- 您现在的位置：买卖IC网 > PDF目录10225 > SP3220EBCY-L/TR (Exar Corporation)IC DVR/RCVR RS232 ESD 16TSSOP PDF资料下载
参数资料
| 型号： | SP3220EBCY-L/TR |
| 厂商： | Exar Corporation |
| 文件页数： | 4/21页 |
| 文件大小： | 0K |
| 描述： | IC DVR/RCVR RS232 ESD 16TSSOP |
| 标准包装： | 2,500 |
| 类型： | 收发器 |
| 驱动器/接收器数： | 1/1 |
| 规程： | RS232 |
| 电源电压： | 3 V ~ 5.5 V |
| 安装类型： | 表面贴装 |
| 封装/外壳： | 16-TSSOP（0.173"，4.40mm 宽） |
| 供应商设备封装： | 16-TSSOP |
| 包装： | 带卷 (TR) |
12
Exar Corporation 48720 Kato Road, Fremont CA, 94538 510-668-7017 www.exar.com
SP3220E_EB_EU_101_060311
DESCRIPTION
Charge Pump Design Guidelines
The charge pump operates with 0.1F ca-
pacitors for 3.3V operation. For other supply
voltages, see the table for required capacitor
values. Do not use values smaller than those
listed. Increasing the capacitor values (e.g.,
by doubling in value) reduces ripple on the
transmitter outputs and may slightly reduce
power consumption. C2, C3, and C4 may be
increased without changing C1’s value.
Minimum recommended charge pump
capacitor value
Input Voltage
Vcc
Charge pump
capacitor value for
SP3220E/EB/EU
3.0V to 3.6V
C1 - C4 = 0.1F
3.0V to 5.5V
C1 - C4 = 0.22F
Thechargepumposcillatortypicallyoperates
at greater than 250kHz allowing the pump to
run efficiently with small 0.1μF capacitors.
Efficientoperationdependsonrapidlycharg-
ing and discharging C1 and C2, therefore
capacitors should be mounted close to the
IC and have low ESR (equivalent series
resistance).
Low cost surface mount ceramic capacitors
(such as are widely used for power-supply
decoupling) are ideal for use on the charge
pump. However the charge pumps are de-
signed to be able to function properly with a
wide range of capacitor styles and values.
If polarized capacitors are used the positive
and negative terminals should be connected
as shown in the Typical Operating Circuit.
Voltage potential across any of the capaci-
tors will never exceed 2 x VCC. Therefore
capacitors with working voltages as low as
6.3V rating may be used with a 3.0V VCC
supply. The reference terminal of the V+
capacitor may be connected either to VCC
or ground, but if connected to ground a
minimum 10V working voltage is required.
Higher working voltages and/or capacitance
values may be advised if operating at higher
VCC or to provide greater stability as the
capacitors age.
Underlightlyloadedconditionstheintelligent
pump oscillator maximizes efficiency by
running only as needed to maintain V+ and
V-. Since interface transceivers often spend
much of their time at idle this power-efficient
innovation can greatly reduce total power
consumption. This improvement is made
possiblebytheindependentphasesequence
of the Exar charge-pump design.
相关PDF资料 |
PDF描述 |
|---|---|
| LTC1407AHMSE#TRPBF | IC ADC 14BIT 3MSPS 10-MSOP |
| AD7866ARU | IC ADC 12BIT 2CH DUAL 20-TSSOP |
| SP26LV432CN-L/TR | IC RCVR RS422 QUAD DIFF 16NSOIC |
| LTC2232IUK#TR | IC ADC 10BIT 105MSPS SAMPL 48QFN |
| LTC1276BCN#PBF | IC A/D CONV 12BIT SAMPLING 24DIP |
相关代理商/技术参数 |
参数描述 |
|---|---|
| SP3220EBEA | 制造商:Rochester Electronics LLC 功能描述: 制造商:Exar Corporation 功能描述: |
| SP3220EBEA-L | 功能描述:RS-232接口集成电路 3V-5.5V RS-232 1-DRV/1-RCV LOW PWR RoHS:否 制造商:Exar 数据速率:52 Mbps 工作电源电压:5 V 电源电流:300 mA 工作温度范围:- 40 C to + 85 C 安装风格:SMD/SMT 封装 / 箱体:LQFP-100 封装: |
| SP3220EBEA-L/TR | 功能描述:RS-232接口集成电路 3V-5.5V RS-232 1-DRV/1-RCV LOW PWR RoHS:否 制造商:Exar 数据速率:52 Mbps 工作电源电压:5 V 电源电流:300 mA 工作温度范围:- 40 C to + 85 C 安装风格:SMD/SMT 封装 / 箱体:LQFP-100 封装: |
| SP3220EBEA-LTR | 制造商:EXAR 制造商全称:EXAR 功能描述:3.0V to 5.5V RS-232 Driver/Receiver Pair |
| SP3220EBET | 制造商:SIPEX 制造商全称:Sipex Corporation 功能描述:High Speed +3.0V to +5.5V RS-232 Driver/Receiver Pair |
发布紧急采购，3分钟左右您将得到回复。