参数资料
| 型号： | SP7650ER-L/TR |
| 厂商： | Exar Corporation |
| 文件页数： | 5/16页 |
| 文件大小： | 0K |
| 描述： | IC REG BUCK SYNC ADJ 3A 26DFN |
| 标准包装： | 3,000 |
| 系列： | Power Blox™ |
| 类型： | 降压（降压） |
| 输出类型： | 可调式 |
| 输出数： | 1 |
| 输出电压： | 0.8 V ~ 27 V |
| 输入电压： | 2.5 V ~ 28 V |
| PWM 型： | 电压模式 |
| 频率 - 开关： | 300kHz |
| 电流 - 输出： | 3A |
| 同步整流器： | 是 |
| 工作温度： | -40°C ~ 85°C |
| 安装类型： | 表面贴装 |
| 封装/外壳： | 26-VFDFN 裸露焊盘 |
| 包装： | 带卷 (TR) |
| 供应商设备封装： | 26-DFN（7x4） |
| 其它名称： | SP7650ER-L/TR-ND |
THEORY OF OPERATION
features include thermal shutdown and short-
circuit detection. In the event that either a ther-
mal, short-circuit, or UVLO fault is detected,
the SP7650 is forced into an idle state where the
output drivers are held off for a finite period
before a restart is attempted.
Soft Start
“Soft Start” is achieved when a power converter
ramps up the output voltage while controlling
the magnitude of the input supply source cur-
rent. In a modern step down converter, ramping
up the positive terminal of the error amplifier
controls soft start. As a result, excess source
current can be defined as the current required to
charge the output capacitor.
I VIN = C OUT * ( V OUT / T SOFT-START )
The SP7650 provides the user with the option to
program the soft start rate by tying a capacitor
from the SS pin to GND. The selection of this
capacitor is based on the 10uA pull up current
present at the SS pin and the 0.8V reference
voltage. Therefore, the excess source can be
redefined as:
IV IN = C OUT * ( V OUT *10 μ A / (C SS * 0.8V)
Under Voltage Lock Out (UVLO)
The SP7650 contains two separate UVLO com-
parators to monitor the bias (V CC ) and conver-
sion (V IN ) voltages independently. The V CC
UVLO threshold is internally set to 4.25V,
whereas the V IN UVLO threshold is program-
mable through the UVIN pin. When the UVIN
pin is greater than 2.5V, the SP7650 is permitted
to start up pending the removal of all other
faults. Both the V CC and V IN UVLO compara-
tors have been designed with hysteresis to pre-
vent noise from resetting a fault.
Thermal and Short-Circuit
Protection
Because the SP7650 is designed to drive large
output current, there is a chance that the power
converter will become too hot. Therefore, an
internal thermal shutdown (145 ° C) has been
included to prevent the IC from malfunctioning
at extreme temperatures.
A short-circuit detection comparator has also
been included in the SP7650 to protect against
an accidental short at the output of the power
converter. This comparator constantly monitors
the positive and negative terminals of the error
amplifier, and if the V FB pin falls more than
250mV (typical) below the positive reference, a
short-circuit fault is set. Because the SS pin
overrides the internal 0.8V reference during soft
start, the SP7650 is capable of detecting short-
circuit faults throughout the duration of soft
start as well as in regular operation.
Handling of Faults:
Upon the detection of power (UVLO), thermal,
or short-circuit faults, the SP7650 is forced into
an idle state where the SS and COMP pins are
pulled low and both switches are held off. In the
event of UVLO fault, the SP7650 remains in this
idle state until the UVLO fault is removed.
Upon the detection of a thermal or short-circuit
fault, an internal 200ms timer is activated. In the
event of a short-circuit fault, a re-start is at-
tempted immediately after the 200ms timeout
expires. Whereas, when a thermal fault is de-
tected the 200ms delay continuously recycles
and a re-start cannot be attempted until the
thermal fault is removed and the timer expires.
Error Amplifier and Voltage Loop
Since the heart of the SP7650 voltage error loop
is a high performance, wide bandwidth transcon-
ductance amplifier. Because of the amplifier’s
current limited (+/-150 μ A) transconductance,
there are many ways to compensate the voltage
loop or to control the COMP pin externally. If
a simple, single pole, single zero response is
2/16/06
Date: / 5/06
WideInputInput Range3A, 3A, BuckBuck
SP7650 SP7650 Wide Voltage Voltage Range 300kHz, 300kHz, Regulator Regulator
5
? ? Copyright 2006 Sipex Corporation
相关PDF资料 |
PDF描述 |
|---|---|
| SP7651ER-L | IC REG BUCK SYNC ADJ 3A 26DFN |
| SP7652ER-L/TR | IC REG BUCK SYNC ADJ 6A 26DFN |
| SP7653ER-L | IC REG BUCK SYNC ADJ 3A 26DFN |
| SP7655ER-L/TR | IC REG BUCK SYNC ADJ 8A 26DFN |
| SP7656EN2-L/TR | IC REG BUCK ADJ 3A 8HNSOIC |
相关代理商/技术参数 |
参数描述 |
|---|---|
| SP7651 | 制造商:SIPEX 制造商全称:Sipex Corporation 功能描述:Evaluation Board Manual |
| SP7651_06 | 制造商:SIPEX 制造商全称:Sipex Corporation 功能描述:Evaluation Board Manual |
| SP7651_07 | 制造商:SIPEX 制造商全称:Sipex Corporation 功能描述:Wide Input Voltage Range 3Amp 900kHz Buck Regulator |
| SP7651EB | 功能描述:电源管理IC开发工具 Wide In Volt Range 3A 900kHz Buck Reg RoHS:否 制造商:Maxim Integrated 产品:Evaluation Kits 类型:Battery Management 工具用于评估:MAX17710GB 输入电压: 输出电压:1.8 V |
| SP7651ER | 制造商:SIPEX 制造商全称:Sipex Corporation 功能描述:Evaluation Board Manual |
发布紧急采购，3分钟左右您将得到回复。