- 您现在的位置：买卖IC网 > PDF目录10216 > SP211EET-L/TR (Exar Corporation)IC TXRX RS232 ESD LP 28WSOIC PDF资料下载
参数资料
| 型号： | SP211EET-L/TR |
| 厂商： | Exar Corporation |
| 文件页数： | 17/19页 |
| 文件大小： | 0K |
| 描述： | IC TXRX RS232 ESD LP 28WSOIC |
| 标准包装： | 1,500 |
| 类型： | 收发器 |
| 驱动器/接收器数： | 4/5 |
| 规程： | RS232 |
| 电源电压： | 4.5 V ~ 5.5 V |
| 安装类型： | 表面贴装 |
| 封装/外壳： | 28-SOIC（0.295"，7.50mm 宽） |
| 供应商设备封装： | 28-SOIC W |
| 包装： | 带卷 (TR) |
7
Exar Corporation 48720 Kato Road, Fremont CA, 94538 50-668-707 www.exar.com
SP207E_0_052
The Exar charge-pump generates V+ and V-
independently from V
CC. Hence in a no–load
condition V+ and V- will be symmetrical.
Older charge pump approaches generate
V+ and then use part of that stored charge
to generate V-. Because of inherent losses,
the magnitude of V- will be smaller than V+
on these older designs.
Underlightlyloadedconditionstheintelligent
pump oscillator maximizes efficiency by
running only as needed to maintain V+ and
V-. Since interface transceivers often spend
muchoftheirtimeatidle,thispower-efficient
innovation can greatly reduce total power
consumption. This improvement is made
possiblebytheindependentphasesequence
of the Exar charge-pump design.
The clock rate for the charge pump typically
operates at greater than 15kHz, allowing
thepumptorunefficientlywithsmall0.1F
capacitors.Efficientoperationdependson
rapidly charging and discharging C
and
C
2, therefore capacitors should be mounted
closetotheICandhavelowESR(equivalent
seriesresistance).Lowcostsurfacemount
ceramiccapacitors(suchasarewidelyused
forpower-supplydecoupling)areidealfor
use on the charge pump.
However the charge pumps are designed
to be able to function properly with a wide
range of capacitor styles and values. If
polarizedcapacitorsareused,thepositive
and negative terminals should be connected
as shown.
Figure 4. Charge Pump — Phase 4
VCC = +5V
+10V
VSS Storage Capacitor
VDD Storage Capacitor
C1
C2
C3
C4
+
–
+7V
Voltage potential across any of the capaci-
tors will never exceed 2 x V
CC. Therefore
capacitors with working v
oltages as low as
0V rating may be used with a nominal V
CC
supply. C
will never see a potential greater
than V
CC , so a working voltage of 6.3V is
adequate. The reference terminal of the
V
DD capacitor may be connected either to
V
CC or ground, but if connected to ground a
minimum 6V working voltage is required.
Higherworkingvoltagesand/orcapacitance
values may be advised if operating at higher
V
CC or to provide greater stability as the
capacitors age.
+7V
a) C
2
+
gND
b) C
2
–
–7V
Figure 5. Typical waveforms seen on ca-
pacitor C2 when all drivers are at maximum
load.
相关PDF资料 |
PDF描述 |
|---|---|
| VE-BNY-IU-S | CONVERTER MOD DC/DC 3.3V 132W |
| VE-BNW-IV-S | CONVERTER MOD DC/DC 5.5V 150W |
| VI-B2H-MW-F3 | CONVERTER MOD DC/DC 52V 100W |
| VI-B2H-MW-F2 | CONVERTER MOD DC/DC 52V 100W |
| VE-214-IU-F1 | CONVERTER MOD DC/DC 48V 200W |
相关代理商/技术参数 |
参数描述 |
|---|---|
| SP211EH | 制造商:SIPEX 制造商全称:Sipex Corporation 功能描述:High Speed +5V High Performance RS232 Transceivers |
| SP211EHCA | 制造商:Rochester Electronics LLC 功能描述: 制造商:Exar Corporation 功能描述: |
| SP211EHCA-L | 功能描述:RS-232接口集成电路 460KBPS 5V 4DRV/5RCV RS-232 0-70C RoHS:否 制造商:Exar 数据速率:52 Mbps 工作电源电压:5 V 电源电流:300 mA 工作温度范围:- 40 C to + 85 C 安装风格:SMD/SMT 封装 / 箱体:LQFP-100 封装: |
| SP211EHCA-L/TR | 功能描述:RS-232接口集成电路 460KBPS 5V 4DRV/5RCV RS-232 0-70C RoHS:否 制造商:Exar 数据速率:52 Mbps 工作电源电压:5 V 电源电流:300 mA 工作温度范围:- 40 C to + 85 C 安装风格:SMD/SMT 封装 / 箱体:LQFP-100 封装: |
| SP211EHCT | 制造商:SIPEX 制造商全称:Sipex Corporation 功能描述:High Speed +5V High Performance RS232 Transceivers |
发布紧急采购，3分钟左右您将得到回复。