参数资料
| 型号： | SP6121CN-L |
| 厂商： | Exar Corporation |
| 文件页数： | 7/16页 |
| 文件大小： | 0K |
| 描述： | IC REG CTRLR BUCK PWM VM 8NSOIC |
| 标准包装： | 98 |
| PWM 型： | 电压模式 |
| 输出数： | 1 |
| 频率 - 最大： | 560kHz |
| 占空比： | 100% |
| 电源电压： | 3 V ~ 5.5 V |
| 降压： | 是 |
| 升压： | 无 |
| 回扫： | 无 |
| 反相： | 无 |
| 倍增器： | 无 |
| 除法器： | 无 |
| Cuk： | 无 |
| 隔离： | 无 |
| 工作温度： | 0°C ~ 70°C |
| 封装/外壳： | 8-SOIC（0.154"，3.90mm 宽） |
| 包装： | 管件 |
THEORY OF OPERATION
Over Current Protection
Over current protection on the SP6121 is imple-
mented through detection of an excess voltage
condition across the high side PMOS switch
during conduction. This is typically referred to
as high side R DS(ON) detection and eliminates the
need of an external sense resistor. The over
current comparator charges an internal sam-
pling capacitor each time V (ISET) - V (ISENSE)
exceeds the 160mV (typ) internal threshold and
the PDRV voltage is low. The discharge/charge
current ratio on the sampling capacitor is about
2%. Therefore, provided that the over current
condition persists, the capacitor voltage will be
pumped up during each time PDRV switches
low. This voltage will trigger an over current
condition upon reaching a CMOS inverter thresh-
old. There are many advantages to this ap-
proach. First, the filtering action of the gated S/
H scheme protects against false and undesirable
triggering that could occur during a minor tran-
Output Drivers
The SP6121, unlike some other bipolar control-
ler IC’s, incorporates gate drivers with rail-to-
rail swing that help prevent spurious turn on due
to capacitive coupling. The driver stage consists
of one high side PMOS, 4 ? driver, PDRV, and
one low side, 4 ? , NFET driver, NDRV, opti-
mized for driving external power MOSFET’s in
a synchronous buck topology. The output driv-
ers also provide gate drive non-overlap mecha-
nism that provides a dead time between PDRV
and NDRV transitions to avoid potential shoot-
through problems in the external MOSFET’s.
Figure 3 shows typical waveforms for the output
drivers. As with all synchronous designs, care
must be taken to ensure that the MOSFETs are
properly chosen for non-overlap time, enhance-
ment gate drive voltage, “on” resistance R DS(ON) ,
reverse transfer capacitance Crss, input voltage
and maximum output current.
Vcc-2 V
sient overload condition or supply line noise.
Furthermore, the total amount of time to trigger
the fault depends on the on-time of the PMOS
5V
GATE DRIVER TEST CONDITIONS
90 %
switch. Ten, 1 μ s pulses are equivalent to twenty,
PDRV(NDRV)
FALL TIME
NON-OVERLAP
500ns pulses or one, 10 μ s pulse, however, de-
pending on the period, each scenario takes a
different amount of total time to trigger a fault.
Therefore, the fault becomes an indicator of
5V
10 %
RISE TIME
90 %
average power in the PMOS switch.
Although the 160 mV internal threshold is fixed,
the overall R DS(ON) detection voltage can be
increased by placing a resistor from I SET to the
source of the PMOS. A 30 μ A sink current pro-
grams the additional voltage.
In order for the current limit circuit to operate
properly and accurately, the I SET and I SENSE pins
must be Kelvin connected to the high side
PMOS’s source and drain pins.
The 160mV threshold and 30 μ A I SET current
have 3300 ppm/ ° C temperature coefficients in
an effort to first order match the thermal charac-
teristics of the R DS(ON) of the PMOS switch. It
assumed that the SP6121 will be used in com-
pact designs where there is a high amount of
thermal coupling between the PMOS and the
controller.
NDRV(PDRV)
V(V CC )
PDRV
Voltage
0V
V(V CC )
NDRV
Voltage
0V
V(V CC =V IN )
SWN
Voltage
~0V
- V(Diode) V
TIME
2V
10 %
Figure 3. SP6121 Output Driver Waveforms.
Date: 11/29/04
SP6121 Low Voltage, Synchronous Step Down PWM Controller
7
? Copyright 2004 Sipex Corporation
相关PDF资料 |
PDF描述 |
|---|---|
| SP6123CN-L | IC REG CTRLR BUCK PWM VM 8NSOIC |
| SP6125EK1-L/TR | IC REG CTRLR BUCK PWM VM 6TSOT |
| SP6126EK1-L | IC REG CTRLR BUCK PWM VM 6TSOT |
| SP6127EK1-L/TR | IC REG CTRLR BUCK PWM VM 6TSOT |
| SP6128ASEY-L | IC REG CTRLR BUCK PWM VM 14TSSOP |
相关代理商/技术参数 |
参数描述 |
|---|---|
| SP6121CN-L/TR | 功能描述:电压模式 PWM 控制器 Low Voltage, 8 Pin Synchronous, Cntrllr RoHS:否 制造商:Texas Instruments 输出端数量:1 拓扑结构:Buck 输出电压:34 V 输出电流: 开关频率: 工作电源电压:4.5 V to 5.5 V 电源电流:600 uA 最大工作温度:+ 125 C 最小工作温度:- 40 C 封装 / 箱体:WSON-8 封装:Reel |
| SP6121EB | 功能描述:电压模式 PWM 控制器 Low Voltage, 8 Pin Sync Buck Controller RoHS:否 制造商:Texas Instruments 输出端数量:1 拓扑结构:Buck 输出电压:34 V 输出电流: 开关频率: 工作电源电压:4.5 V to 5.5 V 电源电流:600 uA 最大工作温度:+ 125 C 最小工作温度:- 40 C 封装 / 箱体:WSON-8 封装:Reel |
| SP6122 | 制造商:SIPEX 制造商全称:Sipex Corporation 功能描述:Low Voltage, Micro 8, PFET, Buck Controller Ideal for 1A to 5A, Small Footprint, DC-DC Power Converters |
| SP6122_04 | 制造商:SIPEX 制造商全称:Sipex Corporation 功能描述:Low Voltage, Micro 8, PFET, Buck Controller Ideal for 1A to 5A, Small Footprint, DC-DC Power Converters |
| SP6122ACU | 制造商:Rochester Electronics LLC 功能描述: 制造商:Exar Corporation 功能描述: |
发布紧急采购，3分钟左右您将得到回复。