- 您现在的位置：买卖IC网 > PDF目录98073 > SAB-XC167CI-16F20F (INFINEON TECHNOLOGIES AG) 16-BIT, FLASH, 20 MHz, MICROCONTROLLER, PQFP144 PDF资料下载
参数资料
| 型号： | SAB-XC167CI-16F20F |
| 厂商： | INFINEON TECHNOLOGIES AG |
| 元件分类： | 微控制器/微处理器 |
| 英文描述： | 16-BIT, FLASH, 20 MHz, MICROCONTROLLER, PQFP144 |
| 封装： | 0.50 MM PITCH, PLASTIC, TQFP-144 |
| 文件页数： | 52/80页 |
| 文件大小： | 2477K |
| 代理商： | SAB-XC167CI-16F20F |
第1页第2页第3页第4页第5页第6页第7页第8页第9页第10页第11页第12页第13页第14页第15页第16页第17页第18页第19页第20页第21页第22页第23页第24页第25页第26页第27页第28页第29页第30页第31页第32页第33页第34页第35页第36页第37页第38页第39页第40页第41页第42页第43页第44页第45页第46页第47页第48页第49页第50页第51页当前第52页第53页第54页第55页第56页第57页第58页第59页第60页第61页第62页第63页第64页第65页第66页第67页第68页第69页第70页第71页第72页第73页第74页第75页第76页第77页第78页第79页第80页
XC167
Derivatives
Electrical Parameters
Data Sheet
52
V1.1, 2003-06
Preliminary
Configuration pull-down
current11)
ICPDL
–10
A
VIN = VILmax
ICPDH
120
–
A
VIN = VIHmin
Level inactive hold current12)
ILHI
–-10
A
VOUT =
0.5
× V
DDP
Level active hold current12)
ILHA
-100
–
A
VOUT = 0.45 V
XTAL1, XTAL3 input current
IIL
CC –
±20
A0 V < V
IN < VDDI
Pin capacitance13)
(digital inputs/outputs)
CIO CC –
10
pF
1)
Keeping signal levels within the limits specified in this table, ensures operation without overload conditions.
For signal levels outside these specifications, also refer to the specification of the overload current
IOV.
2)
If XTAL3 is driven by a crystal, reaching an amplitude (peak to peak) of 0.25
× V
DDI is sufficient.
3)
This parameter is tested for P2, P3, P4, P6, P7, P9.
4)
The maximum deliverable output current of a port driver depends on the selected output driver mode, see
Table 12, Current Limits for Port Output Drivers. The limit for pin groups must be respected.
5)
As a rule, with decreasing output current the output levels approach the respective supply level (
VOL→VSS,
VOH→VDDP). However, only the levels for nominal output currents are guaranteed.
6)
This specification is not valid for outputs which are switched to open drain mode. In this case the respective
output will float and the voltage results from the external circuitry.
7)
An additional error current (
IINJ) will flow if an overload current flows through an adjacent pin. Please refer to
the definition of the overload coupling factor KOV.
8)
This specification is valid during Reset for configuration on RD, WR, EA, PORT0.
The pull-ups on RD and WR (WRL/WRH) are also active during bus hold.
9)
The maximum current may be drawn while the respective signal line remains inactive.
10) The minimum current must be drawn to drive the respective signal line active.
11) This specification is valid during Reset for configuration on ALE.
The pull-down on ALE is also active during bus hold.
12) This specification is valid during Reset for pins P6.4-0, which can act as CS outputs.
The pull-ups on CS outputs are also active during bus hold.
13) Not 100% tested, guaranteed by design and characterization.
DC Characteristics (cont’d)
(Operating Conditions apply)1)
Parameter
Symbol
Limit Values
Unit Test Condition
min.
max.
相关PDF资料 |
PDF描述 |
|---|---|
| SAB16C450-N | 1 CHANNEL(S), 512K bps, SERIAL COMM CONTROLLER, PQCC44 |
| SAB16C450-P | 1 CHANNEL(S), 512K bps, SERIAL COMM CONTROLLER, PDIP40 |
| SAB80186-1-N | 16-BIT, 10 MHz, MICROPROCESSOR, PQCC68 |
| SAB80186-N | 16-BIT, 8 MHz, MICROPROCESSOR, PQCC68 |
| SAB8032B-20-N | 8-BIT, 20 MHz, MICROCONTROLLER, PQCC44 |
相关代理商/技术参数 |
参数描述 |
|---|---|
| SAB-XC167CI-16F40F | 制造商:INFINEON 制造商全称:Infineon Technologies AG 功能描述:16-Bi t Single-Chip Microcontroller Preliminary |
| SAC | 制造商:TSC 制造商全称:Taiwan Semiconductor Company, Ltd 功能描述:Low Capacitance Transient Voltage Suppressor Diodes |
| SAC 8250 | 制造商:Edsyn International 功能描述:Bulk |
| SAC+0107 | 制造商:AIM Metals & Alloys LP 功能描述:Solder Bar-2.5lbs. 制造商:AIM PRODUCTS LLC. 功能描述:Solder Bar-2.5lbs. |
| SAC01UPAK | 制造商:Samson Technologies 功能描述:PODCASTING PACKAGE WITH CO1 MICROPHONE 制造商:Samson Technologies 功能描述:Podcasting Package with C01U Microphone |
发布紧急采购，3分钟左右您将得到回复。