- 您现在的位置：买卖IC网 > PDF目录376305 > REG710 (Texas Instruments, Inc.) 60MA SWITCHED CAP BUCK/BOOST CONVERTER PDF资料下载
参数资料
| 型号： | REG710 |
| 厂商： | Texas Instruments, Inc. |
| 英文描述： | 60MA SWITCHED CAP BUCK/BOOST CONVERTER |
| 中文描述： | 60mA的开关电容降压/升压变换器 |
| 文件页数： | 7/15页 |
| 文件大小： | 378K |
| 代理商： | REG710 |
SBAS221E DECEMBER 2001 REVISED SEPTEMBER 2003
www.ti.com
7
THEORY OF OPERATION
The REG710 regulated charge pump provides a regulated
output voltage for input voltages ranging from less than the
output to greater than the output. This is accomplished by au-
tomatic mode switching within the device. When the input
voltage is greater than the required output, the unit functions
as a variable frequency switch-mode regulator. This opera-
tion is shown in Figure 1. Transistors Q
1
and Q
3
are held off,
Q
4
is on, and Q
2
is switched as needed to maintain a regu-
lated output voltage.
OFF
SWITCHED
StepDown (Buck) Mode
OFF
ON
C
PUMP
Q
1
Q
3
Q
2
Q
4
C
IN
C
OUT
V
OUT
V
IN
Figure 1. Simplified Schematic of the REG710
Operating in the Step-Down Mode
When the input voltage is less than the required output
voltage, the device switches to a step-up or boost mode of
operation, as shown in Figure 2.
A conversion clock of 50% duty cycle is generated. During
the first half cycle the FET switches are configured as
shown in Figure 2A, and C
PUMP
charges to V
IN
.
During the second half cycle the FET switched are config-
ured as shown in Figure 2B, and the voltage on C
PUMP
is
added to V
IN
. The output voltage is regulated by skipping
clock cycles as necessary.
PEAK CURRENT REDUCTION
In normal operation, the charging of the pump and output
capacitors usually leads to relatively high peak input cur-
rents which can be much higher than that of the average
load current. The regulator incorporates circuitry to limit
the input peak current, lowering the total EMI production of
the device and lowering output voltage ripple and input cur-
rent ripple. Input capacitor (C
IN
) supplies most of the
charge required by input current peaks.
PROTECTION
The regulator has thermal shutdown circuitry that protects
it from damage caused by overload conditions. The ther-
mal protection circuitry disables the output when the junc-
tion temperature reached approximately 160
°
C, allowing
the device to cool. When the junction temperature cools to
approximately 140
°
C, the output circuitry is automatically
reenabled. Continuously running the regulator into thermal
shutdown can degrade reliability. The regulator also pro-
vides current limit to protect itself and the load.
SHUTDOWN MODE
A control pin on the regulator can be used to place the de-
vice into an energy-saving shutdown mode. In this mode,
the output is disconnected from the input as long as V
IN
is
greater than or equal to minimum V
IN
and the input quies-
cent current is reduced to 1
μ
A maximum.
StepUp (Boost) Mode
(A)
(B)
OFF
ON
ON
OFF
C
PUMP
Q
2
Q
4
C
OUT
V
OUT
C
PUMP
Q
2
Q
4
C
OUT
V
OUT
OFF
ON
Q
1
Q
3
ON
OFF
Q
1
Q
3
C
IN
V
IN
C
IN
V
IN
Figure 2. Simplified Schematic of the REG710 Operating in the Step-Up or Boost Mode
相关PDF资料 |
PDF描述 |
|---|---|
| REJ03C0098_R1LV0408C | Wide Temperature Range Version 4M SRAM (512-kword 】 8-bit) |
| REJ03F0010_M61529FP | LEAD FREE EXT TEMP A6832 PLCC |
| REJ03F0023_M61140FP | TUNER SINGLE CHIP |
| REJ03F0035_M61524FP | 2ch ELECTRONIC VOLUME WITH 4 INPUT SELECTOR |
| REJ03F0040_M61528FP | LEAD FREE A6832 PLCC |
相关代理商/技术参数 |
参数描述 |
|---|---|
| REG710_07 | 制造商:BB 制造商全称:BB 功能描述:60mA Switched-Cap BUCK/BOOST CONVERTER |
| REG710_08 | 制造商:TI 制造商全称:Texas Instruments 功能描述:60mA, 5.0V, Buck/Boost Charge Pump in ThinSOT-23 and ThinQFN |
| REG710_1 | 制造商:TI 制造商全称:Texas Instruments 功能描述:60mA, 5.0V, Buck/Boost Charge Pump in ThinSOT-23 and ThinQFN |
| REG710-25 | 制造商:未知厂家 制造商全称:未知厂家 功能描述:30-mA Switched-Cap DC-DC Converter with fixed 2.5-V Output |
| REG710-27 | 制造商:未知厂家 制造商全称:未知厂家 功能描述:30-mA Switched-Cap DC-DC Converter with fixed 2.7-V Output |
发布紧急采购，3分钟左右您将得到回复。