参数资料
型号: RPE5C1H220J2S1Z03A
厂商: Murata Electronics North America
文件页数: 16/57页
文件大小: 0K
描述: CAP CER 22PF 50V 5% RADIAL
标准包装: 2,000
系列: RPE
电容: 22pF
电压 - 额定: 50V
容差: ±5%
温度系数: C0G,NP0
安装类型: 通孔
工作温度: -55°C ~ 125°C
应用: 通用
封装/外壳: 径向
尺寸/尺寸: 0.197" L x 0.098" W(5.00mm x 2.50mm)
高度 - 座高(最大): 0.197"(5.00mm)
引线间隔: 0.098"(2.50mm)
包装: 带盒(TB)
引线型: 纽结
! Note ? Please read rating and ! CAUTION (for storage, operating, rating, soldering, mounting and handling) in this catalog to prevent smoking and/or burning, etc.
? This catalog has only typical speci?cations. Therefore, please approve our product speci?cations or transact the approval sheet for product speci?cations before ordering.
C49E.pdf
Mar.12,2014
1
Temperature Compensating Type Speci?cations and Test Methods
No. AEC-Q200 Test Item
Specifications
AEC-Q200 Test Method
1
Pre-and Post-Stress
Electrical Test
High Temperature
The measured and observed characteristics should satisfy the
Exposure (Storage) specifications in the following table.
Appearance No defects or abnormalities
2
Capacitance
Change
Q
Within ±3% or ±0.3pF (Whichever is larger)
30pF V C: Q U 350
10pF V C < 30pF: Q U 275+5C/2
10pF G C: Q U 200+10C
Sit the capacitor for 1,000±12h at 150±3°C. Let sit for 24±2h at
room temperature, then measure.
C: Nominal Capacitance (pF)
I.R.
Temperature
Cycling
More than 1,000M Ω or 50M Ω · μF (Whichever is smaller)
The measured and observed characteristics should satisfy the
specifications in the following table.
Appearance No defects or abnormalities
Perform the 1,000 cycles according to the four heat treatments
Capacitance
Change
Within ±5% or ±0.5pF (Whichever is larger)
listed in the following table. Let sit for 24±2h at *room condition,
then measure.
3
Q
30pF V C: Q U 350
10pF V C < 30pF: Q U 275+5C/2
10pF G C: Q U 200+10C
Step 1 2 3 4
Temp. (°C) -55+0/-3 Room Temp. 125+3/-0 Room Temp.
Time (min.) 15±3 1 15±3 1
C: Nominal Capacitance (pF)
I.R.
1,000M Ω or 50M Ω · μF min. (Whichever is smaller)
Moisture
Resistance
The measured and observed characteristics should satisfy the
specifications in the following table.
Apply the 24h heat (25 to 65°C) and humidity (80 to 98%)
treatment shown below, 10 consecutive times.
Appearance No defects or abnormalities
Let sit for 24±2h at *room condition, then measure.
Humidity
Humidity Humidity Humidity
Humidity
Capacitance
Change
Within ±5% or ±0.5pF (Whichever is larger)
(°C)
70
65
90-98%
80-98% 90-98%
80-98%
90-98%
60
-2 °C
4
Q
30pF V C: Q U 200
30pF G C: Q U 100+10C/3
C: Nominal Capacitance (pF)
55
50
45
40
35
30
25
20
15
10
+10
Initial measurement
5
0
I.R.
500M Ω or 25M Ω · μF min. (Whichever is smaller)
-5
-10
One cycle = 24 hours
0 1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24
Hours
Biased Humidity
The measured and observed characteristics should satisfy the
specifications in the following table.
Appearance No defects or abnormalities
5
Capacitance
Change
Q
Within ±5% or ±0.5pF (Whichever is larger)
30pF V C: Q U 200
30pF G C: Q U 100+10C/3
Apply the rated voltage and DC1.3+0.2/-0V (add 6.8k Ω resistor)
at 85±3°C and 80 to 85% humidity for 1,000±12h.
