参数资料
| 型号： | QLS30ZB-NT |
| 厂商： | Power-One |
| 文件页数： | 6/9页 |
| 文件大小： | 0K |
| 描述： | CONV DC-DC 48V IN 1.8V OUT 54W |
| 标准包装： | 108 |
| 系列： | QLS |
| 类型： | 隔离 |
| 输出数： | 1 |
| 电压 - 输入（最小）： | 36V |
| 电压 - 输入（最大）： | 75V |
| Voltage - Output 1： | 1.8V |
| 电流 - 输出（最大）： | 30A |
| 电源（瓦） - 制造商系列： | 54W |
| 电压 - 隔离： | 1.5kV（1500V） |
| 安装类型： | 通孔 |
| 封装/外壳： | 8-DIP 模块，1/4 砖 |
| 尺寸/尺寸： | 2.28" L x 1.45" W x 0.43" H（57.9mm x 36.8mm x 10.9mm） |
| 包装： | 托盘 |
| 工作温度： | -40°C ~ 100°C |
| 效率： | 86% |
| 电源（瓦特）- 最大： | 54W |
| 其它名称： | 179-2229 |
QLS30 DC-DC Series Data Sheet
30A Quarter-Brick Converter
Note:
If the ON/OFF pin is not used, it can be left floating
(positive logic), or connected to the -Vin pin (negative logic).
Typical Application
Figure 7 shows the recommended connections for the
QLS30 Series converter.
Output Voltage Trim
The trim feature allows the user to adjust the output
voltage from the nominal. This can be used to
accommodate a different requirement or to do production
Fuse
+Vi
QLS30ZX
+Vo
+Sense
margin testing. There are two variances available in the
QLS30 Series.
Negative Trim (No suffix)
The QLS30 negative trim units trim up with a resistor from
C1
On/Off
Trim
C2
C3
the TRIM pin to the –Sense pin and trim down with a
resistor from the TRIM pin to the +Sense pin, as shown in
Fig.8.
-Sense
-Vi
-Vo
The negative trim schematic is shown in Figure 8.
Figure 7. Typical Application of QLS30 Series
The QLS30 Series converters do not require any external
components for proper operation.
However, if the
distribution of the input voltage to the converter contains
significant inductance, the capacitor C1 may be required to
enhance performance of the converter. A minimum of a
33 μ F electrolytic capacitor with the ESR<0.7 Ω
is
recommended for the QLS30 Series.
Refer to the “Inrush Current Control Application Note” on
www.power-one.com for suggestions on how to limit the
magnitude of the inrush current.
For output decoupling we recommend using a 10 μ F
tantalum and a 1 μ F ceramic capacitors connected directly
across the output pins of the converter. Note that the
capacitors do not substitute the filtering required by the
load.
Shutdown Feature Description
The ON/OFF pin in the QLS30 Series converters functions
Figure 8. QLS30 Series Negative Trim Schematic
The general equation (1) for changing the output voltage
on the negative trim modules is invariant, but the constants
in the equation change due to different internal values.
as a normal soft shutdown. It is referenced to the –Vin pin
(see Figure 7). With positive logic, when the ON/OFF pin
is pulled low, the output is turned off and the unit goes into
a very low input power mode.
R TRIM =
A ? B × Δ V
Δ V
,
k ?
(1)
With negative logic, when the ON/OFF pin is pulled low,
the unit is turned on. An open collector switch is
recommended to control the voltage between the ON/OFF
pin and the -Vin pin of the converter. The ON/OFF pin is
where A and B are constants from the table below, and Δ V
is the absolute value of the desired change in the output
voltage in Volts.
pulled up internally, so no external voltage source is
required. The user should avoid connecting a resistor
between the ON/OFF pin and the +Vin pin.
When the ON/OFF pin is used to achieve remote control,
the user must take care to insure that the pin reference for
Model
QLS30ZB
QLS30ZA
QLS30ZY
Trim Up
A B
0.57 1
0.283 0.121
0.5928 3.01
Trim Down
A B
0.2711 1.4676
0.065 0.352
0.5686 3.96
the control is really the -Vin pin. The control signal must
not be referenced ahead of EMI filtering, or remotely from
the unit. Optically coupling the information and locating the
optical coupler directly at the module will solve any of these
problems.
MCD10053 Rev. 1.0
Page 6 of 9
www.power-one.com
相关PDF资料 |
PDF描述 |
|---|---|
| QLS30ZA-NT | CONV DC-DC 48V IN 1.5V OUT 45W |
| SQM48T20010-PAA0 | DC/DC EIGHTH BRICK |
| SQM48T20010-NECP | DC/DC EIGHTH BRICK |
| OSTEZ175152 | CONN PLUG HEADER 17PS 5.08MM |
| SQM48T20010-NEC0 | DC/DC EIGHTH BRICK |
相关代理商/技术参数 |
参数描述 |
|---|---|
| QLS30ZB-NT7 | 制造商:Power-One 功能描述:1-OUTPUT DC-DC REG PWR SUPPLY MODULE |
| QLS30ZB-NT8 | 制造商:Power-One 功能描述: |
| QLS30ZB-NTS1 | 制造商:Power-One 功能描述: |
| QLS30ZD-N | 制造商:Power-One 功能描述:- Bulk |
| QLS30ZY | 功能描述:DC/DC转换器 RoHS:否 制造商:Murata 产品: 输出功率: 输入电压范围:3.6 V to 5.5 V 输入电压（标称）: 输出端数量:1 输出电压（通道 1）:3.3 V 输出电流（通道 1）:600 mA 输出电压（通道 2）: 输出电流（通道 2）: 安装风格:SMD/SMT 封装 / 箱体尺寸: |
发布紧急采购，3分钟左右您将得到回复。