- 您现在的位置：买卖IC网 > PDF目录85373 > S201DH2F (SHARP ELECTRONICS CORP) TRIGGER OUTPUT SOLID STATE RELAY, 4000 V ISOLATION-MAX PDF资料下载
参数资料
| 型号： | S201DH2F |
| 厂商： | SHARP ELECTRONICS CORP |
| 元件分类： | 继电器，输入/输出模块 |
| 英文描述： | TRIGGER OUTPUT SOLID STATE RELAY, 4000 V ISOLATION-MAX |
| 封装： | LEAD FREE, PLASTIC, DIP-16 |
| 文件页数： | 12/13页 |
| 文件大小： | 244K |
| 代理商： | S201DH2F |
8
S101DH2 Series
S201DH2 Series
■ Design Considerations
Sheet No.: D4-A01301EN
● Design guide
In order for the SSR to turn off, the triggering current (IF) must be 0.1mA or less.
Particular attention needs to be paid when utilizing SSRs that incorporate zero crossing circuitry.
If the phase difference between the voltage and the current at the output pins is large enough, zero crossing
type SSRs cannot be used. The result, if zero crossing SSRs are used under this condition, is that the SSR
may not turn on and off irregardless of the input current. In this case, only a non zero cross type SSR should
be used in combination with the above mentioned snubber circuit selection process.
When the input current (IF) is below 0.1mA, the output Triac will be in the open circuit mode. However, if the
voltage across the Triac, VD, increases faster than rated dV/dt, the Triac may turn on. To avoid this situation,
please incorporate a snubber circuit. Due to the many different types of load that can be driven, we can
merely recommend some circuit values to start with : Cs=0.022F and Rs=47. The operation of the SSR
and snubber circuit should be tested and if unintentional switching occurs, please adjust the snubber circuit
component values accordingly.
When making the transition from On to Off state, a snubber circuit should be used ensure that sudden drops
in current are not accompanied by large instantaneous changes in voltage across the Triac.
This fast change in voltage is brought about by the phase difference between current and voltage.
Primarily, this is experienced in driving loads which are inductive such as motors and solenods.
Following the procedure outlined above should provide sufficient results.
For over voltage protection, a Varistor may be used.
Any snubber or Varistor used for the above mentioned scenarios should be located as close to the main
output triac as possible.
All pins shall be used by soldering on the board. (Socket and others shall not be used.)
● Degradation
In general, the emission of the IRED used in SSR will degrade over time.
In the case where long term operation and / or constant extreme temperature fluctuations will be applied to
the devices, please allow for a worst case scenario of 50% degradation over 5years.
Therefore in order to maintain proper operation, a design implementing these SSRs should provide at least
twice the minimum required triggering current from initial operation.
● Recommended Operating Conditions
Parameter
Symbol
Unit
Input
Output
Input signal current at ON state
Input signal current at OFF state
Load supply voltage
Load supply current
Frequency
Operating temperature
IF(ON)
IF(OFF)
VOUT(rms)
IOUT(rms)
f
Topr
mA
V
mA
Hz
C
Locate snubber circuit between output terminals
(Cs
=0.022F, Rs=47)
Conditions
20
0
50
20
25
0.1
120
240
IT(rms)
×80%()
60
80
MIN.
MAX.
() See Fig.2 about derating curve (IT(rms) vs. ambient temperature).
S101DH2
S201DH2
相关PDF资料 |
PDF描述 |
|---|---|
| SFH300 | PHOTO TRANSISTOR DETECTOR |
| SSI/5/ALGAASRD | T-1 3/4 SINGLE COLOR LED, RED, 5 mm |
| STR/LH/8/110/REF1/H/ALGAASRD | T-3 SINGLE COLOR LED, RED, 8 mm |
| S9270 | PHOTO DIODE |
| SLI-343MCT32 | T-1 SINGLE COLOR LED, YELLOW GREEN, 3.1 mm |
相关代理商/技术参数 |
参数描述 |
|---|---|
| S201DL | 功能描述:电容套件 CAP AND IND DSGN KIT 0.2pF-1000pF 50pcs RoHS:否 制造商:Nichicon 电容范围:10 uF to 680 uF 公差范围: 电压范围:6.3 V to 25 V 产品:Aluminum Organic Polymer Capacitor Kit |
| S201DL | 制造商:Johanson Technology Inc 功能描述:L SERIES DESIGNER KIT, 0201 |
| S201E | 功能描述:SCR 1A 200V RoHS:否 制造商:STMicroelectronics 最大转折电流 IBO:480 A 额定重复关闭状态电压 VDRM:600 V 关闭状态漏泄电流（在 VDRM IDRM 下）:5 uA 开启状态 RMS 电流 (It RMS): 正向电压下降:1.6 V 栅触发电压 (Vgt):1.3 V 最大栅极峰值反向电压:5 V 栅触发电流 (Igt):35 mA 保持电流（Ih 最大值）:75 mA 安装风格:Through Hole 封装 / 箱体:TO-220 封装:Tube |
| S201ERP | 功能描述:SCR 200V 1A TO92 RoHS:否 类别:分离式半导体产品 >> SCR - 单个 系列:- 其它有关文件:X00619 View All Specifications 产品目录绘图:SCR TO-92 Package 标准包装:1 系列:- SCR 型:灵敏栅极 电压 - 断路:600V 电压 - 栅极触发器 (Vgt)（最大）:800mV 电压 - 导通状态 (Vtm)（最大）:1.35V 电流 - 导通状态 (It (AV))（最大）:500mA 电流 - 导通状态 (It (RMS))（最大）:800mA 电流 - 栅极触发电流 (Igt)（最大）:200µA 电流 - 维持(Ih):5mA 电流 - 断开状态（最大）:1µA 电流 - 非重复电涌，50、60Hz (Itsm):9A，10A 工作温度:-40°C ~ 125°C 安装类型:通孔 封装/外壳:TO-226-3、TO-92-3（TO-226AA）成形引线 供应商设备封装:TO-92-3 包装:剪切带 (CT) 产品目录页面:1554 (CN2011-ZH PDF) 其它名称:497-9067-1 |
| S201-K0.5 | 制造商:ABB Low Voltage Products and Systems 功能描述:Circuit Breaker, Supplementary, K Curve, 1-Pole, 0.5A, 480Y/277 VAC, UL1077, DIN |
发布紧急采购，3分钟左右您将得到回复。