- 您现在的位置：买卖IC网 > PDF目录10954 > SI3000-C-FS (Silicon Laboratories Inc)IC VOICE CODEC 3.3V/5V 16SOIC PDF资料下载
参数资料
| 型号： | SI3000-C-FS |
| 厂商： | Silicon Laboratories Inc |
| 文件页数： | 6/34页 |
| 文件大小： | 0K |
| 描述： | IC VOICE CODEC 3.3V/5V 16SOIC |
| 标准包装： | 48 |
| 类型： | 语音频带编解码器 |
| 数据接口： | 串行 |
| 分辨率（位）： | 16 b |
| ADC / DAC 数量： | 1 / 1 |
| 三角积分调变： | 无 |
| 动态范围，标准 ADC / DAC (db)： | 84 / 84 |
| 电压 - 电源，模拟： | 3 V ~ 5.25 V |
| 电压 - 电源，数字： | 3 V ~ 5.25 V |
| 工作温度： | 0°C ~ 70°C |
| 安装类型： | 表面贴装 |
| 封装/外壳： | 16-SOIC（0.154"，3.90mm 宽） |
| 供应商设备封装： | 16-SOIC N |
| 包装： | 管件 |
| 产品目录页面： | 627 (CN2011-ZH PDF) |
| 其它名称： | 336-1382 SI3000-C-FS-ND |
第1页第2页第3页第4页第5页当前第6页第7页第8页第9页第10页第11页第12页第13页第14页第15页第16页第17页第18页第19页第20页第21页第22页第23页第24页第25页第26页第27页第28页第29页第30页第31页第32页第33页第34页
Si3000
14
Rev. 1.4
2. Functional Description
The Si3000 is a highly integrated voice bandwidth audio
codec which contains a single 16-bit A/D converter and
D/A converter. The analog input path contains a
microphone input with selectable gain, a line level input
with selectable gain, and a handset input. Each of the
inputs go through a mixer prior to A/D conversion. The
result of this A/D conversion is a 16-bit 2s complement
signed number. Following the A/D converter is a digital
programmable gain amplifier. The analog output path
contains a digital programmable gain amplifier feeding a
single 16-bit D/A converter. The DAC output is provided
to a line output, a headphone drive output, and a
handset output. Control for the various functions
available on the Si3000 as well as the audio data are
communicated to the device over a serial interface.
The Si3000 can be connected directly to the Si3035,
Si3034, Si3044, or Si3056 in modem applications
requiring a voice channel, or the device can be used as
a stand-alone codec in other voice band applications.
The Si3000 offers high integration, and it needs only a
few low-cost, discrete components as shown in
2.1. Analog Inputs
The typical connection diagram (Figure 13) shows the
recommended external analog circuitry for the Si3000.
The device supports three mono analog inputs—line
level, microphone level, and a handset input. Each of
these inputs is provided to a mixer circuit prior to A/D
conversion. Each analog input may also be muted by
writing the appropriate bits in the control registers.
Unused analog inputs should be tied to GND through a
0.1
F capacitor. This prevents any DC current flow.
2.2. Pre-amp/Microphone Bias Circuit
An internal amplifier with a selectable gain of 0 dB,
10 dB, 20 dB, or 30 dB is provided for the MIC input and
an internal amplifier with a selectable gain of 0 dB,
10 dB, or 20 dB, is provided for the LINEI input. AC
coupling is required for both inputs because any DC
offset on the input will be amplified if gain is selected.
Gain settings for the LINEI and MIC inputs are achieved
by writing the RX Gain Control 1 register 5. When gain
is disabled, these inputs become line level inputs with a
full-scale input of 1 Vrms.
A microphone bias circuit is provided on-chip which
consists of a 2.5 V reference output capable of sourcing
up to 5 mA of current. This circuit can be used for active
microphones requiring a bias source.
2.3. Programmable Input Gain/Attenuation
The signals from the microphone, line, or handset inputs
are mixed and then routed to the A/D converter and a
digital programmable gain circuit which provides up to
12 dB of gain or –34.5 dB of attenuation in 1.5 dB steps.
Level changes only take effect on zero crossings to
minimize audible artifacts. The requested level change
is implemented if no zero crossing is found after 256
frames. Write the ADC Volume Control register 6 to set
digital input gain/attenuation.
2.4. Analog Outputs
The analog outputs of the D/A converter are routed to a
line level output (LINEO), a pair of speaker outputs
(SPKRL and SPKRR), and a handset. Each analog
output can be independently muted.
Figure 14. Si3000 with Silicon Labs DAA System Diagram
DSP
DAA
System-Side
Device
Si3000
Voice Codec
Discretes
SPKR
Handset
Line
TIP
RING
Mic
Si3034/35/44/56 Chipsets
DAA
Line-Side
Device
相关PDF资料 |
PDF描述 |
|---|---|
| VI-23T-IY-F1 | CONVERTER MOD DC/DC 6.5V 50W |
| VE-BVL-IX-B1 | CONVERTER MOD DC/DC 28V 75W |
| VI-23P-IY-F2 | CONVERTER MOD DC/DC 13.8V 50W |
| VE-BVK-IX-B1 | CONVERTER MOD DC/DC 40V 75W |
| VI-23N-IY-F3 | CONVERTER MOD DC/DC 18.5V 50W |
相关代理商/技术参数 |
参数描述 |
|---|---|
| SI3000-C-FSR | 功能描述:接口—CODEC Voice Codec Integrated RoHS:否 制造商:Texas Instruments 类型: 分辨率: 转换速率:48 kSPs 接口类型:I2C ADC 数量:2 DAC 数量:4 工作电源电压:1.8 V, 2.1 V, 2.3 V to 5.5 V 最大工作温度:+ 85 C 安装风格:SMD/SMT 封装 / 箱体:DSBGA-81 封装:Reel |
| Si3000-C-GS | 功能描述:接口—CODEC Voice Codec w/Intgrt Mic/Spk Drv/Hndst Hy RoHS:否 制造商:Texas Instruments 类型: 分辨率: 转换速率:48 kSPs 接口类型:I2C ADC 数量:2 DAC 数量:4 工作电源电压:1.8 V, 2.1 V, 2.3 V to 5.5 V 最大工作温度:+ 85 C 安装风格:SMD/SMT 封装 / 箱体:DSBGA-81 封装:Reel |
| SI3000-C-GSR | 功能描述:接口—CODEC Voice Codec Integrated RoHS:否 制造商:Texas Instruments 类型: 分辨率: 转换速率:48 kSPs 接口类型:I2C ADC 数量:2 DAC 数量:4 工作电源电压:1.8 V, 2.1 V, 2.3 V to 5.5 V 最大工作温度:+ 85 C 安装风格:SMD/SMT 封装 / 箱体:DSBGA-81 封装:Reel |
| SI-3000F | 制造商:SANKEN 制造商全称:Sanken electric 功能描述:5-Terminal, Multi-Function, Full-Mold, Low Dropout Voltage Dropper Type |
| SI3000-FS | 功能描述:接口—CODEC Int Mic/Spk/HdSt RoHS:否 制造商:Texas Instruments 类型: 分辨率: 转换速率:48 kSPs 接口类型:I2C ADC 数量:2 DAC 数量:4 工作电源电压:1.8 V, 2.1 V, 2.3 V to 5.5 V 最大工作温度:+ 85 C 安装风格:SMD/SMT 封装 / 箱体:DSBGA-81 封装:Reel |
发布紧急采购，3分钟左右您将得到回复。