- 您现在的位置：买卖IC网 > PDF目录18848 > SI8516-C-IM (Silicon Laboratories Inc)SENSOR CURR 20A 5.5V UNI 12QFN PDF资料下载
参数资料
| 型号： | SI8516-C-IM |
| 厂商： | Silicon Laboratories Inc |
| 文件页数： | 12/36页 |
| 文件大小： | 0K |
| 描述： | SENSOR CURR 20A 5.5V UNI 12QFN |
| 标准包装： | 74 |
| 电流 - 感应： | 20A |
| 精确度： | ±5% |
| 电流 - 电源： | 4mA |
| 传感器类型： | 闭环 |
| 电源电压： | 2.7 V ~ 5.5 V |
| 输出： | 可配置 |
| 频率： | 50kHz ~ 1MHz |
| 电极标记： | 单向 |
| 工作温度： | -40°C ~ 125°C |
| 封装/外壳： | 12-VFQFN |
| 包装： | 管件 |
| 其它名称： | 336-1548-5 |
第1页第2页第3页第4页第5页第6页第7页第8页第9页第10页第11页当前第12页第13页第14页第15页第16页第17页第18页第19页第20页第21页第22页第23页第24页第25页第26页第27页第28页第29页第30页第31页第32页第33页第34页第35页第36页
Si85xx
1.0%
0.5%
0.0%
-0.5%
-1.0%
-1.5%
-2.0%
-2.5%
-3.0%
-3.5%
Current Sense
Transformer
Si8502
0
25
50
75
100
125
Temperature (Celcius)
Figure 6. Differential Temperature
Calibration Error
on-chip sense resistance over the temperature range of
–40 to +125 °C. Series inductance is constant at 2 nH
(max) across this same temperature range.
2
1.8
1.6
1.4
1.2
1
0.8
0.6
0.4
0.2
0
Figure 8. Leading-Edge Noise Suppression
Waveforms (200 kHz, 9.3 A Load)
2.7. FAULT Output
The FAULT output (Si8517/8/9) guards against Si85xx
output signal errors caused by missing reset cycles.
FAULT is asserted when a measurement cycle exceeds
the internal watchdog timer times limit of t WD . FAULT
can be used to alert a local microcontroller or digital
power controller of a current sense failure or to initiate a
system shutdown. To detect faults, tie a 200 k ? resistor
from TRST/FAULT to VDD.
-20
0
20
40 60
Temperature (°C)
80
100
120
2.8. Safe Operating Limits
Figure 7. Series Resistance Thermal
Characteristics
2.6. Leading Edge Noise Suppression
High-amplitude spikes on the leading edge of the
primary switching waveforms can cause the PWM latch
to be erroneously reset at the start of the switching cycle
when operating in current mode control. To prevent this
problem, leading edge blanking is commonly used to
disable the current comparator during the early portion
of the primary-side switching cycle. The Si85xx
eliminates leading-edge noise spikes by including them
in the signal integration. As shown in the output
waveform of Figure 8 (Si8502 waveform measured
directly on OUT pin with no external filter), noise present
in the input waveform is eliminated without the use of
blanking.
The Si85xx is a very robust current sensor. Its maximum
input current rate of change is limited to 1000 A/μs. The
maximum peak ac input current limit is 200 A. The
thermal limit or continuous dc current flow limit is 30 A.
Exceeding these limits may cause long-term reliability
issues. Refer to “AN329: Extending the Full-Scale
Range of the Si85xx” for more information.
12
Preliminary Rev. 0.4
相关PDF资料 |
PDF描述 |
|---|---|
| 3781-8-1 | CORD MINIGRABBER PATCH 8" BROWN |
| SI8513-C-GM | SENSOR CURR 20A 5.5V UNI 12QFN |
| P704-12 BLK | LEAD TEST PICO HOOK 12" BLACK |
| SI8506-C-IM | SENSOR CURR 20A 5.5V UNI 12QFN |
| SI8503-C-GM | SENSOR CURR 20A 5.5V UNI 12QFN |
相关代理商/技术参数 |
参数描述 |
|---|---|
| SI8516-C-IMR | 制造商:Silicon Laboratories Inc 功能描述:20A CURRENT SENSOR, DUAL OUTPUT - Tape and Reel |
| Si8517-B-GM | 功能描述:板上安装电流传感器 5A Current Snsr Dual Out w/FAULT out RoHS:否 制造商:Honeywell 电流额定值:+/- 56 A 传感器/变换器类型: 电源电压:4.75 VDC to 5.25 VDC 响应时间:< 0.2 us 输出电压: 工作温度:- 40 C to + 85 C 准确性:+/- 0.24 % 频率范围: |
| Si8517-C-GM | 功能描述:板上安装电流传感器 5A Current Sensor Dual w/FAULT output RoHS:否 制造商:Honeywell 电流额定值:+/- 56 A 传感器/变换器类型: 电源电压:4.75 VDC to 5.25 VDC 响应时间:< 0.2 us 输出电压: 工作温度:- 40 C to + 85 C 准确性:+/- 0.24 % 频率范围: |
| SI8517-C-GMR | 制造商:Silicon Laboratories Inc 功能描述:5A CURRENT SENSOR, DUAL OUTPUT WITH FAULT OUTPUT - Tape and Reel |
| Si8517-C-IM | 功能描述:板上安装电流传感器 5A DUAL OUTPUT 1kV W/FAULT OUTPUT RoHS:否 制造商:Honeywell 电流额定值:+/- 56 A 传感器/变换器类型: 电源电压:4.75 VDC to 5.25 VDC 响应时间:< 0.2 us 输出电压: 工作温度:- 40 C to + 85 C 准确性:+/- 0.24 % 频率范围: |
发布紧急采购，3分钟左右您将得到回复。