- 您现在的位置：买卖IC网 > PDF目录69330 > SAB-C501G-L40P (INFINEON TECHNOLOGIES AG) 8-BIT, 40 MHz, MICROCONTROLLER, PDIP40 PDF资料下载
参数资料
| 型号： | SAB-C501G-L40P |
| 厂商： | INFINEON TECHNOLOGIES AG |
| 元件分类： | 微控制器/微处理器 |
| 英文描述： | 8-BIT, 40 MHz, MICROCONTROLLER, PDIP40 |
| 封装： | PLASTIC, DIP-40 |
| 文件页数： | 26/48页 |
| 文件大小： | 319K |
| 代理商： | SAB-C501G-L40P |
第1页第2页第3页第4页第5页第6页第7页第8页第9页第10页第11页第12页第13页第14页第15页第16页第17页第18页第19页第20页第21页第22页第23页第24页第25页当前第26页第27页第28页第29页第30页第31页第32页第33页第34页第35页第36页第37页第38页第39页第40页第41页第42页第43页第44页第45页第46页第47页第48页
C501
Semiconductor Group
32
1997-04-01
Notes:
1)
Capacitive loading on ports 0 and 2 may cause spurious noise pulses to be superimposed on the
VOL of ALE
and port 3. The noise is due to external bus capacitance discharging into the port 0 and port 2 pins when these
pins make 1-to-0 transitions during bus operation. In the worst case (capacitive loading > 100 pF), the noise
pulse on ALE line may exceed 0.8 V. In such cases it may be desirable to qualify ALE with a schmitt-trigger,
or use an address latch with a schmitt-trigger strobe input.
2)
Capacitive loading on ports 0 and 2 may cause the
VOH on ALE and PSEN to momentarily fall bellow the
0.9
VCC specification when the address lines are stabilizing.
3)
IPD (Power Down Mode) is measured under following conditions:
EA = Port0 = VCC; RESET = VSS; XTAL2 = N.C.; XTAL1 = VSS; all other pins are disconnected.
4)
ICC (active mode) is measured with:
XTAL1 driven with
tCLCH, tCHCL = 5 ns, VIL = VSS + 0.5 V, VIH = VCC – 0.5 V; XTAL2 = N.C.;
EA = Port0 = RESET=
VCC; all other pins are disconnected. ICC would be slightly higher if a crystal oscillator is
used (appr. 1 mA).
5)
ICC (Idle mode) is measured with all output pins disconnected and with all peripherals disabled;
XTAL1 driven with
tCLCH, tCHCL = 5 ns, VIL = VSS + 0.5 V, VIH = VCC – 0.5 V; XTAL2 = N.C.;
RESET = EA =
VSS; Port0 = VCC; all other pins are disconnected;
7)
ICC max at other frequencies is given by:
active mode:
ICC = 1.27 x fOSC + 5.73
idle mode:
ICC = 0.28 x fOSC + 1.45 (C501-L and C501-1R only)
where
fOSC is the oscillator frequency in MHz. ICC values are given in mA and measured at VCC = 5 V.
相关PDF资料 |
PDF描述 |
|---|---|
| SAB-C501G-LM | 8-BIT, 12 MHz, MICROCONTROLLER, PQFP44 |
| SAB-C501G-1E24N | 8-BIT, OTPROM, 24 MHz, MICROCONTROLLER, PQCC44 |
| SAF-C501G-1EN | 8-BIT, OTPROM, 12 MHz, MICROCONTROLLER, PQCC44 |
| SAF-C501G-1EP | 8-BIT, OTPROM, 12 MHz, MICROCONTROLLER, PDIP40 |
| SAF-C501G-1R24P | 8-BIT, MROM, 24 MHz, MICROCONTROLLER, PDIP40 |
相关代理商/技术参数 |
参数描述 |
|---|---|
| SAB-C501G-LM | 制造商:INFINEON 制造商全称:Infineon Technologies AG 功能描述:8-Bit CMOS Microcontroller |
| SAB-C501G-LN | 制造商:Siemens 功能描述:8-BIT, 12 MHz, MICROCONTROLLER, PQCC44 |
| SABC501G-LN | 制造商:Siemens 功能描述:MicroController, 8-Bit, 44 Pin, Plastic, PLCC |
| SABC501GLP | 制造商:Infineon Technologies AG 功能描述:8bit MCU, CISC, ROMLESS, C500 Family |
| SAB-C501G-LP | 制造商:INFINEON 制造商全称:Infineon Technologies AG 功能描述:8-Bit CMOS Microcontroller |
发布紧急采购，3分钟左右您将得到回复。