参数资料
| 型号： | SP6205ER-L-2-5/TR |
| 厂商： | Exar Corporation |
| 文件页数： | 11/14页 |
| 文件大小： | 0K |
| 描述： | IC REG LDO 2.5V .5A 8DFN |
| 标准包装： | 3,000 |
| 稳压器拓扑结构： | 正，固定式 |
| 输出电压： | 2.5V |
| 输入电压： | 2.7 V ~ 5.5 V |
| 稳压器数量： | 1 |
| 电流 - 输出： | 500mA |
| 电流 - 限制（最小）： | 550mA |
| 工作温度： | -40°C ~ 125°C |
| 安装类型： | 表面贴装 |
| 封装/外壳： | 8-VFDFN 裸露焊盘 |
| 供应商设备封装： | 8-DFN（3x2） |
| 包装： | 带卷 (TR) |
S P 6 2 0 3 / S P 6 2 0 5
3 0 0 m A / 5 0 0 m A L o w N o i s e C M O S L D O R e g u l a t o r s
After calculation, we find that in such an
application (SP6205) the regulator is limited to
260.6mA. Doing the same calculations for the
300mA LDO (SP6203) will limit the regulator’s
output current to 260.9mA.
Also, taking advantage of the very low dropout
voltage characteristics of the SP6203/6205,
power dissipation can be reduced by using the
lowest possible input voltage to minimize the
input-to-output drop.
A DJUSTABLE R EGULATOR A PPLICATIONS
The SP6203/6205 can be adjusted to a specific
output voltage by using two external resistors
(see functional diagram). The resistors set the
output voltage based on the following
equation:
V OUT = V REF *(R1/R2 + 1)
Resistor values are not critical because ADJ
(adjust) has a high input impedance, but for
best performance use resistors of 470K ? or
less. A bypass capacitor from ADJ to V OUT
provides improved noise performance.
D UAL -S UPPLY O PERATION
When used in dual supply systems where the
regulator load is returned to a negative
supply, the output voltage must be diode
clamped to ground.
L AYOUT C ONSIDERATIONS
The primary path of heat conduction out of the
package is via the package leads. Therefore,
careful considerations have to be taken into
account:
1) Attaching the part to a larger copper
footprint will enable better heat transfer from
the device, especially on PCB’s where there
are internal ground and power planes.
2) Place the input, output and bypass
capacitors close to the device for optimal
transient response and device behavior.
3) Connect all ground connections directly to
the ground plane. In case there’s no ground
plane, connect to a common local ground point
before connecting to board ground.
Such layouts will provide a much better
thermal conductivity (lower θ JA ) for, a higher
maximum allowable power dissipation limit.
? 2012 Exar Corporation
11/14
Rev. 2.0.0
相关PDF资料 |
PDF描述 |
|---|---|
| SP6205ER-L-1-8/TR | IC REG LDO 1.8V .5A 8DFN |
| RYM30DTMT-S189 | CONN EDGECARD 60POS R/A .156 SLD |
| ACM28DSUS | CONN EDGECARD 56POS .156 DIP SLD |
| EYM36DTMD-S664 | CONN EDGECARD 72POS R/A .156 |
| GSM30DTMH-S189 | CONN EDGECARD 60POS R/A .156 SLD |
相关代理商/技术参数 |
参数描述 |
|---|---|
| SP6205ER-L-2-7 | 制造商:SIPEX 功能描述:Linear Voltage Regulator IC |
| SP6205ER-L-2-8/TR | 功能描述:低压差稳压器 - LDO Low Noise 500mA CMOS LDO Regulators RoHS:否 制造商:Texas Instruments 最大输入电压:36 V 输出电压:1.4 V to 20.5 V 回动电压（最大值）:307 mV 输出电流:1 A 负载调节:0.3 % 输出端数量: 输出类型:Fixed 最大工作温度:+ 125 C 安装风格:SMD/SMT 封装 / 箱体:VQFN-20 |
| SP6205ER-L-2-85 | 制造商:Exar Corporation 功能描述:V REG LDO 0.5A +2.85V 6205 DFN-8 |
| SP6205ER-L-2-85/TR | 功能描述:低压差稳压器 - LDO Low Noise 500mA CMOS LDO Regulators RoHS:否 制造商:Texas Instruments 最大输入电压:36 V 输出电压:1.4 V to 20.5 V 回动电压（最大值）:307 mV 输出电流:1 A 负载调节:0.3 % 输出端数量: 输出类型:Fixed 最大工作温度:+ 125 C 安装风格:SMD/SMT 封装 / 箱体:VQFN-20 |
| SP6205ER-L-3-0 | 制造商:Exar Corporation 功能描述:V REG LDO 0.5A +3.0V 6205 DFN-8 |
发布紧急采购，3分钟左右您将得到回复。