302CT |
Application Notes
For technical support and more information, see inside back cover or visit www.ti.com/powertrends
Using the Inhibit Function on Power Trends’
Wide Input Range Bus ISRs
For applications requiring output voltage On/Off control,
the 12pin ISR products incorporate an inhibit function.
The function has uses in areas such as battery conservation,
power-up sequencing, or any other application where the
regulated output from the module is required to be
switched off. The On/Off function is provided by the
Pin 1 (Inhibit) control.
The ISR functions normally with Pin 1 open-circuit,
providing a regulated output whenever a valid source
voltage is applied to V
in, (pins 2, 3, & 4). When a low-
level2 ground signal is applied to Pin 1, the regulator
output will be disabled.
Figure 1 shows an application schematic, which details
the typical use of the Inhibit function. Note the discrete
transistor (Q1). The Inhibit control has its own internal
pull-up with a maximum open-circuit voltage of 8.3VDC.
Only devices with a true open-collector or open-drain
output can be used to control this pin. A discrete bipolar
transistor or MOSFET is recommended.
Equation 1 may be used to determine the approximate
current drawn by Q1 when the inhibit is active.
Equation 1
Istby
=Vin ÷ 155k
± 20%
Notes:
1. The Inhibit control logic is similar for all Power Trends’
modules, but the flexibility and threshold tolerances will be
different. For specific information on the inhibit function
of other ISR models, consult the applicable application
note.
2. Use only a true open-collector device (preferably a discrete
transistor) for the Inhibit input. Do Not use a pull-up
resistor, or drive the input directly from the output of a
TTL or other logic gate. To disable the output voltage,
the control pin should be pulled low to less than +1.5VDC.
3. When the Inhibit control pin is active, i.e. pulled low, the
maximum allowed input voltage is limited to +30Vdc.
4. Do not control the Inhibit input with an external DC
voltage. This will lead to erratic operation of the ISR and
may over-stress the regulator.
5. Avoid capacitance greater than 500pF at the Inhibit control
pin. Excessive capacitance at this pin will cause the ISR to
produce a pulse on the output voltage bus at turn-on.
6. Keep the On/Off transition to less than 10
s. This
prevents erratic operation of the ISR, which can cause a
momentary high output voltage.
C2
100
F
+
C1, 1
F
(Optional)
V
out
COM
V
in
COM
Inh
Q1
BSS138
PT6100/6210/6300
9,10,11
12
5,6,7,8
2,3,4
Vin
V o
G N D
Vo(adj)
1
Inh*
Figure 1
Turn-On Time:
The output of the ISR is enabled automatically
when external power is applied to the input. The Inhibit control
pin is pulled high by its internal pull-up resistor. The ISR
produces a fully regulated output voltage within 1-msec of
either the release of the Inhibit control pin, or the application
of power. The actual turn-on time will vary with the input
voltage, output load, and the total amount of capacitance con-
nected to the output Using the circuit of Figure 1, Figure 2
shows the typical rise in output voltage for the PT6101
following the turn-off of Q1 at time t =0. The waveform was
measured with a 9Vdc input voltage, and 5-Ohm resistive load.
Figure 2
0
1
2
3
4
5
6
-0.2
0
0.2
0.4
0.6
0.8
1
t (milli-secs)
V
o
(V
d
c
)
PT6100/6210/6300 Series
相关PDF资料 |
PDF描述 |
|---|---|
| PT6302G | 3 A SWITCHING REGULATOR, 600 kHz SWITCHING FREQ-MAX, SMA12 |
| PT6304R | 1-OUTPUT DC-DC REG PWR SUPPLY MODULE |
| PT6303G | 1-OUTPUT DC-DC REG PWR SUPPLY MODULE |
| PT6302J | 3 A SWITCHING REGULATOR, 600 kHz SWITCHING FREQ-MAX, SMA12 |
| PT6302R | 3 A SWITCHING REGULATOR, 600 kHz SWITCHING FREQ-MAX, SMA12 |
相关代理商/技术参数 |
参数描述 |
|---|---|
| PT6302G | 功能描述:DC/DC转换器 5Vout 3A Wide Input Adj Step-Down ISR RoHS:否 制造商:Murata 产品: 输出功率: 输入电压范围:3.6 V to 5.5 V 输入电压（标称）: 输出端数量:1 输出电压（通道 1）:3.3 V 输出电流（通道 1）:600 mA 输出电压（通道 2）: 输出电流（通道 2）: 安装风格:SMD/SMT 封装 / 箱体尺寸: |
| PT6302H | 制造商:TI 制造商全称:Texas Instruments 功能描述:3 AMP ADJUSTABLE POSITIVE STEP-DOWN INTEGRATED SWITCHING REGULATORS |
| PT6302J | 制造商:TI 制造商全称:Texas Instruments 功能描述:3 AMP ADJUSTABLE POSITIVE STEP-DOWN INTEGRATED SWITCHING REGULATORS |
| PT6302LQ-001 | 制造商:PTC 制造商全称:Princeton Technology Corp 功能描述:VFD Driver/Controller IC with Character RAM |
| PT6302LQ-002 | 制造商:PTC 制造商全称:Princeton Technology Corp 功能描述:VFD Driver/Controller IC with Character RAM |
发布紧急采购，3分钟左右您将得到回复。