- 您现在的位置：买卖IC网 > PDF目录17478 > PVG5H201C03B00 (Murata Electronics North America)TRIMMER 200 OHM 0.25W SMD PDF资料下载
参数资料
| 型号： | PVG5H201C03B00 |
| 厂商： | Murata Electronics North America |
| 文件页数： | 48/55页 |
| 文件大小： | 0K |
| 描述： | TRIMMER 200 OHM 0.25W SMD |
| 标准包装： | 50 |
| 系列： | PVG5 |
| 电阻（欧姆）： | 200 |
| 功率（瓦特）： | 0.25W，1/4W |
| 容差： | ±10% |
| 温度系数： | ±150ppm/°C |
| 匝数： | 11 |
| 调节型： | 侧面调节 |
| 电阻材料： | 金属陶瓷 |
| 安装类型： | 表面贴装 |
| 端接类型： | J 引线 |
| 包装： | 散装 |
| 尺寸/尺寸： | 方形 - 0.193" L x 0.189" W x 0.146" H（4.90mm x 4.80mm x 3.70mm） |
第1页第2页第3页第4页第5页第6页第7页第8页第9页第10页第11页第12页第13页第14页第15页第16页第17页第18页第19页第20页第21页第22页第23页第24页第25页第26页第27页第28页第29页第30页第31页第32页第33页第34页第35页第36页第37页第38页第39页第40页第41页第42页第43页第44页第45页第46页第47页当前第48页第49页第50页第51页第52页第53页第54页第55页
! Note ? Please read rating and ! CAUTION (for storage, operating, rating, soldering, mounting and handling) in this catalog to prevent smoking and/or burning, etc.
? This catalog has only typical speci?cations. Therefore, please approve our product speci?cations or transact the approval sheet for product speci?cations before ordering.
SMD Sealed Type (PVG3/M4A_D01/G5)/Lead Sealed Type (PV32/12/37/36) Speci?cations and Test Methods
The following describes trimmer potentiometer testing conducted by Murata Manufacturing Co., Ltd. in accordance with MIL-R-22097 (military specification
for variable resistors, non-wirewound) and MIL-STD-202 (test methods for electronic and electrical component parts).
R50E.pdf
Jul.23,2012
No.
Item
Test Methods
Measure total resistance between the resistance element and terminals (#1 and #3) with the contact arm positioned
against a stop. The positioning of the contact arm and terminal should be the same for subsequent total resistance
measurements on the same device. Use the test voltage specified in Table 1 for total resistance measurements.
This voltage should be used for all subsequent total resistance measurements.
Total Resistance,
Maximum Test
1
Total Resistance
Nominal (ohm)
10 V R V 100
100 F R V 1k
1k F R V 10k
10k F R V 100k
100k F R
Voltage (V)
1.0
3.0
10.0
30.0
100.0
Table 1: Total resistance test voltage
Position the contact arm at the extreme counterclockwise limit of mechanical travel and measure the resistance
between the contact arm and the corresponding end terminal. Then, position the contact arm at the extreme
2
Residual Resistance
clockwise limit of mechanical travel and measure the resistance between the contact arm and the corresponding end
terminal. During this test, take suitable precautions to ensure that the rated current of the resistance element is not
exceeded.
Contact resistance variation should be measured with the measuring circuit shown in Figure 1, or its equivalent. The
adjustment rotor (screw) should be rotated in both directions through 90% of the actual effective-electrical rotational
angle (number of turns) for a total of 6 cycles. Only the last 3 cycles should count in determining whether or not a
contact resistance variation is observed at least twice in the same location, exclusive of the roll-on or roll-off points
where the contact arm moves from the termination, on or off, the resistance element. The rate of rotation of the
adjustment rotor (screw) should be such that the adjustment rotor (screw) completes 1 cycle for 5 seconds minimum
to 2 minutes maximum. The test current used should follow the value given in Table 2 unless otherwise limited by
power rating.
# 3
# 1
3
Contact Resistance
Variation
Standard Total Resistance
R (ohm)
R V 100
100 F R F 500
500 V R F 1k
1k V R F 2k
2k V R F 50k
50k V R F 200k
200k V R F 1M
1M V R F 2M
2M V R
Test Current
20mA
10mA
4mA
2mA
1mA
200μA
100μA
50μA
30μA
Rx
# 2
Constant Current Source
Calibration
(Test current shown in Table 2) AC
resistance
Amplifier
Rx : Trimmer Potentiometer
Oscilloscope bandwidth :100Hz to 50kHz
Figure 1: CRV measuring circuit
Oscilloscope
vertical
entry
Table 2: Test current for CRV
The trimmer potentiometer should be subjected to each of the following temperatures (see Table 3) for 30-45
minutes. Temperature coefficient of resistance should be applied to the following formula.
