- 您现在的位置：买卖IC网 > PDF目录66051 > PT6601M (TEXAS INSTRUMENTS INC) 9 A SWITCHING REGULATOR, 725 kHz SWITCHING FREQ-MAX, SMA14 PDF资料下载
参数资料
| 型号： | PT6601M |
| 厂商： | TEXAS INSTRUMENTS INC |
| 元件分类： | 稳压器 |
| 英文描述： | 9 A SWITCHING REGULATOR, 725 kHz SWITCHING FREQ-MAX, SMA14 |
| 封装： | ROHS COMPLIANT, SIP-14 |
| 文件页数： | 5/9页 |
| 文件大小： | 146K |
| 代理商： | PT6601M |
Application Notes
For technical support and more information, see inside back cover or visit www.ti.com/powertrends
PT6600 Series
Using the Standby Function on the
PT6600 5V Bus Converters
For applications requiring output voltage On/Off control,
the 14-pin PT6600 ISR series incorporates a standby
function. This function may be used in applications that
require power-up/shutdown sequencing, and wherever
there is a requirement for the output status of the module
to be controlled by external circuitry.
The standby function is provided by the STBY* control,
pin 3. If pin 3 is left open-circuit the regulator operates
normally, and provides a regulated output when a valid
supply voltage is applied to V
in (pins 4, 5, & 6) with re-
spect to GND (pins 7-10). If a low voltage2 is then
applied to pin-3 the regulator output will be disabled and
the input current drawn by the ISR will drop to less than
50mA4. The standby control may also be used to hold-off
the regulator output during the period that input power is
applied.
The standby control pin is ideally controlled using an
open-collector (or open-drain) discrete transistor (See
Figure 1). It may also be driven directly from a dedicated
TTL3 compatible gate. Table 1 provides details of the
threshold requirements.
Table 1 Inhibit Control Thresholds (2,3)
Parameter
Min
Max
Enable (VIH)
1V
5V
Disable (VIL)
–0.1V
0.35V
Notes:
1. The Standby/Inhibit control logic is similar for all Power
Trends’ modules, but the flexibility and threshold
tolerances will be different. For specific information on
this function for other regulator models, consult the
applicable application note.
2. The Standby control pin is ideally controlled using an
open-collector (or open-drain) discrete transistor and
requires no external pull-up resistor. The control input has
an open-circuit voltage of about 1Vdc. To disable the
regulator output, the control pin must be pulled to less
than 0.35Vdc with a low-level 0.5mA sink to ground.
3. The Standby input on the PT6600 series may be driven by
a differential output device, making it compatible with
TTL logic. A standard TTL logic gate will meet the
0.35V V
IL(max) requirement (Table 1 ) at 0.5mA IOL.
Do not use devices that can drive the Standby control input
above 5Vdc.
4. When the regulator output is disabled the current drawn
from the input source is reduced to approximately 30–
40mA (50mA maximum).
Figure 1
Turn-On Time:
In the circuit of Figure 1, turning Q
1 on applies a
low voltage to the Standby control (pin 3) and disables the
regulator ouput. Correspondingly, turning Q
1 off releases the
low-voltage signal and enables the output. The PT6600 ISR
series regulators have a fast response and will provide a fully
regulated output voltage within 250
sec. The actual turn-on
time will vary with load and the total amount of output capaci-
tance. The waveform of Figure 2 shows the typical output
voltage response of a PT6601 (3.3V) following the turn-off of
Q
1 at time t = 0.0 secs. The waveform was measured with a
5Vdc input voltage, and 0.6
load.
Figure 2
C
in
+
C
out
+
Inhibit
V
in
V
o
COM
PT6600
11,12,13
14
7,8,9,10
4,5,6
Vin
Vo
G N D
Vo(adj)
STBY
3
Vo(sense)
1
Q1
BSS138
+5V V
in
-50
0
50
100
150
200
250
300
350
t (
s )
Vo (2V / Div)
相关PDF资料 |
PDF描述 |
|---|---|
| PT6603E | 9 A SWITCHING REGULATOR, 725 kHz SWITCHING FREQ-MAX, PSMA14 |
| PT6606L | 9 A SWITCHING REGULATOR, 725 kHz SWITCHING FREQ-MAX, PSMA14 |
| PT6605B | 9 A SWITCHING REGULATOR, 725 kHz SWITCHING FREQ-MAX, PSMA14 |
| PT6605R | 9 A SWITCHING REGULATOR, 725 kHz SWITCHING FREQ-MAX, PSMA14 |
| PT6601R | 9 A SWITCHING REGULATOR, 725 kHz SWITCHING FREQ-MAX, PSMA14 |
相关代理商/技术参数 |
参数描述 |
|---|---|
| PT6601P | 功能描述:DC/DC转换器 10A 5V Input Non-Iso Wide Adjust Mod RoHS:否 制造商:Murata 产品: 输出功率: 输入电压范围:3.6 V to 5.5 V 输入电压（标称）: 输出端数量:1 输出电压（通道 1）:3.3 V 输出电流（通道 1）:600 mA 输出电压（通道 2）: 输出电流（通道 2）: 安装风格:SMD/SMT 封装 / 箱体尺寸: |
| PT6601Q | 功能描述:REGULATOR 3.3V 8A SIP CUST TH RoHS:否 类别:电源 - 板载 >> DC DC Converters 系列:PT6600 标准包装:10 系列:PT4570 类型:隔离 输出数:1 电压 - 输入（最小）:36V 电压 - 输入（最大）:75V Voltage - Output 1:9V Voltage - Output 2:- Voltage - Output 3:- 电流 - 输出（最大）:3.3A 电源（瓦） - 制造商系列:30W 电压 - 隔离:1.5kV（1500V） 特点:- 安装类型:表面贴装 封装/外壳:19-SIP SMD 模块 尺寸/尺寸:3.00" L x 1.19" W x 0.50" H（76.2mm x 30.2mm x 12.7mm） 包装:托盘 工作温度:-40°C ~ 85°C 效率:84% 电源（瓦特）- 最大:30W |
| PT6601R | 功能描述:开关变换器、稳压器与控制器 3.3Vout 9A 5V-Inp Adj ISR RoHS:否 制造商:Texas Instruments 输出电压:1.2 V to 10 V 输出电流:300 mA 输出功率: 输入电压:3 V to 17 V 开关频率:1 MHz 工作温度范围: 安装风格:SMD/SMT 封装 / 箱体:WSON-8 封装:Reel |
| PT6601S | 功能描述:REGULATOR 3.3V 7/9A 14SIP W/TABS RoHS:否 类别:电源 - 板载 >> DC DC Converters 系列:PT6600 标准包装:10 系列:PT4570 类型:隔离 输出数:1 电压 - 输入（最小）:36V 电压 - 输入（最大）:75V Voltage - Output 1:9V Voltage - Output 2:- Voltage - Output 3:- 电流 - 输出（最大）:3.3A 电源（瓦） - 制造商系列:30W 电压 - 隔离:1.5kV（1500V） 特点:- 安装类型:表面贴装 封装/外壳:19-SIP SMD 模块 尺寸/尺寸:3.00" L x 1.19" W x 0.50" H（76.2mm x 30.2mm x 12.7mm） 包装:托盘 工作温度:-40°C ~ 85°C 效率:84% 电源（瓦特）- 最大:30W |
| PT6602 | 制造商:TI 制造商全称:Texas Instruments 功能描述:9 AMP ADJUSTABLE INTEGRATED SWITCHING REGULATOR |
发布紧急采购，3分钟左右您将得到回复。