参数资料
型号: SI85XX5KV-EVB
厂商: Silicon Laboratories Inc
文件页数: 9/36页
文件大小: 0K
描述: EVAL BOARD FOR SI85XX5KV
标准包装: 1
传感器类型: 电流传感器
传感范围: 最高 10A
接口: 模拟
电源电压: 5V
嵌入式:
已供物品:
已用 IC / 零件: Si8512
Si85xx
2. Functional Overview
The Si85xx ac current sensor family of products mimics
the functionality of traditional current transformer (CT)
circuits with burden resistor, diode, and output filter, but
IIN
R1
R2
R3
R4
Si851x
offers enhanced performance and added capabilities.
RESET LOGIC
MODE LOGIC
MODE
These devices use inductive current sensing and on-
board signal conditioning electronics to generate a 2 V
OUT1
full-scale output signal proportional to the ac current
flowing from the IIN to the IOUT terminals. As shown in
Figures 2 and 3, current flowing through the metal
PICKUP
COIL
INTEGRATOR
SIGNAL CONDITIONING
OUT2
package slug induces a signal in the pickup coil on the
Si85xx die. This signal is applied to the input of an
integrator that reconstructs the ac current flowing from
IIN to IOUT. Onboard circuitry provides cycle-by-cycle
TEMP
SENSOR
ADC
AUTO CALIBRATION
LOGIC
integrator reset and temperature and offset voltage
compensation to achieve initial measurement accuracy
to within ±5%.
IOUT
GND
VDD
TRST/FAULT
Figure 3. Si851x (Ping Pong Output) Block
Diagram
IIN
R1
R2
Si850x
The Si85xx is superior to other current sensing
approaches and benefits the system in a number of
ways:
RESET LOGIC
VDD2
?
Small size: With its 4x4 mm footprint and 1 mm
height (QFN package option), the Si85xx is among
the smallest current sensors available.
INTEGRATOR
SIGNAL CONDITIONING
OUT
?
Large output signal: The nominal 2.0 V full-scale
output swing offers superior noise immunity versus
PICKUP
COIL
?
other current sensing technologies.
Low loss: The Si85xx adds only 1.3 m ? (at 25 °C)
to the sensing path, making it one of the lowest-loss
current sensors available. Low 2 nH primary series
TEMP
SENSOR
ADC
AUTO CALIBRATION
LOGIC
NC
inductance is 2,000 times lower compared to a CT
and results in significantly less ringing.
?
High precision: All versions are available with an
IOUT
GND2
GND1
VDD1
GND3
TRST
initial maximum error of ±5% of reading; one of the
Figure 2. Si850x (Single Output) Block Diagram
?
?
?
most accurate current sensors available.
Ping-Pong output mode (Si851x): Alternately
routes the current measurements from each side of
a full-bridge circuit to separate output pins for
comparison, which is very useful for transformer flux
balancing applications. Eliminates a second CT in a
full-bridge application.
Leading edge noise suppression: Filters out
reflected noise due to long reverse recovery time of
output rectifier. Eliminates the need for external
leading edge blanking circuit.
High common-mode voltage: The Si85xx offers a
minimum of 1,000 V RMS (for QFN package) or
5 kV RMS (for SOIC package) of common-mode
voltage range (or isolation), making it useful over a
very wide voltage range.
Preliminary Rev. 0.4
9
相关PDF资料
PDF描述
HBC08DREI-S13 CONN EDGECARD 16POS .100 EXTEND
DS2438Z IC MONITOR SMART BATTERY 8-SOIC
VI-JW4-EZ CONVERTER MOD DC/DC 48V 25W
EEC13DRTS-S734 CONN EDGECARD 26POS DIP .100 SLD
SI85XX-EVB BOARD EVAL CURRENT SENSOR 10A
相关代理商/技术参数
参数描述
Si85XX-EVB 功能描述:电流传感器开发工具 10A Current Sensor Eval Board RoHS:否 制造商:Texas Instruments 工具用于评估:LMP91000 接口类型:USB 工作电压:2.7 V to 5.25 V 最大工作温度:
SI8600AB-B-IS 制造商:Silicon Laboratories Inc 功能描述:2.5 KV BIDIRECTIONAL I2C ISOLATOR, 1.7MHZ, SOIC8, LEAD FREE, - Rail/Tube
SI8600AB-B-ISR 制造商:Silicon Laboratories Inc 功能描述:2.5 KV BIDIRECTIONAL I2C ISOLATOR, 1.7MHZ, SOIC8, LEAD FREE, - Tape and Reel
Si8600AC-B-IS 功能描述:隔离器接口集成电路 3.75kV Bidirect I2C Isolator 1.7MHz ADuM RoHS:否 制造商:Texas Instruments 通道数量:2 传播延迟时间: 电源电压-最大:5.5 V 电源电压-最小:3 V 电源电流:3.6 mA 功率耗散: 最大工作温度:+ 125 C 安装风格: 封装 / 箱体:SOIC-8 封装:Tube
SI8600AC-B-ISR 制造商:Silicon Laboratories Inc 功能描述:BIDIRECTIONAL I2C ISOLATORS WITH UNIDIRECTIONAL DIGITAL CHANNELS 制造商:Silicon Laboratories Inc 功能描述:3.75 KV BIDIRECTIONAL I2C ISOLATOR, 1.7MHZ, SOIC8, LEAD FREE - Tape and Reel 制造商:Silicon Laboratories Inc 功能描述:IC ISOLATOR BIDIR 3.75KV 8-SOIC 制造商:Silicon Laboratories Inc 功能描述:3.75kV Bidirect I2C ISO 1.7MHz