参数资料
型号: PT6729N
厂商: TEXAS INSTRUMENTS INC
元件分类: 稳压器
英文描述: 13 A SWITCHING REGULATOR, 400 kHz SWITCHING FREQ-MAX, SMA17
封装: VERTICAL MOUNT PACKAGE-17
文件页数: 5/9页
文件大小: 217K
代理商: PT6729N
For technical support and more information, see inside back cover or visit www.ti.com
Application Notes
Using the Standby Function of the PT6725
Series of Integrated Switching Regulators
The PT6725 series of power modules are high efficiency
regulators that operate off a +12V input bus voltage.
These regulators incorporate an on/off ‘Standby’ func-
tion, which may be used to disable the regulator output.
The standby function is provided by the STBY* control,
pin 2. If pin 2 is left open-circuit the regulator operates
normally, and provides a regulated output when a valid
supply voltage is applied to Vin (pins 4–6) with respect to
GND (pins 8–12). If a low voltage 3 is then applied to
pin 2 the regulator output will be disabled and the input
current drawn by the ISR will be reduced to 0.5mA 1.
The standby control may also be used to hold-off the
regulator output during the period that input power is
applied.
Pin 2 is ideally controlled with an open-collector (or
open-drain) discrete transistor (See Figure 1). The open-
circuit voltage is typcially the input voltage Vin. Table 1
gives the circuit parameters for this control input.
Table 1 Standby Control Requirements (2, 3)
Parameter
Min
Typ
Max
Input Low (VIL)
–0.1V
+0.4V
Istby (pin 2 =ground)
–0.5mA
Vstby (open circuit)
Vin
Notes:
1. When the regulator output is disabled the current drawn
from the +Vin input source is typically reduced to 0.5mA.
2 The standby control input requires no external pull-up
resistor. The open-circuit voltage of the STBY* pin is
approximately th input voltage Vin (+12V).
3. The standby control input is Not compatible with TTL
devices that incorporate a totem-pole output drive. Use
only a true open-collector device, preferably a discrete
bipolar transistor (or MOSFET). To ensure the regulator
output is disabled, the control pin must be pulled to less
than 0.4Vdc with a low-level 0.5mA sink to ground.
4. After Q1 in Figure 1 is turned off and before the output
begins to rise, the regulator output will assert a low
impedance to ground. If an external voltage is applied to
the output it will sink current and possibly over-stress the
part.
Figure 1
Turn-On Time:
In the circuit of Figure 1, turning Q1 on
applies a low voltage to the STBY control (pin 2) and
disables the regulator ouput. Correspondingly, turning
Q1 off removes the low-voltage signal and enables the
output. Once enabled, the output will typically experience
a 10–15ms delay followed by a predictable ramp-up of
voltage. The regulator should provide a fully regulated
output voltage within 30ms. Figure 2 shows the output
voltage response, Vo, of a PT6726 (2.5V) following the
turn-off of Q1. The turn-off of Q1 corresponds to the
rise in Vstby. The waveform was measured with a 12Vdc
input voltage, and 9.3ADC resistive load.
Figure 2
PT6725
Sense(+)
Sense(–)
V
OUT
GND
Vo(adj)
V
IN
STBY*
13–16
17
7
1
8–12
4–6
2
C
OUT
+
C
IN
+
STBY
+V
in
GND
V
out
Q1
BSS138
PT6725 Series
Vo (1V/Div)
Vstby (10V/Div)
HORIZ SCALE: 5ms/Div
相关PDF资料
PDF描述
PT6903A 6 A SWITCHING REGULATOR, 600 kHz SWITCHING FREQ-MAX, SMA23
PT6901N 6 A SWITCHING REGULATOR, 600 kHz SWITCHING FREQ-MAX, SMA23
PT6903C 6 A SWITCHING REGULATOR, 600 kHz SWITCHING FREQ-MAX, SMA23
PT6904N 5 A SWITCHING REGULATOR, 600 kHz SWITCHING FREQ-MAX, SMA23
PT6902C 3.5 A SWITCHING REGULATOR, 600 kHz SWITCHING FREQ-MAX, SMA23
相关代理商/技术参数
参数描述
PT68 制造商:HOFFMAN ENCLOSURES 功能描述:TOP, SOLID;FITS 600X800MM;STEEL;LTGRAY
P-T68 制造商:Pentair Technical Products / Hoffman 功能描述:Solid Top 600x800mm ;RoHS Compliant: Yes
PT6801B 制造商:Texas Instruments 功能描述:- Trays
PT6880 制造商:PTC 制造商全称:Princeton Technology Corp 功能描述:OLED Driver/Controller IC
PT6881 制造商:TI 制造商全称:Texas Instruments 功能描述:5-A, 15-36-V Input Integrated Switching Regulator