- 您现在的位置：买卖IC网 > PDF目录98064 > PTEA420033N2AD (TEXAS INSTRUMENTS INC) 1-OUTPUT 66 W DC-DC REG PWR SUPPLY MODULE PDF资料下载
参数资料
| 型号： | PTEA420033N2AD |
| 厂商： | TEXAS INSTRUMENTS INC |
| 元件分类： | 电源模块 |
| 英文描述： | 1-OUTPUT 66 W DC-DC REG PWR SUPPLY MODULE |
| 封装： | PLASTIC, DIP-8 |
| 文件页数： | 15/16页 |
| 文件大小： | 333K |
| 代理商： | PTEA420033N2AD |
SLTS288C – JUNE 2007 – REVISED OCTOBER 2010
www.ti.com
APPLICATION INFORMATION
Operating Features and System Considerations for the PTEA Series of DC/DC Converters
Overcurrent Protection
To protect against load faults, these converters incorporate output overcurrent protection. Applying a load to the
output that exceeds the converter's overcurrent threshold (see applicable specification) will cause the output
voltage to momentarily fold back, and then shut down. Following shutdown the module will periodically attempt to
automatically recover by initiating a soft-start power-up. This is often described as a hiccup mode of operation,
whereby the module continues in the cycle of successive shutdown and power up until the load fault is removed.
Once the fault is removed, the converter automatically recovers and returns to normal operation.
Output Overvoltage Protection
Each converter incorporates protection circuitry that continually senses for an output overvoltage (OV) condition.
The OV threshold is set approximately 20% higher than the nominal output voltage. If the converter output
voltage exceeds this threshold, the converter is immediately shut down and remains in a latched-off state. To
resume normal operation the converter must be actively reset. This can only be done by momentarily removing
the input power to the converter. For fail-safe operation and redundancy, the OV protection uses circuitry that is
independent of the converter’s internal feedback loop.
Overtemperature Protection
Overtemperature protection is provided by an internal temperature sensor, which closely monitors the
temperature of the converter’s printed circuit board (PCB). If the sensor exceeds a temperature of approximately
105°C, the converter will shut down. The converter will then automatically restart when the sensed temperature
drops back to approximately 95°C. When operated outside its recommended thermal derating envelope (see
data sheet SOA curves), the converter will typcially cycle on and off at intervals from a few seconds to one or two
minutes. This is to ensure that the internal components are not permanently damaged from excessive thermal
stress.
Undervoltage Lockout
The Undervoltage lockout (UVLO) is designed to prevent the operation of the converter until the input voltage is
at the minimum input voltage. This prevents high start-up current during normal power-up of the converter, and
minimizes the current drain from the input source during low input voltage conditions. The UVLO circuitry also
overrides the operation of the Remote On/Off control.
Primary-Secondary Isolation
These converters incorporate electrical isolation between the input terminals (primary) and the output terminals
(secondary). All converters are production tested to a withstand voltage of 1500 VDC. This specification complies
with UL60950 and EN60950 requirements. This allows the converter to be configured for either a positive or
negative input voltage source. The data sheet Pin Descriptions section provides guidance as to the correct
reference that must be used for the external control signals.
Input Current Limiting
The converter is not internally fused. For safety and overall system protection, the maximum input current to the
converter must be limited. Active or passive current limiting can be used. Passive current limiting can be a fast
acting fuse. A 125-V fuse, rated no more than 10 A, is recommended. Active current limiting can be implemented
with a current limited Hot-Swap controller.
Thermal Considerations
Airflow may be necessary to ensure that the module can supply the desired load current in environments with
elevated ambient temperatures. The required airflow rate may be determined from the Safe Operating Area
(SOA) thermal derating chart (see typical characteristics).
8
Copyright 2007–2010, Texas Instruments Incorporated
Product Folder Link(s): PTEA420025 PTEA420033
相关PDF资料 |
PDF描述 |
|---|---|
| PTH03000WAS | 1-OUTPUT DC-DC REG PWR SUPPLY MODULE |
| PTH03000WAZT | 1-OUTPUT DC-DC REG PWR SUPPLY MODULE |
| PTH03000WAH | 1-OUTPUT DC-DC REG PWR SUPPLY MODULE |
| PTH03000WAD | 1-OUTPUT DC-DC REG PWR SUPPLY MODULE |
| PTH03000WAST | 1-OUTPUT DC-DC REG PWR SUPPLY MODULE |
相关代理商/技术参数 |
参数描述 |
|---|---|
| PTEA420033P2AD | 功能描述:DC/DC转换器 20A 48V Inp Iso 1/8 Brick DC/DC Cnvrtr RoHS:否 制造商:Murata 产品: 输出功率: 输入电压范围:3.6 V to 5.5 V 输入电压（标称）: 输出端数量:1 输出电压（通道 1）:3.3 V 输出电流（通道 1）:600 mA 输出电压（通道 2）: 输出电流（通道 2）: 安装风格:SMD/SMT 封装 / 箱体尺寸: |
| PTE-AM-02-B | 制造商:Autonics Corporation 功能描述:TOWER LIGHS 24VAC/VDC 27mA 0.65W 制造商:AUTONICS 功能描述:TOWER LIGHS, 24VAC/VDC, 27mA, 0.65W 制造商:AUTONICS 功能描述:TOWER LIGHS, 24VAC/VDC, 27mA, 0.65W; Supply Voltage V AC:24VAC; Supply Voltage V DC:24VDC; IP / NEMA Rating:IP65, NEMA 4X; Flash Rate Per Minute:80; Bulb Diameter:56mm; Current Rating:27mA; Light Source:LED; Mounting Type:Wall ;RoHS Compliant: Yes |
| PTE-AMF-02-B | 制造商:Autonics Corporation 功能描述:TOWER LIGHS 24VAC/VDC 27mA 0.65W 制造商:AUTONICS 功能描述:TOWER LIGHS, 24VAC/VDC, 27mA, 0.65W 制造商:AUTONICS 功能描述:TOWER LIGHS, 24VAC/VDC, 27mA, 0.65W; IP / NEMA Rating:IP65, NEMA 4X; Flash Rate Per Minute:80; Bulb Diameter:56mm; Current Rating:27mA; Light Source:LED; Mounting Type:Wall; Voltage Rating:24 VAC/VDC ;RoHS Compliant: Yes |
| PTE-AM-FF-B | 制造商:Autonics Corporation 功能描述:TOWER LIGHS 90-240VAC 27mA 0.65W 制造商:AUTONICS 功能描述:TOWER LIGHS, 90-240VAC, 27mA, 0.65W; IP / NEMA Rating:IP65, NEMA 4X; Flash Rate Per Minute:80; Bulb Diameter:56mm; Current Rating:27mA; Light Source:LED; Mounting Type:Wall; Voltage Rating:90-240VAC ;RoHS Compliant: Yes |
| PTE-AMF-FF-B | 制造商:Autonics Corporation 功能描述:TOWER LIGHS 90-240VAC 27mA 0.65W 制造商:AUTONICS 功能描述:TOWER LIGHS, 90-240VAC, 27mA, 0.65W 制造商:AUTONICS 功能描述:TOWER LIGHS, 90-240VAC, 27mA, 0.65W; IP / NEMA Rating:IP65, NEMA 4X; Flash Rate Per Minute:80; Bulb Diameter:56mm; Current Rating:27mA; Light Source:LED; Mounting Type:Wall; Voltage Rating:90-240VAC ;RoHS Compliant: Yes |
发布紧急采购，3分钟左右您将得到回复。