参数资料
| 型号： | SP6136ER1-L/TR |
| 厂商： | Exar Corporation |
| 文件页数： | 7/18页 |
| 文件大小： | 0K |
| 描述： | IC REG CTRLR BUCK PWM VM 16-QFN |
| 标准包装： | 3,000 |
| PWM 型： | 电压模式 |
| 输出数： | 1 |
| 频率 - 最大： | 680kHz |
| 占空比： | 92% |
| 电源电压： | 5 V ~ 24 V |
| 降压： | 是 |
| 升压： | 无 |
| 回扫： | 无 |
| 反相： | 无 |
| 倍增器： | 无 |
| 除法器： | 无 |
| Cuk： | 无 |
| 隔离： | 无 |
| 工作温度： | -40°C ~ 85°C |
| 封装/外壳： | 16-VFQFN 裸露焊盘 |
| 包装： | 带卷 (TR) |
THEORY OF OPERATION
MHz) and enough gain (60 dB) to run Type III
compensation schemes with adequate gain
and phase margins at crossover frequencies
greater than 200 kHz.
The common mode output of the error ampli-
fier (COMP) is 0.9V to 2.2V. Therefore, the
PWM voltage ramp has been set between
.0V and 2.0V to ensure proper 0% to 00%
duty cycle capability. The voltage loop also
includes two other very important features.
One is a non-synchronous start up mode.
Basically, the GL driver cannot turn on unless
the GH driver has attempted to turn on or
the SS pin has exceeded .7V. This feature
prevents the controller from “dragging down”
the output voltage during startup or in fault
modes. The second feature is a 00% duty
cycle timeout that ensures synchronized
refreshing of the BST capacitor at very high
duty ratios. In the event that the GH driver is
on for 20 continuous clock cycles, a reset is
given to the PWM flip flop half way through
the 20th cycle. This forces GL to rise for the
remainder of the cycle, in turn refreshing the
BST capacitor.
included to prevent the IC from malfunction-
ing at extreme temperatures.
Over-Current Protection
Over-current is detected by monitoring a
differential voltage across the output in-
ductor as shown in figure 1. Inputs to an
over-current detection comparator, set to
trigger at 60 mV nominal, are connected to
the inductor as shown.
Since the average voltage sensed by the
comparator is equal to the product of in -
ductor current and inductor DC resistance
(DCR) then I MAX = 60mV / DCR. Solving
this equation for the specific inductor in cir -
cuit , I MAX = 4.6A. When I MAX is reached,
a 220 ms time-out is initiated, during which
top and bottom drivers are turned off. Fol-
lowing the time-out, a restart is attempted.
If the fault condition persists, then the time-
out is repeated (referred to as hiccup).
SP613X
Gate Drivers
The SP6 36 contains a pair of powerful 2 W
Pull-up and .5 W Pull-down drivers. These
SWN
L = 2.7uH, DCR = 4. mOhm
RS
RS2
5. 11K
5. K
Vout
state-of-the-art drivers are designed to drive
an external NFET capable of handling up to
ISP
30A. Rise, fall, and non-overlap times have
all been minimized to achieve maximum
efficiency. All drive pins GH, GL, & SWN
ISN
CSP
6.8nF
CS
0. uF
are monitored continuously to ensure that
only one external NFET is ever on at any
given time.
Thermal & Short-Circuit Protection
Because the SP6 36 is designed to drive
large NFETs running at high current, there is
a chance that either the controller or power
converter will become too hot. Therefore, an
internal thermal shutdown (145°C) has been
Figure 1: Over-current detection circuit
Oct 3 -06 Rev L
SP6 36 Synchronous Buck Controller
7
? 2006 Sipex Corporation
相关PDF资料 |
PDF描述 |
|---|---|
| SP6137EU-L | IC REG CTRLR BUCK PWM VM 10-MSOP |
| SP6201EM5-G-3-3 | IC REG LDO 3.3V .2A SOT23-5 |
| SP6203EM5-L | IC REG LDO ADJ .3A SOT23-5 |
| SP6214EC5-L-3-3 | IC REG LDO 3.3V .1A SC70-5 |
| SP6260BEK-L/TR | IC REG LDO 1.8V .2A SOT23-5 |
相关代理商/技术参数 |
参数描述 |
|---|---|
| SP6137 | 制造商:SIPEX 制造商全称:Sipex Corporation 功能描述:Wide Input, 900KHz Synchronous PWM Controller |
| SP6137CU | 制造商:Exar Corporation 功能描述:SMPS Controller |
| SP6137CU/TR | 制造商:Exar Corporation 功能描述:SMPS Controller |
| SP6137CU-L | 功能描述:开关变换器、稳压器与控制器 Wide Input, 900KHz Synchronous RoHS:否 制造商:Texas Instruments 输出电压:1.2 V to 10 V 输出电流:300 mA 输出功率: 输入电压:3 V to 17 V 开关频率:1 MHz 工作温度范围: 安装风格:SMD/SMT 封装 / 箱体:WSON-8 封装:Reel |
| SP6137CU-L/TR | 功能描述:开关变换器、稳压器与控制器 Wide Input, 900KHz Synchronous RoHS:否 制造商:Texas Instruments 输出电压:1.2 V to 10 V 输出电流:300 mA 输出功率: 输入电压:3 V to 17 V 开关频率:1 MHz 工作温度范围: 安装风格:SMD/SMT 封装 / 箱体:WSON-8 封装:Reel |
发布紧急采购，3分钟左右您将得到回复。