参数资料
型号: PT6515H
厂商: TEXAS INSTRUMENTS INC
元件分类: 稳压器
英文描述: 8 A SWITCHING REGULATOR, 725 kHz SWITCHING FREQ-MAX, SMA14
文件页数: 11/11页
文件大小: 222K
代理商: PT6515H
Application Notes
For technical support or further information, visit http://power.ti.com
PT6510 Series
Adjusting the Output Voltage of the
PT6510 5V/3.3V Bus Converters
The output voltage of the PT6510 series switching regula-
tors may be adjusted higher or lower than the factory
trimmed pre-set voltage with the addition of a single
external resistor. Table 4-1 gives the allowable adjust-
ment range for each model in the series as Va (min) and
Va (max).
Adjust Up:
An increase in the output voltage is obtained
by adding a resistor R2, between Vo Adjust (pin 14) and
GND (pins 7-10).
Adjust Down:
Add a resistor (R1), between Vo Adjust
(pin 14) and Vout (pins 11-13).
Refer to Figure 4-1 and Table 4-2 for both the placement and
value of the required resistor, either (R1) or R2 as appropriate.
Notes:
1. Use only a single 1 % resistor in either the (R1) or R2
location. Place the resistor as close to the ISR as
possible.
2. Never connect capacitors from Vo Adjust to either
GND, Vout, or the Vo Sense pin. Any capacitance
added to the Vo Adjust pin will affect the stability of
the ISR.
3. If the remote sense feature is used, connecting the
resistor (R1) between Vo Adjust (pin 14) and Vo Sense
(pin 1) can benefit load regulation.
4. The minimum input voltage required by the part is
Vout + 1.2 or Vin(min) from Table 4-1, whichever is
higher.
Figure 4-1
The values of (R
1) [adjust down], and R2 [adjust up], can
also be calculated using the following formulae.
Ro (Va – 1.0)
(R1)
=
(Vo – Va)
– Rs k
Ro
– Rs
k
R2
=
Va - Vo
Where: Vo = Original output voltage
Va = Adjusted output voltage
Ro = The resistance value in Table 4-1
Rs = The series resistance from Table 4-1
Table 4-1
PT6510 ADJUSTMENT AND FORMULA PARAMETERS
Series Pt #
PT6515
PT6512
PT6516
PT6513
PT6511
PT6514
Vo (nom)
1.2
1.5
1.8
2.5
3.3
3.6
Va (min)
1.14
1.27
1.4
1.8
2.25
2.5
Va (max)
2.35
2.65
2.95
3.5
4.2
4.3
Ro (k
)
2.49
4.99
12.1
10
Rs (k
)
2
4.22
12.1
Vin(min)
3.1
4.5
C
in
+
C
out
+
(R1)
Adj Down
R2
Adjust Up
V
out
COM
Vin
COM
PT6510
11–13
14
7–10
4–6
V
in
V
out
GND
V
o(adj)
STBY
3
V
o(Sense)
1
L
O
A
D
相关PDF资料
PDF描述
PT6514A 8 A SWITCHING REGULATOR, 725 kHz SWITCHING FREQ-MAX, SMA14
PT6513A 8 A SWITCHING REGULATOR, 725 kHz SWITCHING FREQ-MAX, PSMA14
PT6514R 8 A SWITCHING REGULATOR, 725 kHz SWITCHING FREQ-MAX, SMA14
PT6515G 8 A SWITCHING REGULATOR, 725 kHz SWITCHING FREQ-MAX, SMA14
PT6514H 8 A SWITCHING REGULATOR, 725 kHz SWITCHING FREQ-MAX, SMA14
相关代理商/技术参数
参数描述
PT6515N 功能描述:REG 1.2V 8A 14SIP VERT RoHS:否 类别:电源 - 板载 >> DC DC Converters 系列:PT6510 设计资源:VI-200, VI-J00 Design Guide, Appl Manual 标准包装:1 系列:* 类型:隔离 输出数:1 电压 - 输入(最小):55V 电压 - 输入(最大):100V Voltage - Output 1:15V Voltage - Output 2:- Voltage - Output 3:- 电流 - 输出(最大):* 电源(瓦) - 制造商系列:200W 电压 - 隔离:* 特点:* 安装类型:通孔 封装/外壳:9-FinMod 尺寸/尺寸:4.60" L x 1.86" W x 0.79" H(116.8mm x 47.2mm x 20.1mm) 包装:散装 工作温度:-55°C ~ 85°C 效率:* 电源(瓦特)- 最大:*
PT6516 制造商:TI 制造商全称:Texas Instruments 功能描述:8-A 5-V/3.3-V Input Adjustable ISR with Short-Circuit protection
PT6516A 功能描述:REG 1.8V 8A 14SIP HORZ RoHS:否 类别:电源 - 板载 >> DC DC Converters 系列:PT6510 设计资源:VI-200, VI-J00 Design Guide, Appl Manual 标准包装:1 系列:* 类型:隔离 输出数:1 电压 - 输入(最小):55V 电压 - 输入(最大):100V Voltage - Output 1:15V Voltage - Output 2:- Voltage - Output 3:- 电流 - 输出(最大):* 电源(瓦) - 制造商系列:200W 电压 - 隔离:* 特点:* 安装类型:通孔 封装/外壳:9-FinMod 尺寸/尺寸:4.60" L x 1.86" W x 0.79" H(116.8mm x 47.2mm x 20.1mm) 包装:散装 工作温度:-55°C ~ 85°C 效率:* 电源(瓦特)- 最大:*
PT6516B 功能描述:REG 1.8V 8A 14SIP SMD SIDE TAB RoHS:否 类别:电源 - 板载 >> DC DC Converters 系列:PT6510 设计资源:VI-200, VI-J00 Design Guide, Appl Manual 标准包装:1 系列:* 类型:隔离 输出数:1 电压 - 输入(最小):55V 电压 - 输入(最大):100V Voltage - Output 1:15V Voltage - Output 2:- Voltage - Output 3:- 电流 - 输出(最大):* 电源(瓦) - 制造商系列:200W 电压 - 隔离:* 特点:* 安装类型:通孔 封装/外壳:9-FinMod 尺寸/尺寸:4.60" L x 1.86" W x 0.79" H(116.8mm x 47.2mm x 20.1mm) 包装:散装 工作温度:-55°C ~ 85°C 效率:* 电源(瓦特)- 最大:*
PT6516C 功能描述:REG 1.8V 8A 14SIP SMD RoHS:否 类别:电源 - 板载 >> DC DC Converters 系列:PT6510 设计资源:VI-200, VI-J00 Design Guide, Appl Manual 标准包装:1 系列:* 类型:隔离 输出数:1 电压 - 输入(最小):55V 电压 - 输入(最大):100V Voltage - Output 1:15V Voltage - Output 2:- Voltage - Output 3:- 电流 - 输出(最大):* 电源(瓦) - 制造商系列:200W 电压 - 隔离:* 特点:* 安装类型:通孔 封装/外壳:9-FinMod 尺寸/尺寸:4.60" L x 1.86" W x 0.79" H(116.8mm x 47.2mm x 20.1mm) 包装:散装 工作温度:-55°C ~ 85°C 效率:* 电源(瓦特)- 最大:*