- 您现在的位置：买卖IC网 > PDF目录18849 > SI8504-B-IM (Silicon Laboratories Inc)SENSOR CURRENT 5A 5.5V UNI 12QFN PDF资料下载
参数资料
| 型号： | SI8504-B-IM |
| 厂商： | Silicon Laboratories Inc |
| 文件页数： | 11/36页 |
| 文件大小： | 0K |
| 描述： | SENSOR CURRENT 5A 5.5V UNI 12QFN |
| 标准包装： | 74 |
| 电流 - 感应： | 5A |
| 精确度： | ±5% |
| 电流 - 电源： | 4mA |
| 传感器类型： | 闭环 |
| 电源电压： | 2.7 V ~ 5.5 V |
| 输出： | 可配置 |
| 频率： | 50kHz ~ 1MHz |
| 电极标记： | 单向 |
| 工作温度： | -40°C ~ 125°C |
| 封装/外壳： | 12-VFQFN |
| 包装： | 管件 |
| 其它名称： | 336-1416-5 |
第1页第2页第3页第4页第5页第6页第7页第8页第9页第10页当前第11页第12页第13页第14页第15页第16页第17页第18页第19页第20页第21页第22页第23页第24页第25页第26页第27页第28页第29页第30页第31页第32页第33页第34页第35页第36页
Si85xx
Integrator reset Option 1 is selected by connecting T RST
to VDD. In this mode, the Si85xx is held in reset as long
as the signals on R1–R4 satisfy the logic equations of
gate drivers are external to the system controller IC (the
2.4. Total Measurement Error
The Si85xx’s absolute accuracy is affected by the
following factors:
? Ambient operating temperature
gate driver delay ensures reset is completed prior to the
start of measurement).
?
?
VDD supply voltage
Time
Reset Option 2 is selected by connecting a timing
resistor (R TRST in Figure 5) from the TRST input to
ground. It is typically used in applications where the
gate drivers are on-board the controller. In this mode,
the on-chip reset timer is triggered when the signals on
R1–R4 satisfy the logic equations in Table 11. Once
triggered, the timer maintains integrator in reset for time
duration t R as programmed by the value of resistor
R TRST . The user must select the value of resistor R TRST
to terminate the reset cycle prior to the start of
measurement under worst-case timing conditions. Note
that values of t R below the specified value in "1.
integrator output offset error and increased output noise
operating conditions that can ultimately affect the
absolute measurement accuracy of the Si85xx. The
total worst-case accuracy at full scale can be estimated
by the sum of the initial accuracy (up to ±5%) plus aging
(up to ±1.5%) and supply variations (up to ±3.5%). For
example, the total measurement error expected for a
device operating at a given V DD supply of 5 V (±10%) is
10% if the device is operated over a temperature range
of –40 to 125 °C for up to 10 years. If the temperature
range is limited to 0 to 85 °C, the measurement error
can be improved by up to 2%. See Figure 6 for details.
Table 10. Total Measurement Error Contributors
on V OUT . Moreover, t R ’s time is summarized by the
following equation (see Table 9):
t R = 10 ns/k ?
where values of R TRST that produce a reset time less
than 150 ns (R TRST < 15 k ? ) should not be used.
Si85xx
Error Contributor
Initial error
@ given V DD ±10%, 25 °C
Temperature variation
–40 to 125 °C
Aging (10 years)
% Error Added
±5%
±3.5%
±1.5%
2.5. Effect of Temperature on Accuracy
Offset voltage present at the Si85xx output terminals
TRST
R TRST
Figure 5. Programming Reset Time (t R )
Table 9. Typical Reset Time vs. R TRST
Resistance
(output offset voltage) is calibrated out each time VDD is
applied to the Si85xx; so, its error contribution is
minimized when the temperature at which calibration
occurred is at or near the steady-state operating
temperature of the Si85xx. For example, applying VDD
at 25 °C (offset cal is performed) and operating at 85 °C
will result in a larger offset error than operating at 50 °C.
The effect of this error is summarized in Figure 6. The
chart is referenced to 25 °C. If the Si85xx is powered up
at 25 °C and then operated at 125 °C with no auto-
calibration performed (i.e., the power is not cycled at
125 °C, which causes an auto-calibration), a 3%
R TRST
15 k ?
100 k ?
1 M ?
2.2 M ?
Reset Time (t R )
150 ns
1 μs
9 μs
20 μs
measurement error can be expected.
Preliminary Rev. 0.4
11
相关PDF资料 |
PDF描述 |
|---|---|
| NC6Y | KIT NANO-CLIP 6 CLIPS YELLOW |
| SI8503-B-GM | SENSOR CURR 20A 5.5V UNI 12QFN |
| V-103-1C24 | SWITCH MINI SPDT 10A HNGE LVR |
| NC6B | KIT NANO-CLIP 6 CLIPS BLACK |
| SI8502-C-GM | SENSOR CURR 10A 5.5V UNI 12QFN |
相关代理商/技术参数 |
参数描述 |
|---|---|
| Si8504-C-IM | 功能描述:板上安装电流传感器 5A Current Sensor Single Output RoHS:否 制造商:Honeywell 电流额定值:+/- 56 A 传感器/变换器类型: 电源电压:4.75 VDC to 5.25 VDC 响应时间:< 0.2 us 输出电压: 工作温度:- 40 C to + 85 C 准确性:+/- 0.24 % 频率范围: |
| SI8504-C-IMR | 制造商:Silicon Laboratories Inc 功能描述:5A CURRENT SENSOR, SINGLE OUTPUT - Tape and Reel |
| SI-8504L | 制造商:SANKEN 制造商全称:Sanken electric 功能描述:Separate Excitation Switching Type with Coil |
| Si8505-B-IM | 功能描述:板上安装电流传感器 10A Current Sensr Single Out RoHS:否 制造商:Honeywell 电流额定值:+/- 56 A 传感器/变换器类型: 电源电压:4.75 VDC to 5.25 VDC 响应时间:< 0.2 us 输出电压: 工作温度:- 40 C to + 85 C 准确性:+/- 0.24 % 频率范围: |
| Si8505-C-IM | 功能描述:板上安装电流传感器 10A Current Sensor Single Output RoHS:否 制造商:Honeywell 电流额定值:+/- 56 A 传感器/变换器类型: 电源电压:4.75 VDC to 5.25 VDC 响应时间:< 0.2 us 输出电压: 工作温度:- 40 C to + 85 C 准确性:+/- 0.24 % 频率范围: |
发布紧急采购，3分钟左右您将得到回复。