- 您现在的位置：买卖IC网 > Datasheet目录57 > SI4020-I1-FT (Silicon Laboratories Inc)IC TX FSK 915MHZ 5.4V 16-TSSOP Datasheet资料下载
参数资料
| 型号： | SI4020-I1-FT |
| 厂商： | Silicon Laboratories Inc |
| 文件页数： | 14/32页 |
| 文件大小： | 1058K |
| 描述： | IC TX FSK 915MHZ 5.4V 16-TSSOP |
| 标准包装： | 96 |
| 频率： | 315MHz，433MHz，868MHz，和 915MHz |
| 调制或协议： | FSK，OOK |
| 数据传输率 - 最大： | 256 kbps |
| 电流 - 传输： | 14mA |
| 数据接口： | PCB，表面贴装 |
| 天线连接器： | PCB，表面贴装 |
| 电源电压： | 2.2 V ~ 5.4 V |
| 工作温度： | -40°C ~ 85°C |
| 封装/外壳： | 16-TSSOP（0.173"，4.40mm 宽） |
| 包装： | 管件 |
| 产品目录页面： | 585 (CN2011-ZH PDF) |
| 其它名称： | 336-1621-5 |
第1页第2页第3页第4页第5页第6页第7页第8页第9页第10页第11页第12页第13页当前第14页第15页第16页第17页第18页第19页第20页第21页第22页第23页第24页第25页第26页第27页第28页第29页第30页第31页第32页
Si4020
14
2. Power Management Command
bit 15 14 13 12 11 10
9
8
7
6
5
4
3
2
1
0
POR
1
1
0
0
0
0
0
0
a1 a0 ex es ea eb et dc
C000h
Bits 5-0, enable the corresponding block of the transmitters, i.e. the crystal oscillator is enabled by the ex bit, the synthesizer by es, the
power amplifier by ea and the low battery detector by eb, while the wake-up timer by et. The bit dc disables the clock output buffer.
When receiving the Data Transmit Command, the chip supports automatic on/off control over the crystal oscillator, the PLL and the PA.
If bit a1 is set, the crystal oscillator and the synthesizer are controlled automatically. Data Transmit Command starts up the crystal oscillator
and as soon as a stable reference frequency is available the synthesizer starts. After a subsequent delay to allow locking of the PLL, if a0 is
set the power amplifier is turned on as well.
Note:
" To enable the automatic internal control of the crystal oscillator, the synthesizer and the power amplifier, the corresponding bits
(ex, es, ea) must be zero in the Power Management Command.
" In microcontroller mode, the ex bit should be set in the Power Management Command for the correct control of es and ea. The
oscillator can be switched off by clearing the ex bit after the transmission.
" In EEPROM operation mode after an identified Data Transmit Command the internal logic switches on the synthesizer and PA. At
the end of Data Transmit Command header if necessary the current clock cycle is automatically extended to ensure the PLL
stabilization and RF power ramp-up.
" In EEPROM operation mode the internal logic switches off the PA when the given number of bytes is transmitted. (See: Data
Transmit Command in EEPROM operation.)
" When the chip is controlled by a microcontroller, the Sleep Command can be used to indicate the end of the data transmission
process, because in microcontroller mode the Data Transmit Command does not contain the length of the TX data.
" For processing the events caused by the peripheral blocks (POR, LBD, wake-up timer, push-buttons) the chip requires operation of
the crystal oscillator. This operation is fully controlled internally, independently from the status of the ex bit, but if the dc bit is zero,
the oscillator remains active until Sleep Command is issued. (This command can be considered as an event controller reset.)
Oscillator control logic
相关PDF资料 |
PDF描述 |
|---|---|
| SI4021-A1-FT | IC TX FSK 915MHZ 5.4V 16-TSSOP |
| SI4022-A0-FT | IC TX FSK UNI 868/915MHZ 16TSSOP |
| SI4711-B30-GM | IC TX FM RADIO 76-108MHZ 20UQFN |
| SI4713-B30-GMR | IC TX FM RADIO RPS/RDS 20UQFN |
| SKY12146-321LF | IC VAR VOLT ATTEN 12QFN |
相关代理商/技术参数 |
参数描述 |
|---|---|
| SI4020-I1-FTR | 功能描述:射频发射器 Transmitter EZRadio RoHS:否 制造商:Micrel 类型:ASK Transmitter 封装 / 箱体:SOT-23-6 工作频率:300 MHz to 450 MHz 封装:Reel |
| SI-40219 | 制造商:BEL 制造商全称:Bel Fuse Inc. 功能描述:SI-40219 |
| Si4021-A1-FT | 功能描述:射频发射器 Transmitters IA4221 RoHS:否 制造商:Micrel 类型:ASK Transmitter 封装 / 箱体:SOT-23-6 工作频率:300 MHz to 450 MHz 封装:Reel |
| SI4021-A1-FTR | 功能描述:射频发射器 Transmitter EZRadio RoHS:否 制造商:Micrel 类型:ASK Transmitter 封装 / 箱体:SOT-23-6 工作频率:300 MHz to 450 MHz 封装:Reel |
| SI-40222 | 制造商:BEL 制造商全称:Bel Fuse Inc. 功能描述:SI-40222 |
发布紧急采购，3分钟左右您将得到回复。