参数资料
| 型号： | SP720ABT |
| 厂商： | Littelfuse Inc |
| 文件页数： | 4/6页 |
| 文件大小： | 0K |
| 描述： | TVS ARRAY ESD 14 INPUT 16-SOIC |
| 标准包装： | 2,500 |
| 系列： | SP720 |
| 电压 - 工作： | 30V |
| 技术： | 混合技术 |
| 电路数： | 14 |
| 应用： | 通用 |
| 封装/外壳： | 16-SOIC（0.154"，3.90mm 宽） |
| 供应商设备封装： | 16-SOIC |
| 包装： | 带卷 (TR) |
TVS Diode Arrays
Electronic Protection Array for ESD and Overvoltage Protection
SP720
Peak Transient Current Capability of the SP720
The peak transient current capability rises sharply as the width of the
current pulse narrows. Destructive testing was done to fully evaluate the
SP720’s ability to withstand a wide range of transient current pulses. The
circuit used to generate current pulses is shown in Figure 5.
The overstress curve is shown in Figure 6 for a 15V supply condition. The
dual pins are capable of 10A peak current for a 10μs pulse and 4A peak
current for a 1ms pulse. The complete for single pulse peak current vs.
pulse width time ranging up to 1 second are shown in Figure 6.
VARIABLETIME DURATION
The test circuit of Figure 5 is shown with a positive pulse input. For a
+
R 1
CURRENT PULSE GENERATOR
negative pulse input, the (-) current pulse input goes to an SP720 ‘IN’
input pin and the (+) current pulse input goes to the SP720 V- pin. The
V+ to V- supply of the SP720 must be allowed to float. (i.e., It is not tied
-
V G
CURRENT
SENSE
(-)
to the ground reference of the current pulse generator.) Figure 6 shows
the point of overstress as defined by increased leakage in excess of the
data sheet published limits.
(+)
1 IN
V+ 16
The maximum peak input current capability is dependent on the V+ to V-
voltage supply level, improving as the supply voltage is reduced. Values
2 IN
3 IN
IN 15
IN 14
+
of 0, 5, 15 and 30 voltages are shown. The safe operating range of the
transient peak current should be limited to no more than 75% of the
measured overstress level for any given pulse width as shown in Figure 6.
VOLTAGE
PROBE
4 IN
5 IN
6 IN
SP720
IN 13
IN 12
IN 11
C1
-
When adjacent input pins are paralleled, the sustained peak current
7 IN
IN 10
capability is increased to nearly twice that of a single pin. For compari-
son, tests were run using dual pin combinations 1+2, 3+4, 5+6, 7+9,
10+11, 12+13 and 14+15.
R 1 ~ 10 ? TYPICAL
V G ADJ. 10V/A TYPICAL
C1 ~ 100 μ F
8 V-
IN 9
5
FIGURE 5. TYPICAL SP720 PEAK CURRENT TEST CIRCUIT
WITH A VARIABLE PULSE WIDTH INPUT
10
9
8
CAUTION: SAFE OPERATING CONDITIONS LIMIT
7
6
5
4
THE MAXIMUM PEAK CURRENT FOR A GIVEN
PULSE WIDTH TO BE NO GREATER THAN 75%
OF THE VALUES SHOWN ON EACH CURVE.
SINGLE PIN STRESS CURVES
DUAL PIN STRESS CURVE
3
2
1
0
0V
5V
30V
V+ TO V- SUPPLY
15V
15V
0.001
0.01
0.1
1
10
100
1000
PULSE WIDTH TIME (ms)
FIGURE 6. SP720 TYPICAL SINGLE PULSE PEAK CURRENT CURVES SHOWING THE MEASURED POINT OF OVER-STRESS IN
AMPERES vs PULSE TIME IN MILLISECONDS (T A = 25 o C)
w w w. l i t t e l f u s e . c o m
231
相关PDF资料 |
PDF描述 |
|---|---|
| SP721ABG | TVS ARRAY ESD 6 INPUT 8-SOIC |
| SP721ABT | TVS ARRAY ESD 6 INPUT 8-SOIC |
| SP723ABT | TVS ARRAY ESD 6 INPUT 8-SOIC |
| SP723APP | TVS ARRAY ESD 6 INPUT 8-DIP |
| SP724AHTG | TVS ARRAY ESD 4 INPUT SOT-23 |
相关代理商/技术参数 |
参数描述 |
|---|---|
| SP720ABTG | 功能描述:TVS二极管阵列 30V 1A 3pF 14 Input RoHS:否 制造商:Littelfuse 极性: 通道:4 Channels 击穿电压: 钳位电压:11.5 V 工作电压:2.5 V 峰值浪涌电流:20 A 安装风格:SMD/SMT 端接类型:SMD/SMT 系列: 最小工作温度:- 40 C 最大工作温度:+ 85 C |
| SP720ABTG | 制造商:Littelfuse 功能描述:Diode 制造商:Littelfuse 功能描述:DIODE, TVS, 3pF, SOIC-16 |
| SP720ABTG-CUT TAPE | 制造商:LITTELFUSE 功能描述:SP720 Series 3 pF Surface Mount Electronic Protection Array for ESD - SOIC-16 |
| SP720AP | 功能描述:TVS二极管阵列 SP720AP RoHS:否 制造商:Littelfuse 极性: 通道:4 Channels 击穿电压: 钳位电压:11.5 V 工作电压:2.5 V 峰值浪涌电流:20 A 安装风格:SMD/SMT 端接类型:SMD/SMT 系列: 最小工作温度:- 40 C 最大工作温度:+ 85 C |
| SP720APP | 功能描述:TVS二极管阵列 14 CH DIODE ARRAY RoHS:否 制造商:Littelfuse 极性: 通道:4 Channels 击穿电压: 钳位电压:11.5 V 工作电压:2.5 V 峰值浪涌电流:20 A 安装风格:SMD/SMT 端接类型:SMD/SMT 系列: 最小工作温度:- 40 C 最大工作温度:+ 85 C |
发布紧急采购，3分钟左右您将得到回复。