参数资料
型号: RPE5C1H150J2S1Z03A
厂商: Murata Electronics North America
文件页数: 16/57页
文件大小: 0K
描述: CAP CER 15PF 50V 5% RADIAL
标准包装: 2,000
系列: RPE
电容: 15pF
电压 - 额定: 50V
容差: ±5%
温度系数: C0G,NP0
安装类型: 通孔
工作温度: -55°C ~ 125°C
应用: 通用
封装/外壳: 径向
尺寸/尺寸: 0.197" L x 0.098" W(5.00mm x 2.50mm)
高度 - 座高(最大): 0.197"(5.00mm)
引线间隔: 0.098"(2.50mm)
包装: 带盒(TB)
引线型: 纽结
! Note ? Please read rating and ! CAUTION (for storage, operating, rating, soldering, mounting and handling) in this catalog to prevent smoking and/or burning, etc.
? This catalog has only typical speci?cations. Therefore, please approve our product speci?cations or transact the approval sheet for product speci?cations before ordering.
C49E.pdf
Mar.12,2014
1
Temperature Compensating Type Speci?cations and Test Methods
No. AEC-Q200 Test Item
Specifications
AEC-Q200 Test Method
1
Pre-and Post-Stress
Electrical Test
High Temperature
The measured and observed characteristics should satisfy the
Exposure (Storage) specifications in the following table.
Appearance No defects or abnormalities
2
Capacitance
Change
Q
Within ±3% or ±0.3pF (Whichever is larger)
30pF V C: Q U 350
10pF V C < 30pF: Q U 275+5C/2
10pF G C: Q U 200+10C
Sit the capacitor for 1,000±12h at 150±3°C. Let sit for 24±2h at
room temperature, then measure.
C: Nominal Capacitance (pF)
I.R.
Temperature
Cycling
More than 1,000M Ω or 50M Ω · μF (Whichever is smaller)
The measured and observed characteristics should satisfy the
specifications in the following table.
Appearance No defects or abnormalities
Perform the 1,000 cycles according to the four heat treatments
Capacitance
Change
Within ±5% or ±0.5pF (Whichever is larger)
listed in the following table. Let sit for 24±2h at *room condition,
then measure.
3
Q
30pF V C: Q U 350
10pF V C < 30pF: Q U 275+5C/2
10pF G C: Q U 200+10C
Step 1 2 3 4
Temp. (°C) -55+0/-3 Room Temp. 125+3/-0 Room Temp.
Time (min.) 15±3 1 15±3 1
C: Nominal Capacitance (pF)
I.R.
1,000M Ω or 50M Ω · μF min. (Whichever is smaller)
Moisture
Resistance
The measured and observed characteristics should satisfy the
specifications in the following table.
Apply the 24h heat (25 to 65°C) and humidity (80 to 98%)
treatment shown below, 10 consecutive times.
Appearance No defects or abnormalities
Let sit for 24±2h at *room condition, then measure.
Humidity
Humidity Humidity Humidity
Humidity
Capacitance
Change
Within ±5% or ±0.5pF (Whichever is larger)
(°C)
70
65
90-98%
80-98% 90-98%
80-98%
90-98%
60
-2 °C
4
Q
30pF V C: Q U 200
30pF G C: Q U 100+10C/3
C: Nominal Capacitance (pF)
55
50
45
40
35
30
25
20
15
10
+10
Initial measurement
5
0
I.R.
500M Ω or 25M Ω · μF min. (Whichever is smaller)
-5
-10
One cycle = 24 hours
0 1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24
Hours
Biased Humidity
The measured and observed characteristics should satisfy the
specifications in the following table.
Appearance No defects or abnormalities
5
Capacitance
Change
Q
Within ±5% or ±0.5pF (Whichever is larger)
30pF V C: Q U 200
30pF G C: Q U 100+10C/3
Apply the rated voltage and DC1.3+0.2/-0V (add 6.8k Ω resistor)
at 85±3°C and 80 to 85% humidity for 1,000±12h.
Remove and let sit for 24±2h at *room condition, then measure.
