参数资料
| 型号： | SL15303EZC |
| 厂商： | Silicon Laboratories Inc |
| 文件页数： | 4/10页 |
| 文件大小： | 0K |
| 描述： | IC CLOCK SSCG 1PLL 8TSSOP |
| 标准包装： | 100 |
| 系列： | EProClock® |
| 类型： | * |
| PLL： | 带旁路 |
| 输入： | 时钟，晶体 |
| 输出： | 时钟 |
| 电路数： | 1 |
| 比率 - 输入:输出： | 1:3 |
| 差分 - 输入:输出： | 无/无 |
| 频率 - 最大： | 200MHz |
| 除法器/乘法器： | 是/无 |
| 电源电压： | 2.25 V ~ 3.63 V |
| 工作温度： | 0°C ~ 70°C |
| 安装类型： | * |
| 封装/外壳： | * |
| 供应商设备封装： | * |
| 包装： | * |
Rev 2.0, October 11, 2010
Page 3 of 10
SL15303
General Description
The primary source of EMI from digital circuits is the
system clock and all the other synchronous clocks and
control signals derived from the system clock. The well
know techniques of filtering (suppression) and shielding
(containment), while effective, can cost money, board
space and longer development time.
A more effective and efficient technique to reduce EMI is
Spread Spectrum Clock Generator (SSCG) technique.
Instead of using constant clock frequency, the SSCG
technique modulates (spreads) the system clock with a
much smaller frequency, to reduce EMI emissions at its
source: The System Clock.
The
SL15303
is
designed
using
SpectraLinear
proprietary programmable EProClock phase-locked
loop (PLL) and Spread Spectrum Technologies (SST) to
synthesize and modulate (spread) the system clock such
that the energy is spread out over a wider bandwidth.
This reduces the peak value of the radiated emissions at
the fundamental and the harmonics.
Power Supply Operation
The SL15303 operates from 3.3V to 2.5V+/-10% and
1.8+/-5% power supply ranges. Pins 7 driver is powered
using VDDO where VDDO
≤VDD.
The SL15303 is available in 8-pin TSSOP package with
Commercial Temperature range of 0 to 70
°C and
Industrial Temperature range of –40 to 85°C.
Input Frequency Range
The input frequency range is from 8.0 to 48.0 MHz for
crystals and ceramic resonators. If an external clock is
used, the input frequency range is from 3 to 166 MHz.
Output Frequency Range and Outputs
Up to four (3) outputs can be programmed as SSCLK,
CLKOUT or REFCLK. SSCLK or CLKOUT output can be
synthesized to any value from 3 to 200 MHz with spread
based on valid input frequency. The spread at SSCLK
pins can be stopped by SSON# input control pin, If
SSON# pin is HIGH (VDD), the frequency at this pin is
the synthesized to the nominal value of the input
frequency and there is no spread.
REFOUT is the buffered output of the oscillator and is
the same frequency as the input frequency without
spread. However, REFOUT value can also be divided by
using the output dividers from 2 to 32. The SSCLK is the
programmed and synthesized value of the input clock.
The remaining SSCLKs could be the same value
providing fanout of up to 4 or the frequency can be
divided from also 2 to 32. In this case, the spread %
value is the same as the original programmed spread %
value. By using only first order crystals, SL15300 can
synthesize output frequency up to 200 MHz, eliminating
the need for higher order Crystals (Xtals) and Crystal
Oscillators (XOs). This reduces the cost while improving
the system clock accuracy, performance and reliability.
Programmable CL (Crystal Load)
The SL15303 provides programmable on-chip capacitors
at XIN/CLKIN (Pin-3) and XOUT (Pin-2). The resolution of
this programmable capacitor is 6-bits with LSB value of
0.5pF. When all bits are off the pin capacitance is
CXIN=CXOUT =8.5pF (minimum value). When all bits are
on the pin capacitance is CXIN=CXOUT=40pF (maximum
value). The values of CXIN and CXOUT based on the CL
(Crystal Load Capacitor) can be calculated as:
CXIN=CXOUT=2CL-CPCB. Refer to the Table 5 for
additional information on crystal load (CL).
In addition, if an external clock is used, the capacitance at
Pin-3 (CLKIN) can programmed to control the edge rate of
this input clock, providing additional EMI control.
