参数资料
型号: SFPA32GBQ1BO8TO-I-QT-223-STD
厂商: Swissbit NA Inc
文件页数: 23/76页
文件大小: 0K
描述: FLASH SSD SMART UDMA 2.5" 32GB
视频文件: Swissbit Manufacturing Overview
RoHS指令信息: Environment Protection Declaration
标准包装: 4
系列: P-120
存储容量: 32GB
存储器类型: FLASH
其它名称: 1052-1027
Figure 6: Ultra DMA Data-In Burst Device Termination Timing
Notes: The definitions for the STOP, HDMARDY, and DSTROBE signal lines are no longer in effect after DMARQ
and DMACK are negated.
6.3.2.4.5 Host Terminating an Ultra DMA Data-In Burst
The host terminates an Ultra DMA Data-In burst by following the steps lettered below. The timing
diagram is shown in Figure 7: Ultra DMA Data-In Burst Host Termination Timing. The timing
parameters are specified in Table 22: Ultra DMA Data Burst Timing Requirements and are
The following steps shall occur in the order they are listed unless otherwise specifically allowed:
a) The host shall not initiate Ultra DMA burst termination until at least one data word of an Ultra DMA
burst has been transferred.
b) The host shall initiate Ultra DMA burst termination by negating -HDMARDY. The host shall continue
to negate -HDMARDY until the Ultra DMA burst is terminated.
c) The device shall stop generating DSTROBE edges within t RFS of the host negating -HDMARDY
d) If the host negates -HDMARDY within t SR after the device has generated a DSTROBE edge, then the
host shall be prepared to receive zero or one additional data words. If the host negates
HDMARDYgreater than t SR after the device has generated a DSTROBE edge, then the host shall be
prepared to receive zero, one or two additional data words. The additional data words are a result
of cable round trip delay and t RFS timing for the device.
e) The host shall assert STOP no sooner than t RP after negating -HDMARDY. The host shall not negate
STOP again until after the Ultra DMA burst is terminated.
f)
The device shall negate DMARQ within t LI after the host has asserted STOP. The device shall not assert
DMARQ again until after the Ultra DMA burst is terminated.
g) If DSTROBE is negated, the device shall assert DSTROBE within t LI after the host has asserted STOP. No
data shall be transferred during this assertion. The host shall ignore this transition on DSTROBE.
DSTROBE shall remain asserted until the Ultra DMA burst is terminated.
h) The device shall release D[15:00] no later than t AZ after negating DMARQ.
i) The host shall drive DD D[15:00] no sooner than t ZAH after the device has negated DMARQ. For this
step, the host may first drive D[15:00] with the result of its CRC calculation (see 6.3.2.5 ).
Swissbit AG
Industriestrasse 4
Swissbit reserves the right to change products or specifications without notice.
Revision: 1.00
CH-9552 Bronschhofen
Switzerland
www.swissbit.com
industrial@swissbit.com
P-120_data_sheet_PA-QxBO_Rev100.doc
Page 23 of 76
相关PDF资料
PDF描述
SFPK-SL CONN SFP CAGE
SFSA16GBV1BR4TO-I-QT-226-STD FLASH SLC UDMA/MDMA/PIO 16GB
SFSA32GBQ1BR8TO-I-QT-226-STD FLASH SLC UDMA/MDMA/PIO 32GB
SFSA32GBU1BR4TO-I-NC-216-STD FLASH X-200M SLC MSATA 32GB
SFSA32GBV1BR4TO-I-NC-216-STD FLASH X-200S SLC SLIM SATA 32GB
相关代理商/技术参数
参数描述
SFPA32GBQ1BO8TO-I-QT-243-STD 制造商:SWISSBIT NA INC 功能描述:FLASH
SFPA36AT0250 制造商:General Electric Company 功能描述:SFP 3P 600V 250A
SFPA4096Q1BO2TO-C-DT-243-STD 制造商:SWISSBIT NA INC 功能描述:FLASH
SFPA4096Q1BO2TO-I-DT-223-STD 功能描述:FLASH SSD SMART UDMA 2.5" 4GB RoHS:是 类别:计算机,办公室 - 元件,配件 >> 固态硬盘驱动器 系列:P-120 标准包装:1 系列:- 存储容量:64GB 存储器类型:闪存 - NAND 其它名称:VL 64 GB SSHD KITVL64GBSSHDKIT
SFPA4096Q1BO2TO-I-DT-243-STD 制造商:SWISSBIT NA INC 功能描述:FLASH