参数资料
型号: SAF-XC2220U-8F66V
厂商: INFINEON TECHNOLOGIES AG
元件分类: 微控制器/微处理器
英文描述: 32-BIT, FLASH, 66 MHz, RISC MICROCONTROLLER, PQCC48
封装: 0.50 MM PITCH, GREEN, PLASTIC, VQFN-48
文件页数: 87/106页
文件大小: 3017K
代理商: SAF-XC2220U-8F66V
XC2220U
XC2000 Family / Compact Line
Electrical Parameters
PRELIMINARY
Data Sheet
77
V1.0, 2010-12
The timing in the AC Characteristics refers to TCSs. Timing must be calculated using the
minimum TCS possible under the given circumstances.
The actual minimum value for TCS depends on the jitter of the PLL. Because the PLL is
constantly adjusting its output frequency to correspond to the input frequency (from
crystal or oscillator), the accumulated jitter is limited. This means that the relative
deviation for periods of more than one TCS is lower than for a single TCS (see formulas
and Figure 16).
This is especially important for bus cycles using waitstates and for the operation of
timers, serial interfaces, etc. For all slower operations and longer periods (e.g. pulse train
generation or measurement, lower baudrates, etc.) the deviation caused by the PLL jitter
is negligible.
The value of the accumulated PLL jitter depends on the number of consecutive VCO
output cycles within the respective timeframe. The VCO output clock is divided by the
output prescaler K2 to generate the system clock signal
f
SYS. The number of VCO cycles
is K2
× T, where T is the number of consecutive f
SYS cycles (TCS).
The maximum accumulated jitter (long-term jitter) DTmax is defined by:
DTmax [ns] = ±(220 / (K2 × fSYS) + 4.3)
This maximum value is applicable, if either the number of clock cycles T > (
f
SYS / 1.2) or
the prescaler value K2 > 17.
In all other cases for a timeframe of T
× TCS the accumulated jitter D
T is determined by:
DT [ns] = DTmax × [(1 - 0.058 × K2) × (T - 1) / (0.83 × fSYS - 1) + 0.058 × K2]
f
SYS in [MHz] in all formulas.
Example, for a period of 3 TCSs @ 33 MHz and K2 = 4:
Dmax = ±(220 / (4 × 33) + 4.3) = 5.97 ns (Not applicable directly in this case!)
D3 = 5.97 × [(1 - 0.058 × 4) × (3 - 1) / (0.83 × 33 - 1) + 0.058 × 4]
= 5.97
× [0.768 × 2 / 26.39 + 0.232]
= 1.7 ns
Example, for a period of 3 TCSs @ 33 MHz and K2 = 2:
Dmax = ±(220 / (2 × 33) + 4.3) = 7.63 ns (Not applicable directly in this case!)
D3 = 7.63 × [(1 - 0.058 × 2) × (3 - 1) / (0.83 × 33 - 1) + 0.058 × 2]
= 7.63
× [0.884 × 2 / 26.39 + 0.116]
= 1.4 ns
相关PDF资料
PDF描述
SAH-XC2220U-4F66V 32-BIT, FLASH, 66 MHz, RISC MICROCONTROLLER, PQCC48
SAF-XC2224L-12F66V 32-BIT, FLASH, 66 MHz, RISC MICROCONTROLLER, PQCC48
SAF-XC2224L-20F66V 32-BIT, FLASH, 66 MHz, RISC MICROCONTROLLER, PQCC48
SAH-XC2224L-12F66V 32-BIT, FLASH, 66 MHz, RISC MICROCONTROLLER, PQCC48
SAF-XC2220L-20F66V 32-BIT, FLASH, 66 MHz, RISC MICROCONTROLLER, PQCC48
相关代理商/技术参数
参数描述
SAF-XC2336A-56F80L AA 功能描述:16位微控制器 - MCU 16Bit Sngl-Chip MCU w/32Bit Perform RoHS:否 制造商:Texas Instruments 核心:RISC 处理器系列:MSP430FR572x 数据总线宽度:16 bit 最大时钟频率:24 MHz 程序存储器大小:8 KB 数据 RAM 大小:1 KB 片上 ADC:Yes 工作电源电压:2 V to 3.6 V 工作温度范围:- 40 C to + 85 C 封装 / 箱体:VQFN-40 安装风格:SMD/SMT
SAF-XC2336A-72F80L AA 功能描述:16位微控制器 - MCU 16Bit Sngl-Chip MCU w/32Bit Perform RoHS:否 制造商:Texas Instruments 核心:RISC 处理器系列:MSP430FR572x 数据总线宽度:16 bit 最大时钟频率:24 MHz 程序存储器大小:8 KB 数据 RAM 大小:1 KB 片上 ADC:Yes 工作电源电压:2 V to 3.6 V 工作温度范围:- 40 C to + 85 C 封装 / 箱体:VQFN-40 安装风格:SMD/SMT
SAF-XC2365-48F66L 制造商:INFINEON 制造商全称:Infineon Technologies AG 功能描述:16/32-Bit Single-Chip Microcontroller with 32-Bit Performance
SAF-XC2365-56F66L 制造商:INFINEON 制造商全称:Infineon Technologies AG 功能描述:16/32-Bit Single-Chip Microcontroller with 32-Bit Performance
SAF-XC2365-72F66L 制造商:INFINEON 制造商全称:Infineon Technologies AG 功能描述:16/32-Bit Single-Chip Microcontroller with 32-Bit Performance