参数资料
| 型号： | SC4620MLTRT |
| 厂商： | Semtech |
| 文件页数： | 11/19页 |
| 文件大小： | 0K |
| 描述： | IC REG BUCK ADJ 2.5A 20MLPQ |
| 标准包装： | 1 |
| 类型： | 降压（降压） |
| 输出类型： | 可调式 |
| 输出数： | 1 |
| 输出电压： | 0.5 V ~ 5.5 V |
| 输入电压： | 2.3 V ~ 5.5 V |
| PWM 型： | 电压模式 |
| 频率 - 开关： | 200kHz ~ 2MHz |
| 电流 - 输出： | 2.5A |
| 同步整流器： | 无 |
| 工作温度： | -40°C ~ 85°C |
| 安装类型： | 表面贴装 |
| 封装/外壳： | 20-MLPQ |
| 包装： | 标准包装 |
| 供应商设备封装： | 20-MLPQ（4x4） |
| 其它名称： | SC4620MLDKR |
SC4620
POWER MANAGEMENT
Application Information
Overview
The SC4620 is a programmable high switching frequency,
integrated 2.5A MOSFET, synchronous step down regula-
tor. This reduces external component count and makes it
effective for applications which are low in cost and sized
small. A non-overlap protection is provided for the gate
drive signals to prevent shoot through of the internal
MOSFET pair.
The SC4620 is capable of producing an output voltage as
low as 0.5V and Its operation frequency is programmable
up to 2MHz by an external resistor. It features lossless
current sensing of the voltage drop across the internal
drain to source resistance of the high side MOSFET during
its conduction period.
The quiescent supply current in shutdown mode is
typically lower than 1μA. An external soft start is provided
to prevent output voltage overshoot during start-up. Over
Temperature Protection, Power Good Indicator, External
Clock Synchronization are some of the internal added
features.
During start up or restart, A typical 4μA sourcing current
charges the capacitor and then the voltage of capacitor
ramp up the error amp reference slowly. The closed
loop creates narrow width driver pulses while the output
voltage is low and allows these pulses to increase to their
steady state duty cycle as the output voltage reaches
its regulated value. The duration of the soft start in the
SC4620 is controlled by an external capacitor.
The SC4620 starts up in asynchronous mode before SS
voltage reaches to 0.5V, and the bottom FET diode is used
for circulating current during the top FET off time. Ths SS
voltage level is clamped at V CC finally.
Oscillator
The FS pin is used to set the PWM oscillator frequency
through an external resistor that is connected from the
FS pin to the AGND. The internal ramp is a triangle at the
PWM frequency with a peak voltage of 1.25V and a valley
voltage of 0.25V. The approximate operating frequency is
determined by the value of an external resistor as shown
in Figure 15.
Enable
The SC4620 is enabled by applying a voltage greater than
2V (typical) to the V CC and SYNC/EN pin. The voltage on
the V CC pin determines the operation of the SC4620. As
V CC increases during start up, the UVLO block senses V CC
and keeps the high side and low side MOSFETs off and
the internal soft start voltage low until V CC reaches 2V. If
no faults are present, the SC4620 will initiate a soft start
when V CC exceeds 2V. A typical 120mV hysteresis in the
UVLO comparator provides noise immunity during its start
up. (refer to Figure 1 to 2).
145
135
125
115
105
95
85
75
65
55
45
35
25
Switching Frequency Setting
5VIN
2.5VIN
Shutdown
The SC4620 is disabled when V CC falls below 1.88V (typical)
or shutdown mode operation is invoked by clamping the
SYNC/EN pin to a voltage below 0.8V. During the shutdown
mode, A typical 0.2μA current draw through the V CC pin,
the internal soft start voltage is held low and the internal
MOSFETs are turned off. (refer to Figure 3 to 4).
15
5
200
400 600 800 1000 1200 1400 1600 1800
F osc (kHz)
Figure 15. Switching Frequency vs. R FS
2000
Soft Start
The soft start function is required for step down controllers
to prevent excess in-rush current through the DC bus
during start up. An external capacitor is necessary for
the soft start function and is connected from SS pin to
AGND.
The operation frequency can be programmed up to 2MHz,
but there is a minimum on-time limitation which is around
110ns. Users should take care of minimum limitation on the
operating duty cycle under high frequency application.
? 2008 Semtech Corp.
11
www.semtech.com
相关PDF资料 |
PDF描述 |
|---|---|
| SC4624AMLTRT | IC REG BUCK ADJ 4A 20MLPQ |
| SC4626HSKTRT | IC REG BUCK SYNC 1.5V 1A SOT23-5 |
| SC470ITSTRT | IC REG CTRLR BUCK PWM 14-TSSOP |
| SC493ULTRT | IC REG CTRLR BUCK PWM MLPQ-20 |
| SC553ISKTRT | IC REG LDO ADJ .15A SOT-23-5 |
相关代理商/技术参数 |
参数描述 |
|---|---|
| SC4624 | 制造商:SEMTECH 制造商全称:Semtech Corporation 功能描述:Low Input Voltage, High Efficiency, 4A Integrated FET Synchronous Step down DC/DC Regulator |
| SC4624_08 | 制造商:SEMTECH 制造商全称:Semtech Corporation 功能描述:Low Input Voltage, High Efficiency, 4A Integrated FET Synchronous Step down DC/DC Regulator |
| SC4624A | 制造商:SEMTECH 制造商全称:Semtech Corporation 功能描述:Low Input Voltage, High Efficiency, 4A Integrated FET Synchronous Step down DC/DC Regulator |
| SC4624AEVB-MLPQ | 制造商:SEMTECH 制造商全称:Semtech Corporation 功能描述:Low Input Voltage, High Efficiency, 4A Integrated FET Synchronous Step down DC/DC Regulator |
| SC4624AMLTRT | 功能描述:IC REG BUCK ADJ 4A 20MLPQ RoHS:是 类别:集成电路 (IC) >> PMIC - 稳压器 - DC DC 开关稳压器 系列:- 标准包装:50 系列:- 类型:升压（升压） 输出类型:可调式 输出数:1 输出电压:5 V ~ 25 V 输入电压:2.3 V ~ 5.5 V PWM 型:电流模式 频率 - 开关:600kHz，1.2MHz 电流 - 输出:1A 同步整流器:无 工作温度:-40°C ~ 85°C 安装类型:表面贴装 封装/外壳:8-TSSOP，8-MSOP（0.118"，3.00mm 宽） 包装:管件 供应商设备封装:8-MSOP |
发布紧急采购，3分钟左右您将得到回复。