- 您现在的位置：买卖IC网 > PDF目录15629 > SP708TEN-L/TR (Exar Corporation)IC MPU SUPERVISORY CIRCUIT 8SOIC PDF资料下载
参数资料
| 型号： | SP708TEN-L/TR |
| 厂商： | Exar Corporation |
| 文件页数： | 10/16页 |
| 文件大小： | 0K |
| 描述： | IC MPU SUPERVISORY CIRCUIT 8SOIC |
| 标准包装： | 2,500 |
| 类型： | 简单复位/加电复位 |
| 监视电压数目： | 1 |
| 复位： | 高有效/低有效 |
| 复位超时： | 最小为 140 ms |
| 电压 - 阀值： | 3.08V |
| 工作温度： | -40°C ~ 85°C |
| 安装类型： | 表面贴装 |
| 封装/外壳： | 8-SOIC（0.154"，3.90mm 宽） |
| 供应商设备封装： | 8-SOICN |
| 包装： | 带卷 (TR) |
S P 7 0 6 R / S / T - S P 7 0 8 R / S / T
3 . 0 V / 3 . 3 V L o w P o w e r M i c r o p r o c e s s o r S u p e r v i s o r y
C i r c u i t s
FEATURES
The SP706R/S/T and SP708R/S/T series
provides four key functions:
1. A reset output during power-up, power-
down and brownout conditions.
2. An independent watchdog output that goes
LOW if the watchdog input has not been
toggled within 1.6 seconds.
3. A 1.25V threshold detector for power-fail
warning, low battery detection, or monitoring
a power supply other than +3.3V/+3.0V.
4. An active-LOW manual-reset that allows
RESET to be triggered by a pushbutton switch.
The SP706R/S/T devices are the same as the
SP708R/S/T devices except for the active-
HIGH RESET substitution of the watchdog
timer.
THEORY OF OPERATION
The SP706R/S/T-SP708R/S/T series is a
microprocessor (μP) supervisory circuit that
monitors the power supplied to digital circuits
such as microprocessors, microcontrollers, or
memory. The series is an ideal solution for
portable, battery-powered equipment that
requires power supply monitoring.
Implementing this series will reduce the
number of components and overall complexity.
The watchdog functions of this product family
will continuously oversee the operational
status of a system. The operational features
and benefits of the SP706R/S/T-SP708R/S/T
series are described in more detail below.
RESET O UTPUT
A microprocessor's reset input starts the μP in
a known state. The SP706R/S/T-SP708R/S/T
series asserts reset during power-up and
prevents code execution errors during power
down or brownout conditions.
On power-up, once V CC reaches 1V, RESET is a
guaranteed logic LOW of 0.4V or less. As V CC
rises, RESET stays LOW. When V CC rises above
the reset threshold, an internal timer releases
RESET after 200ms. RESET pulses LOW
whenever V CC dips below the reset threshold,
such as in a brownout condition. When a
brownout condition occurs in the middle of a
previously initiated reset pulse, the pulse
continues for at least another 140ms. On
power down, once V CC falls below the reset
threshold, RESET stays LOW and is
guaranteed to be 0.4V or less until V CC drops
below 1V.
The active-HIGH RESET output is simply the
complement of the RESET output and is
guaranteed to be valid with V CC down to 1.1V.
Some μ Ps, such as Intel's 80C51, require an
active-HIGH reset pulse.
W ATCHDOG T IMER
The SP706R/S/T-SP708R/S/T watchdog circuit
monitors the μP's activity. If the μP does not
toggle the watchdog input (WDI) within 1.6
seconds and WDI is not tri-stated, WDO goes
LOW. As long as RESET is asserted or the WDI
input is tri-stated, the watchdog timer will stay
cleared and will not count. As soon as RESET
is released and WDI is driven HIGH or LOW,
the timer will start counting. Pulses as short as
50ns can be detected.
Typically, WDO will be connected to the non-
maskable interrupt input (NMI) of a μP. When
V CC drops below the reset threshold, WDO will
go LOW whether or not the watchdog timer
had timed out. Normally this would trigger an
NMI but RESET goes LOW simultaneously and
thus overrides the NMI.
If WDI is left unconnected, WDO can be used
as a low-line output. Since floating WDI
disables the internal timer, WDO goes LOW
only when V CC falls below the reset threshold,
thus functioning as a low-line output.
Fig. 18: Watchdog Timing Waveforms
? 2010 Exar Corporation
10/16
Rev. 2.0.0
相关PDF资料 |
PDF描述 |
|---|---|
| SP708TCN-L/TR | IC MPU SUPERVISORY CIRCUIT 8SOIC |
| SP706SCN-L/TR | IC MPU SUPERVISORY CIRCUIT 8SOIC |
| V48C5E100BF | CONVERTER MOD DC/DC 5V 100W |
| SRR1260-3R5Y | INDUCTOR 3.5UH 7.5A SMD |
| MAX6441KAKRZD3+T | IC BATTERY MON DUAL SOT23-8 |
相关代理商/技术参数 |
参数描述 |
|---|---|
| SP708TEP | 制造商:SIPEX 制造商全称:Sipex Corporation 功能描述:+3.0V/+3.3V Low Power Microprocessor Supervisory Circuits |
| SP708TEU | 制造商:SIPEX 制造商全称:Sipex Corporation 功能描述:+3.0V/+3.3V Low Power Microprocessor Supervisory Circuits |
| SP710AS | 制造商:Rochester Electronics LLC 功能描述:- Bulk |
| SP7120 | 制造商:SIPEX 制造商全称:Sipex Corporation 功能描述:Evaluation Board Manual |
| SP7120_07 | 制造商:SIPEX 制造商全称:Sipex Corporation 功能描述:Evaluation Board Manual |
发布紧急采购，3分钟左右您将得到回复。