- 您现在的位置：买卖IC网 > PDF目录372174 > SP320ACF 5V High-Speed RS-232 Transceivers with 0.1uF Capacitors PDF资料下载
参数资料
| 型号： | SP320ACF |
| 元件分类： | RS-232 |
| 英文描述： | 5V High-Speed RS-232 Transceivers with 0.1uF Capacitors |
| 中文描述： | 5V的高速RS - 232收发器与0.1uF电容 |
| 文件页数： | 5/12页 |
| 文件大小： | 647K |
| 代理商： | SP320ACF |
5
Rev:A Date: 1/27/04 SP320 Complete +5V-Only V.35 Interface with RS-232 (V.28) Control Lines Copyright 2004 Sipex Corporation
Phase 4
-Vdd transfer- The fourth phase of the clock
connects the negative terminal of C2 to ground
and transfers the generated +10V across C2 to
C4, the Vdd storage capacitor. Again, simulta-
neously with this, the positive side of capacitor
C1 is switched to +5V and the negative side is
connected to ground, and the cycle begins again.
Since both V+ and V- are separately generated
from Vcc in a no load condition, V+and V- will
be symmetrical. Older charge pump approaches
that generate V- from V+ will show a decrease
in the magnitude of V- compared to V+ due to
the inherent inefficiencies in the design.
The clock rate for the charge pump typically
operates at 15kHz. The external capacitors must
be 0.1
μ
F with a 16V breakdown rating.
Shutdown Mode
The
SP320
can be put into a low power
shutdown mode by bringing both TS000 (pin 3)
and ENV35 (pin 9) low. In shutdown mode, the
SP320
will draw less than 2mA of supply
current. For normal operation, both pins should
be connected to +5V.
External Power Supplies
For applications that do not require +5V only,
external supplies can be applied at the V+ and
V- pins. The value of the external supply
voltages must be no greater than
±
10V. The
current drain from the
±
10V supplies is used for
the RS-232 drivers. For the RS-232 driver the
current requirement will be 3.5mA per driver.
It is critical the external power supplies provide
a power supply sequence of : +10V, +5V, and
then -10V.
Applications Information
The
SP320
is a single chip device that can
implement a complete V.35 interface. Three (3)
V.35 drivers and three (3) V.35 receivers are
used for clock and data signals and four (4)
RS-232 (V.28) drivers and four (4) RS-232
(V.28) receivers can be used for the control
signals of the interface. The following examples
show the
SP320
configured in either a DTE or
DCE application.
+10V
a) C
2
+
GND
GND
b) C
2
–
–10V
Figure 1. Charge Pump Waveforms
Figure 1a
shows the waveform found on the
positive side of capacitor C2, and
Figure 1b
shows the negative side of capacitor C2. There
is a free-running oscillator that controls the four
phases of the voltage shifting. A description of
each phase follows.
Phase 1
-Vss charge storage- During this phase of the
clock cycle, the positive side of capactors C1
and C2 are initially charged to +5V. C1+ is then
switched to ground and the charge in C1- is
transferred to C2-. Since C2+ is connected to
+5V, the voltage potential across capacitor C2 is
now 10V.
Phase 2
-Vss transfer- Phase two of the clock connects
the negative terminal of C2 to the Vss storage
capacitor and the positive terminal of C2 to
ground, and transfers the generated -10V to C3.
Simultaneously, the positive side of capacitor
C1 is switched to +5V and the negative side is
connected to ground.
Phase 3
-Vdd charge storage- The third phase of the
clock is identical to the first phase- the trans-
ferred charge in C1 produces -5V in the negative
terminal of C1, which is applied to the negative
side of capacitor C2. Since C2+ is at +5V, the
voltage potential across C2 is +10V.
相关PDF资料 |
PDF描述 |
|---|---|
| SP3220B | Low Power 5V RS232 Dual Driver/Receiver with 0.1?μF Capacitors; Package: SO; No of Pins: 16; Temperature Range: -40?°C to 85?°C |
| SP3220UCA | 320 x 240 pixel format, LED or CFL Backlight |
| SP3220UEA | 320 x 240 pixel format, 5.7in. Display |
| SP3220UET | 320 x 240 pixel format, Chip-On-Glass Technology |
| SP3220UEY | 320 x 240 pixel format, Chip-On-Glass Technology |
相关代理商/技术参数 |
参数描述 |
|---|---|
| SP320ACF-L | 制造商:Exar 功能描述:Transceiver V.35 with RS-232 5V LQFP80 |
| SP320ACM-L | 功能描述:RS-232接口集成电路 COMPLETE V.35 SERIAL PORT TRANCEIVER RoHS:否 制造商:Exar 数据速率:52 Mbps 工作电源电压:5 V 电源电流:300 mA 工作温度范围:- 40 C to + 85 C 安装风格:SMD/SMT 封装 / 箱体:LQFP-100 封装: |
| SP3-2-10 | 制造商:RHOMBUS-IND 制造商全称:Rhombus Industries Inc. 功能描述:SP3 Series Mini-SIP Passive Delay Modules |
| SP-3215 | 功能描述:SPEAKER 83 DB SENSITIVITY 31.7 D 制造商:soberton inc. 系列:SP 微型扬声器 包装:托盘 零件状态:在售 技术:磁性 类型:通用 频率范围:1.2kHz ~ 20kHz 频率 - 自谐振:1200Hz 阻抗:8 Ohms 效率 - dBA:83 效率 -?测试:100mm 效率 -?类型:声压级?(SPL) 功率 - 额定值:200mW 功率 - 最大值:300mW 端口位置:顶部 形状:圆形 材料 - 锥体:聚酯，聚对苯二甲酸乙二醇酯（PET） 材料 - 磁铁:铁氧体 侵入防护:- 等级:- 端接:PC 引脚 大小/尺寸:1.248" 直径（31.70mm） 高度 - 安装（最大值）:0.591"（15.00mm） 标准包装:136 |
| SP-3216-FF-2.5A | 制造商:Cooper Bussmann 功能描述: |
发布紧急采购，3分钟左右您将得到回复。