- 您现在的位置：买卖IC网 > PDF目录97711 > SP8795/NA/DP (ZARLINK SEMICONDUCTOR INC) 8795 SERIES, PRESCALER, DIP8 PDF资料下载
参数资料
| 型号： | SP8795/NA/DP |
| 厂商： | ZARLINK SEMICONDUCTOR INC |
| 元件分类： | 谐振器 |
| 英文描述： | 8795 SERIES, PRESCALER, DIP8 |
| 封装： | DIP-8 |
| 文件页数： | 5/6页 |
| 文件大小： | 263K |
| 代理商： | SP8795/NA/DP |
SP8795
OPERATING NOTES
1. The clock input (Pin 5) should be capacitively coupled to
the signal source. The input signal path is completed by
coupling a capacitor from the internal bias decoupling, Pin 6 to
ground.
2. The output stage which is normally open collector (Pin 2
open circuit) can be interfaced to CMOS. The open collector
can be returned to a +10V line via a 5k resistor but the output
sink current should not exceed 2mA. If interfacing to TTL is
required then Pins 2 and 7 should be connected together to
give a fan-out = 1. This will increase supply current by
approximately 2mA.
3. The circuit will operate down to DC but a slew rate of better
than 20V/~s is required.
4. The mark space ratio of the output is approximately 1.2:1
at 200MHz.
5. Input impedance is a function of frequency. See Fig.5.
6. If no signal is present the device will self-oscillate. If this is
undesirable it may be prevented by connecting a 150k
between unused input and ground. This reduces the input
sensitivity by typically 50-100mV p-p.
7. The internal regulator has its input connected to Pin 8,
while the internal reference voltage appears at Pin 7 and
should be decoupled. For use from a 5.2V supply, Pins 7 and
8
should be connected together, and 5.2V applied to these
pins. For operation from supply voltages in the range +6.8V to
+9.5V, Pins 7 and 8 should be separately decoupled, and the
supply voltage applied to Pin 8.
Figure 5 : Typical impedance. Test conditions: supply voltage 5.2V, ambient temperature 25
°C, frequencies in
MHz, impedance normalised to 50 ohms.
Figure 6 : Toggle frequency test circuit
18
27
36
45
SP8795
VCC1
CONTROL
INPUT
OUTPUT
VCC OF MODULUS
CONTROL DEVICE
1n
100n
1n
50
MONITOR
50
SIGNAL
SOURCE
相关PDF资料 |
PDF描述 |
|---|---|
| SP8812B1DG | TTL/H/L SERIES, PRESCALER, CDIP8 |
| SP8902KGDG1S | ECL SERIES, PRESCALER, CDIP8 |
| SP8910/KG/MP1S | 8910 SERIES, PRESCALER, PDSO8 |
| SPLBX81-2S | 802 nm, LASER DIODE |
| SPLLL15 | SPECIALTY OPTOELECTRONIC DEVICE |
相关代理商/技术参数 |
参数描述 |
|---|---|
| SP8799 | 制造商:ZARLINK 制造商全称:Zarlink Semiconductor Inc 功能描述:225MHz 10/11 TWO MODULUS DIVIDER |
| SP87JC96C4-A WAF | 制造商:Intel 功能描述: |
| SP87JF97C4 WAF | 制造商:Intel 功能描述: |
| SP8802 | 制造商:ZARLINK 制造商全称:Zarlink Semiconductor Inc 功能描述:3.3GHZ ± 2 Fixed Modulus Divider |
| SP8802/A/DG | 制造商:ZARLINK 制造商全称:Zarlink Semiconductor Inc 功能描述:3.3GHZ ± 2 Fixed Modulus Divider |
发布紧急采购，3分钟左右您将得到回复。