Programmable Modulation Frequency
The Spread Spectrum Clock (SSC) modulation default
value is 31.5 kHz. The higher values of up to 120 kHz can
also be programmed. Less than 30 kHz modulation
frequency is not recommended to stay out of the range
audio frequency bandwidth since this frequency could be
detected as a noise by the audio receivers within the
vicinity.
Programmable Spread Percent (%)
The spread percent (%) value is programmable from +/-
0.25% to +/-2.5% (center spread) or -0.5% to -5.0%
(down spread) for all SSCLK frequencies. It is possible to
program smaller or larger non-standard values of spread
percent. Contact SLI if these non-standard spread percent
values are required in the application.
SSON# or Frequency Select (FS)
The SL15303 Pin-4 can also be programmed as either
SSON# to enable or disable the programmed spread
percent value or as Frequency Select (FS). If SSON# is
used, when this pin is pulled high (VDD), the spread is
stopped and the frequency is the nominal value without
spread. If low (GND), the frequency is the nominal value
with the spread.
If FS function is used, the output pins can be programmed
for different set of frequencies as selected by FS. SSCLK
value can be any frequency from 3 to 200MHz, but the
spread % is the same percent value. REFOUT is the
same frequency as the input reference clock or divide by
from 2 to 32 without spread. The set of frequencies in
Table 1 is given as en example, using 48MHz crystal.
The SL15300 also allows a fan-out of up to 4, meaning
that Pins 4, 6, 7 and 8 can be programmed to the same
frequencies with or without spread.
FS
(Pin-8)
SSCLK1/2
(Pins-4/7)
REFCLK4
(Pin-6)
0
66MHz, +/-2%
48MHz
1
33MHz, +/-2%
24MHz
Table 1. Frequency Selection (FS)
Power Down (PD#) or Output Enable (OE)
The SL15300 Pin-4 can be programmed as either PD# or
OE. PD# powers down the entire chip whereas OE only
disables the output buffers to Hi-Z.
相关PDF资料 |
PDF描述 |
|---|---|
| SL15300ZC | IC CLOCK SSCG 1PLL 2CH 8TSSOP |
| VE-J1J-MZ-F2 | CONVERTER MOD DC/DC 36V 25W |
| VE-J1J-MZ-F1 | CONVERTER MOD DC/DC 36V 25W |
| SL15100ZC | IC CLOCK SSCG 1PLL 2CH 8TSSOP |
| 74LVX138SJ | DECODER/DEMUX 1-OF-8 LV 16SOP |
相关代理商/技术参数 |
参数描述 |
|---|---|
| SL15303EZCT | 功能描述:时钟发生器及支持产品 1PLL EEPROM Programmable RoHS:否 制造商:Silicon Labs 类型:Clock Generators 最大输入频率:14.318 MHz 最大输出频率:166 MHz 输出端数量:16 占空比 - 最大:55 % 工作电源电压:3.3 V 工作电源电流:1 mA 最大工作温度:+ 85 C 安装风格:SMD/SMT 封装 / 箱体:QFN-56 |
| SL15303EZI | 功能描述:时钟发生器及支持产品 1PLL EEPROM Programmable RoHS:否 制造商:Silicon Labs 类型:Clock Generators 最大输入频率:14.318 MHz 最大输出频率:166 MHz 输出端数量:16 占空比 - 最大:55 % 工作电源电压:3.3 V 工作电源电流:1 mA 最大工作温度:+ 85 C 安装风格:SMD/SMT 封装 / 箱体:QFN-56 |
| SL15303EZIT | 功能描述:时钟发生器及支持产品 1PLL EEPROM Programmable RoHS:否 制造商:Silicon Labs 类型:Clock Generators 最大输入频率:14.318 MHz 最大输出频率:166 MHz 输出端数量:16 占空比 - 最大:55 % 工作电源电压:3.3 V 工作电源电流:1 mA 最大工作温度:+ 85 C 安装风格:SMD/SMT 封装 / 箱体:QFN-56 |
| SL15316 | 制造商:SPECTRALINEAR 制造商全称:SPECTRALINEAR 功能描述:Programmable Spread Spectrum Clock Generator (SSCG) |
| SL15316ZC-XXX | 制造商:SPECTRALINEAR 制造商全称:SPECTRALINEAR 功能描述:Programmable Spread Spectrum Clock Generator (SSCG) |
发布紧急采购，3分钟左右您将得到回复。