TCR=
R 2 – R 1
R 1 (T 2 – T 1 )
Z 10 6 (ppm/°C)
T 1
T 2
: Reference temperature in degrees celsius
: Test temperature in degrees celsius
4
Temperature Coefficient of
Resistance
R 1
R 2
: Resistance at reference temperature in ohm
: Resistance at test temperature in ohm
Sequence
Temperature (°C)
1*
+25
2
-15
3
Min. operating
Temperature
4*
+25
5
+65
6
Max. operating
Temperature
Note*: Reference temperature
Table 3: Test temperatures
The wiper should be set at approximately 40% of the actual effective-electrical rotational angle (number of turns). An
adequate DC test potential should be applied between terminal #1 and terminal #3. The voltage between terminal #1
and terminal #3, and the voltage between terminal #1 and terminal #2, should be measured and applied to the
following formula.
E
(
)
Voltage setting stability= — – — Z 100 (%)
5
Voltage Setting
Stability
e' e
E E
e : Before test
(The voltage between terminal #1 and terminal #2)
e' : After test
#1
e
#2
#3
(The voltage between terminal #1 and terminal #2)
Figure 2
Continued on the following page.
46
相关PDF资料 |
PDF描述 |
|---|---|
| PVG5H200C03B00 | TRIMMER 20 OHM 0.25W SMD |
| PVG5H105C03B00 | TRIMMER 1M OHM 0.25W SMD |
| PVG5H104C03B00 | TRIMMER 100K OHM 0.25W SMD |
| PVG5H103C03B00 | TRIMMER 10K OHM 0.25W SMD |
| PVG5H102C03B00 | TRIMMER 1K OHM 0.25W SMD |
相关代理商/技术参数 |
参数描述 |
|---|---|
| PVG5H201C03R00 | 功能描述:微调电阻器 - 表面贴装 200ohms 5mm 11turn Side Adjust RoHS:否 制造商:Murata 产品:Single-Turn Trimmer Potentiometers 产品类型:Single Turn 转数:1 元件类型:Cermet 锥度:Linear 电阻:10 kOhms 电压额定值: 端接类型:SMD/SMT 功率额定值:250 mW (1/4 W) 容差:20 % 温度系数:150 PPM / C |
| PVG5H202A01B00 | 功能描述:微调电阻器 - 表面贴装 2000 ohm RoHS:否 制造商:Murata 产品:Single-Turn Trimmer Potentiometers 产品类型:Single Turn 转数:1 元件类型:Cermet 锥度:Linear 电阻:10 kOhms 电压额定值: 端接类型:SMD/SMT 功率额定值:250 mW (1/4 W) 容差:20 % 温度系数:150 PPM / C |
| PVG5H202A01R00 | 功能描述:微调电阻器 - 表面贴装 2000 ohm RoHS:否 制造商:Murata 产品:Single-Turn Trimmer Potentiometers 产品类型:Single Turn 转数:1 元件类型:Cermet 锥度:Linear 电阻:10 kOhms 电压额定值: 端接类型:SMD/SMT 功率额定值:250 mW (1/4 W) 容差:20 % 温度系数:150 PPM / C |
| PVG5H202C01B00 | 功能描述:微调电阻器 - 表面贴装 2Kohms 5mm Sealed Square 11 turns RoHS:否 制造商:Murata 产品:Single-Turn Trimmer Potentiometers 产品类型:Single Turn 转数:1 元件类型:Cermet 锥度:Linear 电阻:10 kOhms 电压额定值: 端接类型:SMD/SMT 功率额定值:250 mW (1/4 W) 容差:20 % 温度系数:150 PPM / C |
| PVG5H202C01R00 | 功能描述:微调电阻器 - 表面贴装 2Kohms RoHS:否 制造商:Murata 产品:Single-Turn Trimmer Potentiometers 产品类型:Single Turn 转数:1 元件类型:Cermet 锥度:Linear 电阻:10 kOhms 电压额定值: 端接类型:SMD/SMT 功率额定值:250 mW (1/4 W) 容差:20 % 温度系数:150 PPM / C |
发布紧急采购，3分钟左右您将得到回复。