Remove and let sit for 24±2h at *room condition, then measure.
The charge/discharge current is less than 50mA.
C: Nominal Capacitance (pF)
I.R.
Operational Life
500M Ω or 25M Ω · μF min. (Whichever is smaller)
The measured and observed characteristics should satisfy the
specifications in the following table.
Appearance No defects or abnormalities
Apply the voltage shown in the table for 1,000±12h at 125±3°C.
Capacitance
Change
Within ±3% or ±0.3pF (Whichever is larger)
Let sit for 24±2h at *room condition, then measure.
The charge/discharge current is less than 50mA.
6
Q
30pF V C: Q U 350
10pF V C < 30pF: Q U 275+5C/2
10pF G C: Q U 200+10C
Rated Voltage
DC50V, DC100V
DC250V
DC630V, DC1kV
Test Voltage
200% of the rated voltage
150% of the rated voltage
120% of the rated voltage
C: Nominal Capacitance (pF)
I.R.
1,000M Ω or 50M Ω · μF min. (Whichever is smaller)
* “room condition” Temperature: 15 to 35°C, Relative humidity: 45 to 75%, Atmosphere pressure: 86 to 106kPa
Continued on the following page.
14
相关PDF资料
PDF描述
RPE5C1H220J2M1Z03A CAP CER 22PF 50V 5% RADIAL
PIC18F442T-I/PT IC MCU FLASH 8KX16 EE A/D 44TQFP
RPE5C1H1R0C2S1B03A CAP CER 1PF 50V RADIAL
PIC24FJ256GB210T-I/BG MCU 16BIT 256K FLASH 121-BGA
RPE5C1H180J2S1Z03A CAP CER 18PF 50V 5% RADIAL
相关代理商/技术参数
参数描述
RPE5C1H220J2S2Z03A 功能描述:多层陶瓷电容器MLCC - 含引线 22pF 50volts C0G 5% 2.5mm L/S RoHS:否 制造商:AVX 电容:470 pF 容差:10 % 电压额定值:3 kV 端接类型:Radial 工作温度范围: 温度系数/代码:X7R 引线间隔:5.08 mm 产品:Automotive MLCCs 引线类型:
RPE5C1H221J1A1C03B 功能描述:多层陶瓷电容器MLCC - 含引线 220pF 50volt C0G +/-5% RoHS:否 制造商:AVX 电容:470 pF 容差:10 % 电压额定值:3 kV 端接类型:Radial 工作温度范围: 温度系数/代码:X7R 引线间隔:5.08 mm 产品:Automotive MLCCs 引线类型:
RPE5C1H221J1A1Y02B 功能描述:多层陶瓷电容器MLCC - 含引线 220pF 50volt C0G +/-5% RoHS:否 制造商:AVX 电容:470 pF 容差:10 % 电压额定值:3 kV 端接类型:Radial 工作温度范围: 温度系数/代码:X7R 引线间隔:5.08 mm 产品:Automotive MLCCs 引线类型:
RPE5C1H221J2K1A03A 功能描述:多层陶瓷电容器MLCC - 含引线 220pF 50volts C0G 5% 5.0mm L/S RoHS:否 制造商:AVX 电容:470 pF 容差:10 % 电压额定值:3 kV 端接类型:Radial 工作温度范围: 温度系数/代码:X7R 引线间隔:5.08 mm 产品:Automotive MLCCs 引线类型:
RPE5C1H221J2K1A03B 功能描述:多层陶瓷电容器MLCC - 含引线 220pF 50volts 5% C0G RoHS:否 制造商:AVX 电容:470 pF 容差:10 % 电压额定值:3 kV 端接类型:Radial 工作温度范围: 温度系数/代码:X7R 引线间隔:5.08 mm 产品:Automotive MLCCs 引线类型: