- 您现在的位置：买卖IC网 > PDF目录15449 > RFS1C330MCN1GS (Nichicon)CAP ALUM 33UF 16V 20% SMD PDF资料下载
参数资料
| 型号： | RFS1C330MCN1GS |
| 厂商： | Nichicon |
| 文件页数： | 4/60页 |
| 文件大小： | 0K |
| 描述： | CAP ALUM 33UF 16V 20% SMD |
| 标准包装： | 1 |
| 系列： | FS |
| 电容： | 33µF |
| 额定电压： | 16V |
| 容差： | ±20% |
| 寿命@温度： | 105°C 时为 2000 小时 |
| 工作温度： | -55°C ~ 105°C |
| 特点： | 聚合物 |
| 纹波电流： | 2.07A |
| ESR（等效串联电阻）： | 35 毫欧 |
| 安装类型： | 表面贴装 |
| 封装/外壳： | 径向，Can - SMD |
| 尺寸/尺寸： | 0.197" 直径（5.00mm） |
| 高度 - 座高（最大）： | 0.236"（6.00mm） |
| 表面贴装占地面积： | 0.209" L x 0.209" W（5.30mm x 5.30mm） |
| 包装： | 标准包装 |
| 其它名称： | 493-6624-6 |
第1页第2页第3页当前第4页第5页第6页第7页第8页第9页第10页第11页第12页第13页第14页第15页第16页第17页第18页第19页第20页第21页第22页第23页第24页第25页第26页第27页第28页第29页第30页第31页第32页第33页第34页第35页第36页第37页第38页第39页第40页第41页第42页第43页第44页第45页第46页第47页第48页第49页第50页第51页第52页第53页第54页第55页第56页第57页第58页第59页第60页
Precautions
General Precautions at Designing, for Use and Handling
1. Circuit design precautions
(1) Check the rated performance
After checking the operation and installation environments, design the circuit so that it falls within the rated performance range
stipulated in the catalog specification.
(2) Operating temperature and ripple current
a) Set the operating temperature so that it falls within the range stipulated in the catalog specification.
b) Do not apply current that exceeds the allowable ripple current in the catalog.
(3) Leakage current
Even when the soldering conditions fall within the range of the catalog specification, the leakage current increases slightly.
It also increases slightly during high temperature no-load, moisture-proof no-load and temperature cycling tests with
no voltage applied.
In cases such as these, leakage current will decrease by applying voltage in conditions below the maximum operating temperature.
(4) Applied voltage Considerations
a) Make sure the sum of the peak DC voltage and ripple voltage values does not exceed the rated voltage.
b) Please do not apply the reverse voltage to FPCAP .
c) When the DC voltage is low, please check whether the peak value of ripple voltage does not become a reverse voltage.
(5) Reduction of failure stress
The main failure mode of the FPCAP is in the open mode primarily caused by an electrostatic capacitance drop.
Random short circuit mode failures occur rarely.
The time it takes to reach the failure mode can be extended by using the FPCAP with reduced ambient temperature,
ripple current and applied voltage.
(6) Capacitor insulation
a) Insulation is not guaranteed.
b) Be sure to completely separate the case, negative electrode terminal and positive electrode terminal from adjacent components
and PC board traces.
(7) Operating environment
Do not use the FPCAP in the following environments.
a) Places where it can come into direct contact with water or salt water and places where condensation may form.
b) Places filled with noxious gasses such as: hydrogen sulfide, sulfurous acid, nitrous acid, chlorine, ammonia, etc.
c) Places exposed to ozone, ultraviolet rays and radiation.
d) Where severe vibration or shock which exceeds the condition specified in the specification sheets.
(8) Assembly Conditions Considerations
In designing a circuit, the following conditions should be checked before the FPCAP is mounted on the PC board.
a) The pitch and diameter of PCB holes to which the FPCAP is mounted, shall be designed in conformance with the dimensional
tolerance stipulated in the catalog specifications.
(9) PC board
Avoid locating heat-generating components around the FPCAP and on the underside of the PC board under the FPCAP .
(10) Parallel connection
When used in a parallel connection with another capacitor, carefully select the type of capacitor.
(11) Other
a) Electrical characteristics are affected by fluctuations in temperature and frequency.
b) When mounting the FPCAP on a double-sided PC board, design the board so that extra PC board holes are not located
underneath the FPCAP .
2
NICHICON CORPORATION / FPCAP ELECTRONICS (SUZHOU) CO., LTD.
相关PDF资料 |
PDF描述 |
|---|---|
| V150C8T100B2 | CONVERTER MOD DC/DC 8V 100W |
| H2BXT-10106-Y4-ND | JUMPER-H1500TR/A2015Y/X 6" |
| ASM10DSXS | CONN EDGECARD 20POS DIP .156 SLD |
| V150C8T100B | CONVERTER MOD DC/DC 8V 100W |
| H2BXT-10106-W4-ND | JUMPER-H1500TR/A2015W/X 6" |
相关代理商/技术参数 |
参数描述 |
|---|---|
| RFS1C390MCN1GS | 功能描述:铝有机聚合物电容器 39UF 16V 20% RoHS:否 制造商:Panasonic Electronic Components 电容:470 uF 容差:20 % 电压额定值:2.5 V ESR:4.5 mOhms 工作温度范围:- 40 C to + 105 C 端接类型:SMD/SMT 外壳直径: 外壳长度:7.3 mm 外壳宽度:4.3 mm 外壳高度:1.9 mm 封装:Reel |
| RFS1E220MCN1GS | 功能描述:铝有机聚合物电容器 22UF 25V 20% RoHS:否 制造商:Panasonic Electronic Components 电容:470 uF 容差:20 % 电压额定值:2.5 V ESR:4.5 mOhms 工作温度范围:- 40 C to + 105 C 端接类型:SMD/SMT 外壳直径: 外壳长度:7.3 mm 外壳宽度:4.3 mm 外壳高度:1.9 mm 封装:Reel |
| RFS2 | 制造商:Ferraz Shawmut 功能描述: |
| RFS200 | 制造商:Universal 功能描述:URC RFS200 Universal Remote Control RF Power Pack 制造商:UNIVERSAL 功能描述:URC RFS200 POWER PACK RF20 AND POWER BLASTER |
| RFS-2002 | 制造商:RF Industries 功能描述:RF COAXIAL CABLE MOUNT CONNECTOR |
发布紧急采购，3分钟左右您将得到回复。