参数资料
型号: PTN78020HAS
厂商: TEXAS INSTRUMENTS INC
元件分类: 电源模块
英文描述: 1-OUTPUT DC-DC REG PWR SUPPLY MODULE
封装: DIP-7
文件页数: 11/26页
文件大小: 669K
代理商: PTN78020HAS
Optional Input/Output Filters
Input/Output Capacitors
PTN78020W
2
6
5
+
7
4
GND
Adjust
Sense
1
3
GND
UDG06049
VO
VI
VO
VI
Inhibit
C1
1
F
50 V
Ceramic
C2
2.2
F
50 V
Ceramic
(Required)
C3
330
F
(Required)
C4
1
F
Ceramic
RSET
(2)
(1)
π Filters
www.ti.com .................................................................................................................................................. SLTS228B – DECEMBER 2004 – REVISED APRIL 2008
Power modules include internal input and output ceramic capacitors in all of their designs. However, some
applications require much lower levels of either input reflected or output ripple/noise. This application describes
various filters and design techniques found to be successful in reducing both input and output ripple/noise.
The easiest way to reduce output ripple and noise is to add one or more 1-
F ceramic capacitors, such as C4
shown in Figure 29. Ceramic capacitors should be placed close to the output power terminals. A single 1-
F
capacitor reduces the output ripple/noise by 10% to 30% for modules with a rated output current of less than 3 A.
(Note: C3 is required to improve the regulator transient response, and does not reduce output ripple and noise.)
Switching regulators draw current from the input line in pulses at their operating frequency. The amount of
reflected (input) ripple/noise generated is directly proportional to the equivalent source impedance of the power
source including the impedance of any input lines. The addition of C1, minimum 2.2-
F ceramic capacitor, near
the input power pins, reduces reflected conducted ripple/noise by 30% to 50%.
(1)
See the specifications for required value and type. For the PTN78020H, C2 = 4
× 4.7 F.
(2)
See the Application Information section for suggeted value and type.
Figure 29. Adding High-Frequency Bypass Capacitors To The Input and Output
If a further reduction in ripple/noise level is required for an application, higher order filters must be used. A
π (pi)
filter, employing a ferrite bead (Fair-Rite part number 2773021447 or equivalent) in series with the input or output
terminals of the regulator reduces the ripple/noise by at least 20 db (see Figure 30 and Figure 31). In order for
the inductor to be effective in reduction of ripple and noise, ceramic capacitors are required. (Note: see Capacitor
Recommendations for the PTN78020W for addtional information on vendors and component suggestions.)
These inductors plus ceramic capacitors form an excellent filter because of the rejection at the switching
frequency (650 kHz - 1 MHz). The placement of this filter is critical. It must be located as close as possible to the
input or output pins to be efffective. The ferrite bead is small (12.5 mm
× 3 mm), easy to use, low cost, and has
low dc resistance. Fair-Rite also manufactures a surface mount bead (part number 2773021447), through hole
(part number 2673000701) rated to 5 A, but in this application, it is effective to 6 A on the output bus. 1-H to
5-H inductors can be used in place of the ferrite inductor bead.
Copyright 2004–2008, Texas Instruments Incorporated
19
Product Folder Link(s): PTN78020W PTN78020H
相关PDF资料
PDF描述
PTN78020HAZ 1-OUTPUT DC-DC REG PWR SUPPLY MODULE
PTN78020WAZT 1-OUTPUT DC-DC REG PWR SUPPLY MODULE
PTN78020HAST 1-OUTPUT DC-DC REG PWR SUPPLY MODULE
PTN78020HAH 1-OUTPUT DC-DC REG PWR SUPPLY MODULE
PTN78020HAZT 1-OUTPUT DC-DC REG PWR SUPPLY MODULE
相关代理商/技术参数
参数描述
PTN78020HAST 功能描述:DC/DC转换器 6A Wide-In Wide Output Adj Module RoHS:否 制造商:Murata 产品: 输出功率: 输入电压范围:3.6 V to 5.5 V 输入电压(标称): 输出端数量:1 输出电压(通道 1):3.3 V 输出电流(通道 1):600 mA 输出电压(通道 2): 输出电流(通道 2): 安装风格:SMD/SMT 封装 / 箱体尺寸:
PTN78020HAZ 功能描述:DC/DC转换器 6A Wide-In Wide Output Adj Module RoHS:否 制造商:Murata 产品: 输出功率: 输入电压范围:3.6 V to 5.5 V 输入电压(标称): 输出端数量:1 输出电压(通道 1):3.3 V 输出电流(通道 1):600 mA 输出电压(通道 2): 输出电流(通道 2): 安装风格:SMD/SMT 封装 / 箱体尺寸:
PTN78020HAZT 功能描述:DC/DC转换器 6A Wide-In Wide Output Adj Module RoHS:否 制造商:Murata 产品: 输出功率: 输入电压范围:3.6 V to 5.5 V 输入电压(标称): 输出端数量:1 输出电压(通道 1):3.3 V 输出电流(通道 1):600 mA 输出电压(通道 2): 输出电流(通道 2): 安装风格:SMD/SMT 封装 / 箱体尺寸:
PTN78020W 制造商:TI 制造商全称:Texas Instruments 功能描述:6-A, WIDE-INPUT ADJUSTABLE SWITCHING REGULATOR
PTN78020W_08 制造商:TI 制造商全称:Texas Instruments 功能描述:6-A, WIDE-INPUT ADJUSTABLE SWITCHING REGULATOR