- 您现在的位置：买卖IC网 > PDF目录378694 > SL2017 (Mitel Networks Corporation) Full Band Satellite Tuner PDF资料下载
参数资料
| 型号： | SL2017 |
| 厂商： | Mitel Networks Corporation |
| 英文描述： | Full Band Satellite Tuner |
| 中文描述： | 全波段卫星调谐器 |
| 文件页数： | 10/17页 |
| 文件大小： | 190K |
| 代理商： | SL2017 |
10
SL2017
e) The difference in level in dB between the fundamentals and
the 3rd order products is the IM3 of the device.
f) IP3 may be calculated from the above reading as follows:
IP3 = RF input level + IM3/2.
This level is usually referred to the input.
e.g.
Assuming a measured IM3 of 44dB, and with an input level of
-19dBm,
IP3 = 44/2 + -19dBm = +3dBm
In a 50
system, this may be converted to dBuV by adding 107
to the value calculated since 0dBm = 107dB
μ
V.
i.e. +3dBm = 110dBuV.
This is known as the input referred IP3 of the device.
If you experience any difficulties with this board, or require
further help, please contact Robert Marsh on 01793 518234
or Fred Herman on 01793 518423. The fax number is 01793
518411.
The in-band ones are listed below:
fd = flo - (2 x f1 - f2)
fc = flo - (2 x f2 - f1)
fd = 1430MHz - (2 x 950MHz - 951MHz) = 481MHz
fc = 1430MHz - (2 x 951MHz - 950MHz) = 478MHz
fa
fb
fc
fd
fundamentals
3rd order product
3rd order product
Measurement of IM3 and IP3
a) Input two signal tones from RF generators. The level of
these should be adjusted so that the device sees an input
signal level of -19dBm from each tone.
Program the local oscillator so that both tones are mixed down
to the IF (approx).
b) Adjust the AGC so that the device gives an overall
conversion gain of +5dB.
c) Connect a spectrum analyser to the selected IF output of
the device.
d) Measure the relative levels of the down converter signals
and the 3rd order products (see diag overleaf).
Two input signals are used:
f1 = 950MHz
f2 = 951MHz
The local oscillator flo is tuned to 1430MHz.
This gives the following at the IF output:
fa = 1430MHz - 950MHz = 480MHz
fb = 1430MHz - 951MHz = 479MHz
Mixing products are also produced in the front end. These
are then downconverted by the mixer.
相关PDF资料 |
PDF描述 |
|---|---|
| SL2030 | High Performance Broadband Mixer Oscillator |
| SL2035 | High Performance Broadband Downconverter |
| SL22-T1 | 2.0A LOW VF SURFACE MOUNT SCHOTTKY BARRIER RECTIFIER |
| SL23-T1 | 2.0A LOW VF SURFACE MOUNT SCHOTTKY BARRIER RECTIFIER |
| SL22-T3 | 2.0A LOW VF SURFACE MOUNT SCHOTTKY BARRIER RECTIFIER |
相关代理商/技术参数 |
参数描述 |
|---|---|
| SL201A101FABTR1 | 功能描述:多层陶瓷电容器MLCC - 含引线 100volts100pF C0G RoHS:否 制造商:AVX 电容:470 pF 容差:10 % 电压额定值:3 kV 端接类型:Radial 工作温度范围: 温度系数/代码:X7R 引线间隔:5.08 mm 产品:Automotive MLCCs 引线类型: |
| SL201A102FAB | 制造商:AVX Corporation 功能描述:BULK / SKYCAP / SKYCAPS |
| SL201A102JAB | 功能描述:多层陶瓷电容器MLCC - 含引线 100volts 1000pF 5% C0G RoHS:否 制造商:AVX 电容:470 pF 容差:10 % 电压额定值:3 kV 端接类型:Radial 工作温度范围: 温度系数/代码:X7R 引线间隔:5.08 mm 产品:Automotive MLCCs 引线类型: |
| SL201A102JABTR1 | 功能描述:多层陶瓷电容器MLCC - 含引线 100volts 1000pF 5% C0G RoHS:否 制造商:AVX 电容:470 pF 容差:10 % 电压额定值:3 kV 端接类型:Radial 工作温度范围: 温度系数/代码:X7R 引线间隔:5.08 mm 产品:Automotive MLCCs 引线类型: |
| SL201A122JAB | 功能描述:多层陶瓷电容器MLCC - 含引线 100volts 1200pF 5% C0G RoHS:否 制造商:AVX 电容:470 pF 容差:10 % 电压额定值:3 kV 端接类型:Radial 工作温度范围: 温度系数/代码:X7R 引线间隔:5.08 mm 产品:Automotive MLCCs 引线类型: |
发布紧急采购，3分钟左右您将得到回复。