The charge/discharge current is less than 50mA.
C: Nominal Capacitance (pF)
I.R.
Operational Life
500M Ω or 25M Ω · μF min. (Whichever is smaller)
The measured and observed characteristics should satisfy the
specifications in the following table.
Appearance No defects or abnormalities
Apply the voltage shown in the table for 1,000±12h at 125±3°C.
Capacitance
Change
Within ±3% or ±0.3pF (Whichever is larger)
Let sit for 24±2h at *room condition, then measure.
The charge/discharge current is less than 50mA.
6
Q
30pF V C: Q U 350
10pF V C < 30pF: Q U 275+5C/2
10pF G C: Q U 200+10C
Rated Voltage
DC50V, DC100V
DC250V
DC630V, DC1kV
Test Voltage
200% of the rated voltage
150% of the rated voltage
120% of the rated voltage
C: Nominal Capacitance (pF)
I.R.
1,000M Ω or 50M Ω · μF min. (Whichever is smaller)
* “room condition” Temperature: 15 to 35°C, Relative humidity: 45 to 75%, Atmosphere pressure: 86 to 106kPa
Continued on the following page.
14
相关PDF资料
PDF描述
PIC24HJ256GP210A-E/PF MCU 16BIT 256K FLASH 100TQFP
PIC16C76-04E/SP IC MCU OTP 8KX14 A/D PWM 28DIP
RPE5C1H150J2M1Z03A CAP CER 15PF 50V 5% RADIAL
PIC18LF4585T-I/ML IC MCU FLASH 24KX16 44QFN
PIC32MX664F128LT-I/PF IC PIC MCU 128KBIT FLASH 100TQFP
相关代理商/技术参数
参数描述
RPE5C1H150J2S2Y03A 功能描述:多层陶瓷电容器MLCC - 含引线 15pF 50volt C0G +/-5% RoHS:否 制造商:AVX 电容:470 pF 容差:10 % 电压额定值:3 kV 端接类型:Radial 工作温度范围: 温度系数/代码:X7R 引线间隔:5.08 mm 产品:Automotive MLCCs 引线类型:
RPE5C1H151J1A1C03B 功能描述:多层陶瓷电容器MLCC - 含引线 150pF 50volts C0G 5% 2.5mm L/S RoHS:否 制造商:AVX 电容:470 pF 容差:10 % 电压额定值:3 kV 端接类型:Radial 工作温度范围: 温度系数/代码:X7R 引线间隔:5.08 mm 产品:Automotive MLCCs 引线类型:
RPE5C1H151J1A1Y02B 功能描述:多层陶瓷电容器MLCC - 含引线 150pF 50volt C0G +/-5% RoHS:否 制造商:AVX 电容:470 pF 容差:10 % 电压额定值:3 kV 端接类型:Radial 工作温度范围: 温度系数/代码:X7R 引线间隔:5.08 mm 产品:Automotive MLCCs 引线类型:
RPE5C1H151J2K1A03A 功能描述:多层陶瓷电容器MLCC - 含引线 150pF 50volt C0G +/-5% RoHS:否 制造商:AVX 电容:470 pF 容差:10 % 电压额定值:3 kV 端接类型:Radial 工作温度范围: 温度系数/代码:X7R 引线间隔:5.08 mm 产品:Automotive MLCCs 引线类型:
RPE5C1H151J2K1A03B 功能描述:CAP CER 150PF 50V 5% RADIAL RoHS:是 类别:电容器 >> 陶瓷 系列:RPE 标准包装:4,000 系列:- 电容:1000pF 电压 - 额定:50V 容差:±10% 温度系数:X7R 安装类型:表面贴装,MLCC 工作温度:-55°C ~ 125°C 应用:自动 额定值:AEC-Q200 封装/外壳:0805(2012 公制) 尺寸/尺寸:0.079" L x 0.047" W(2.00mm x 1.20mm) 高度 - 座高(最大):- 厚度(最大):- 引线间隔:- 特点:- 包装:带卷 (TR) 引线型:-