参数资料
型号: PTV12010WAH
厂商: TEXAS INSTRUMENTS INC
元件分类: 电源模块
英文描述: 1-OUTPUT DC-DC REG PWR SUPPLY MODULE
封装: SIP-8
文件页数: 5/22页
文件大小: 386K
代理商: PTV12010WAH
www.ti.com
POWER-UP INTO A NON-PREBIASED OUTPUT — AUTO-TRACK FUNCTION
UDG06074
RSET
2 k
0.1 W
1 %
CO
330
F
CI
560
F
2
8
1
7
3
9
10
PTH12060W
4
6
+
GND
L
O
A
D
Q1
BSS138
1=TurnOff
+
Margin
Down
Margin
Up
Inhibit
Track
GND
VoAdj
5
VO
VOSense
VI
SLTS234B – DECEMBER 2004 – REVISED FEBRUARY 2007
The Auto-Track function is unique to the PTH/PTV family, and is available with all POLA products. Auto-Track
was designed to simplify the amount of circuitry required to make the output voltage from each module power up
and power down in sequence. The sequencing of two or more supply voltages during power up is a common
requirement for complex mixed-signal applications that use dual-voltage VLSI ICs such as the TMS320 DSP
family, microprocessors, and ASICs.
Basic Power-Up using Auto-Track
For applications requiring output voltage on/off control, each series of the PTH family incorporates the track
control pin. The Auto-Track feature should be used instead of the inhibit feature wherever there is a requirement
for the output voltage from the regulator to be turned on/off.
Figure 12 shows the typical application for basic start-up. Note the discrete transistor (Q1). The track input has
its own internal pull-up to a potential of 5 V to 13.2 V The input is not compatible with TTL logic devices. An
open-collector (or open-drain) discrete transistor or supply voltage supervisor (TPS3808 or TPS7712) is
recommended for control.
Figure 12. Basic Start-up Control Circuit
Turning on Q1 applies a low voltage to the track control pin and disables the output of the module. If Q1 is then
turned off, the output ramps immediately to the regulated output voltage. A regulated output voltage is produced
within 35 ms. With the initial application of the input source voltage, the track pin must be held low (Q1 turned
ON) for at least 40 ms. Figure 13 shows the typical rise in both the output voltage and input current, following
the turn off of Q1. The turn off of Q1 corresponds to the rise in the waveform, Q1 Vds. The waveforms were
measured with a 10-A constant current load.
13
相关PDF资料
PDF描述
PVX003A0X43-SRZ 1-OUTPUT DC-DC REG PWR SUPPLY MODULE
PVX006A0X43-SRZ DC-DC REG PWR SUPPLY MODULE
PVX006A0X3-SRZ DC-DC REG PWR SUPPLY MODULE
PVX012A0X3-SRZ 1-OUTPUT DC-DC REG PWR SUPPLY MODULE
PVX012A0X43-SRZ 1-OUTPUT DC-DC REG PWR SUPPLY MODULE
相关代理商/技术参数
参数描述
PTV12010WAH 制造商:Texas Instruments 功能描述:IC REG SW 1.2-5.5V 8A VERT T/H 制造商:Texas Instruments 功能描述:IC, REG SW 1.2-5.5V 8A VERT T/H 制造商:Texas Instruments 功能描述:IC, REG SW 1.2-5.5V 8A VERT T/H; DC / DC Converter Type:Non Isolated POLA; DC / DC Converter Output Type:Adjustable; Input Voltage DC Min:10.8V; Input Voltage DC Max:13.2V; No. of Outputs:1; Output Voltage Nom.:1.2V to 5.5V; Output ;RoHS Compliant: Yes
PTV12020 制造商:EMERSON-NETWORKPOWER 制造商全称:Emerson Network Power 功能描述:DC-DC CONVERTERS
PTV12020L 制造商:EMERSON-NETWORKPOWER 制造商全称:Emerson Network Power 功能描述:DC-DC CONVERTERS
PTV12020LAD 功能描述:DC/DC转换器 28.8W 0.8-1.8V 16A RoHS:否 制造商:Murata 产品: 输出功率: 输入电压范围:3.6 V to 5.5 V 输入电压(标称): 输出端数量:1 输出电压(通道 1):3.3 V 输出电流(通道 1):600 mA 输出电压(通道 2): 输出电流(通道 2): 安装风格:SMD/SMT 封装 / 箱体尺寸:
PTV12020LAH 功能描述:DC/DC转换器 0.8-1.8V 16A 12V-In WideAdj SIP Module RoHS:否 制造商:Murata 产品: 输出功率: 输入电压范围:3.6 V to 5.5 V 输入电压(标称): 输出端数量:1 输出电压(通道 1):3.3 V 输出电流(通道 1):600 mA 输出电压(通道 2): 输出电流(通道 2): 安装风格:SMD/SMT 封装 / 箱体尺寸: